Broilmaster DPA100 Installation Manual

Sm o k e r Sh u t t e r

In S t a l l a t I o n In S t r u c t I o n S

Fo r u S e w I t h Br o I l m a S t e r ®

r e m I u m Ga S Gr I l l S

P

mo d e l nu m B e r S

t3, P3 a n d d3

dPa100-1

When placing DPA100, Smoker Shutter into an installed BIKH, Grill Surround a hole or slot must be
drilled into the stainless steel front panel on grill surround. Order B100550, Actuator Rod Kit to use
with DPA100, Smoker Shutter.

re t a I n ow n e r ’S ma n u a l

F o r Fu t u r e re F e r e n c e .

Page 1

Attention: You must wear gloves while grasping frame on smoker

1-3/4”

1-1/4”

shutter or handling smoker shutters.

If your Broilmaster is installed in the BIKH, grill surround, proceed
to Step 1.

If your Broilmaster is not installed in a BIKH, grill surround, proceed
to Step 4.

1. Remove front panel from grill surround

2. Place front panel face-up on a non-abrasive surface. When
facing the front panel, drill either a 7/8" diameter hole or 5/16"
slot into upper, left corner of front panel. Refer to Figure 1 for
hole location or Figure 2 for slot location.

3. Insert bushing into 7/8 " diameter hole in front panel.

4. Remove retract-a-rack from grill body bottom.

5. If applicable, remove cooking grids from grill body bottom.

6. If applicable, push lid stop into notch on grill body bottom.

7. Drill 1/8" pilot hole through grill body bottom. Refer to
Figure 3 for hole location. Enlarge 1/8" pilot hole with a 5/16"

drill bit for nal hole size.

Figure 1

Figure 3

8. If applicable, replace front panel onto grill surround.

9. Remove knob from 7-1/2" actuator rod provided with
DPA100.

Attention: Use 7-1/2" actuator rod for standard smoker shutter

installation. Use 9" actuator rod when smoker shutter is
installed into a BIKH, Grill Surround.

10. Insert hook on either 7-1/2" or 9" actuator rod into 9/32" hole
in shutter linkage on left side of smoker shutter. The hook
is inserted from the outside to the inside on linkage bar of
smoker shutter. Refer to Figure 4.

Figure 2

Figure 4

B101627-0-0811Page 2