Bromic BH0420002, BH0420003, BH0420004, BH0420005 Installation Guide, Instructions Manual, & Service Manual

TUNGSTEN SMART-HEAT™

ELECTRIC HEATER

BY BROMIC

INSTALLATION, INSTRUCTION AND

SERVICE MANUAL

SUITABLE FOR ELECTRIC HEATER MODELS:

TUNGSTEN 2000W, 3000W, 4000WAND TUNGSTEN 6000W

! IMPORTANT

READ THIS MANUAL CAREFULLY.

SEE INSIDE COVER FOR IMPORTANT INFORMATION ABOUT THIS MANUAL.KEEP INSTRUCTION WITH APPLIANCE FOR FUTURE REFERENCE.

Version 1.6 USA

! IMPORTANT

This manual contains important information about the installation, operation, and maintenance of Tungsten Smart-Heat™ Electric Heaters. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety information will be accompanied by the following safety alert symbols:

! DANGER, ! WARNING, IMPORTANT!

•READ THIS MANUAL CAREFULLY before installing or servicing this product.

•Improper installation, operation, or maintenance can result in death, severe injury, or property damage.

•Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons

•This appliance is intended for fixed installation with 230240Volt power supply.

•Installation MUST be carried out by a licensed and authorised technician in accordance with local electrical codes.

•For Domestic and Commercial Use

•Patent Pending & Registered Design

NOTE: IMPORTANT INSTRUCTIONS, SAVE THESE INSTRUCTIONS

BROMIC HEATING

Head Office:10 Phiney Place, Ingleburn NSW 2565 Australia

Telephone: [phone] (within Australia) or [phone] (from overseas)

Email: [e-mail] Web: www.bromicheating.com

Note: Bromic Heating reserves the right to make changes to specifications, parts, components and equipment without prior notification. This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Heating.

2	www.bromicheating.com

CONTENTS

IMPORTANT NOTES & WARNINGS	4
PRODUCT OVERVIEW	5
PRODUCT DESCRIPTION AND FEATURES	5
SPECIFICATIONS	5
HEATER INSTALLATION	6
INSTALLATION CLEARANCES	6
CEILING WALL MOUNTING	7
CHAIN SUSPENSION	7
TUBE SUSPENSION	8
CEILING RECESS	9
ELEMENT INSTALLATION	11
ELECTRICAL INSTALLATION	13
WIRING DIAGRAMS	14
SERVICING	15
MAINTENANCE	15
TUBE ELEMENT REPLACEMENT	15
REPLACEMENT PART LIST	16
TROUBLESHOOTING	16

www.bromicheating.com	3

IMPORTANT NOTES AND WARNINGS

!WARNING

•Read all instructions before installing or using this heater

•Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.

•	Improper installation, adjustment, or alteration and failure
	to follow the warnings and instructions in this manual could
	result in severe personal injury, death or property damage.

•The manufacturer is not responsible for any damage that could happen from improper use. The manufacturer emphasises that this appliance should be used in a responsible manner and that all procedures, warnings, and safety instructions contained in this booklet be followed strictly.

•This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.

•Do not install the heater directly near a bathtub, shower or swimming pool. Any switches or controls must not be within reach of a person in the bathtub, shower or swimming pool.

•This heater is hot when in use. To avoid burns do not let bare skin touch hot surfaces. Keep combustible materials such as furniture, pillows, bedding, papers, clothes , etc. and curtains at least 3’(900mm) from the front the front of the heater and keep them away from the sides and rear.

•Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.

•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

•Keep packaging materials out of reach of children

•Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns, clothing ignition, or other serious personal injury

•Children should be carefully supervised when they are in the area of the heater.

•Do not attempt to alter the unit in any manner.

•Do not paint any surface of the heater.

•Do not touch the heater with wet hands at any time.

•Do not insert or allow foreign objects to enter front cover or front opening as this may cause an electric shock or fire, or damage the heater

•Do not touch the heating surface at any time, even when the heater is turned off and has cooled down.

• Do not use or store flammable materials near this appliance

•Do not spray aerosols or flammable materials in the vicinity of this appliance while it is in operation

•Never operate the heater in an explosive environment such as areas where petrol or other flammable liquids or vapours are stored.

•Clothing or other flammable materials should not be hung from the heater or placed on or near the heater.

INSTALLATION

•IMPORTANT - Installation must be carried out by a licensed and authorised person.

•The installer is to ensure that the requirements of the local authority, local electrical installation code, municipal building

codes, and any other relevant	statutory regulations are carried
out.

•After unpacking, make sure the appliance shows no signs of visible damage or tampering. If the appliance appears damaged, contact the place of purchase for assistance.

•Remove transit protection before use.

•This appliance must only be used on a 230-240 Volt AC Single Phase electricity supply.

•This radiant heater is NOT intended to be installed on recreational vehicles and/or boats.

•Do not run cord under carpeting. Do not cover with throw rugs, runners or the like arrange cord away from traffic area and where it will not be tripped over

•A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.

•To maintain Ingress Protection Rating (IPX4), only IPX4 rated conduit fittings should be used for electrical installation.

•Warning –To Reduce the risk of fire with Danger –To Avoid Fire

•This Installation, Operation and Service manual should not be removed from the site of installation. Installer should leave

manual with the customer for

future reference.

•Any guard or other protective device removed for servicing (conducted by an authorised person) must be replaced before operating the heater.

•Heaters are not intended to be installed in wardrobes.

•The appliance must not be located directly below or in front of a wall electricity socket. This is because the heat radiated from the appliance may damage the electricity outlet or plug.

•If the appliance has not been used, or will not be used, for a long period of time, disconnect power supply

•A means for disconnection of the heater must be incorporated in the fixed wiring according to the local electrical codes.

•Do not mount the heater vertically. Install Heater so that the infrared elements are

•Horizontal. Failure to do this may cause the heating element within the tube to sag and cause premature burnout. Installing vertically will void the manufacturer’s warranty.

CLEARANCE

•Do not place articles on or against this appliance

•A minimum safety distance of 3’ (900mm) should always be left in front of the appliance.

•Be sure the heater is not facing the ceiling or flammable or combustible substances/materials.

MAINTENANCE/ REPAIR

•Installation and repair must be carried out by a qualified & licenced service person only. The heater should be inspected

4	www.bromicheating.com

IMPORTANT NOTES AND WARNINGS CONTINUES ...

before use and at least annually serviced & inspected by a qualified & licenced service person.

•Do not perform maintenance until heater has been turned off, power disconnected, and heater temperature has cooled to room temperature.

•Check for damage to the appliance regularly. If damage to the appliance is suspected, discontinue use immediately and contact the supplier or qualified person to repair.

•If the supply cord is damaged, it must be replaced by an authorised and licenced person in order to avoid a hazard.

•At the end of this product’s useful life, it must not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is the user’s responsibility to dispose of this appliance through the appropriate channels at the end of its useful life. Failure to do

so may incur the penalties established by laws governing waste

disposal. Proper differential collection, and the subsequent recycling, processing and environmentally compatible disposal of waste equipment avoids unnecessary damage to the environment and possible related health risks, and also promotes recycling of the materials used in the appliance. For further information on waste collection and disposal, contact your local waste disposal service, or the place of purchase

PRODUCT OVERVIEW

Model	2000W	3000W	4000W	6000W
Part no.	BH0420002	BH0420003	BH0420004	BH0420005
No. of Elements	Single element	Single element	Double element	Double element
Bracket Length	6.5”	6.5”	9.5”	9.5”
Power (Watts)	1.8 - 2.0kW	2.8 - 3.0kW	3.4-3.9kW	5.4-5.9kW
Heating Area*	up to 64ft2	up to 100ft2	up to 120ft2	up to 144ft2
Power connection required (Volts/	230-240V - a.c.-	230-240V -a.c.-	230-240V -a.c.-	230-240V -a.c.-
Amps)	50/60Hz / 8.3A	50/60Hz / 12.5A	50/60Hz / 16.6A	50/60Hz / 25A
Dimension (W”xD”xH”)	44” x 8.5” x 3.5”	56” x 8.5” x 3.5”	44” x 8.5” x 3.5”	56” x 8.5” x 3.5”
Weight (kg)	19.8lbs	22lbs	19.8lbs	22lbs
Finish		Black High Temperature Coating

*Heating areas are based on protected environment with mounting height of 96” (8’). For unprotected and extremely cold and windy environments heating areas can be less. Please contact Bromic Heating for further advice.

PRODUCT FEATURES

•The Tungsten Smart-Heat Electric heaters are designed to provide efficient spot heating for commercial and residential applications.

•Suitable for indoor and outdoor heating applications such as restaurants, cafes, bars and clubs, factories, office spaces, designated smoking areas, public areas, hotels and more.

•The heaters are available in 2000W, 3000W,

4000W and 6000W models to suit a range of environments.

•High temperature corrosion-resistant coating.

•IPX4 water ingress protection rating.

•Soft glow infrared heating element - No harsh glare.

•Wall and ceiling mounting brackets allowing adjustable angle of the heating direction.

•Tube elements are included with the heater and easily installed.

•Heater is equipped with spectral reflector for excellent radiant heat output.

•Patent Pending & Registered Design

www.bromicheating.com	5