Breville ESP4 User Manual

Model ESP4
CONTENTS
Page
Introduction 3
Breville Recommends Safety First 4
Special Safety Directions 5
Know your Breville Espresso/Cappuccino Maker 6
Operating your Breville Espresso/Cappuccino Maker 7
Before using your Espresso/Cappuccino Maker 7
How to make an Espresso 7
How to froth milk for a cappuccino or latte 10
How to release the steam pressure 11
Care and Cleaning 13
Trouble Shooting Chart 15
2
Bar Italia
Congratulations
Congratulations on the purchase of your new Breville Espresso/Cappuccino Maker
BREVILLE RECOMMENDS SAFETY FIRST
Congratulations on your purchase of your new Breville Espresso/Cappuccino Maker. We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind.
In addition, we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:
IMPORTANT SAFEGUARDS
Do not immerse cord, plug or
Espresso/Cappuccino Maker body in water or any other liquid.
Always use the appliance on a dry, level
surface.
Before use fully unwind the power cord.
Do not let the cord hang over the edge of
a table or counter, touch hot surfaces, or become knotted.
Do not place this appliance on or near a
hot gas or electric burner, or where it could touch a heated oven.
Always turn the Selector Control to
‘STANDBY’, switch the power off at the power outlet and then remove the plug when the appliance is not being used and before cleaning.
The appliance is not intended for use by
young children or infirm persons without supervision.
Do not leave the appliance unattended
when in use. Young children should be supervised to ensure that they do not play with the appliance.
This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use outdoors.
Do not touch hot surfaces. Use handles.
Regularly inspect the supply cord, plug
and actual appliance for any damage. If found damaged in anyway, immediately cease use and return the entire appliance to the nearest authorised Breville Service Centre for examination, replacement or repair.
Any maintenance other than cleaning
should be performed at an authorised Breville Service Centre.
The installation of a residual current
device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.
4
SPECIAL SAFETY INSTRUCTIONS
SPECIAL SAFETY INSTRUCTIONS
The cup-warming plate will always be
heating when the appliance is switched on at the power outlet. Please switch off and unplug when not in use.
Only use cold water in the water tank. Do
not use any other liquid.
Never use the appliance without water in it.
Ensure the water tank cap and filter
holder are firmly secured when using the appliance.
Always ensure the water tank cap is clean
around the seal and the centre valve area (never use if the seal is damaged or faulty).
As part of regular maintenance, it is
recommended that this appliance be taken to the nearest authorised Breville Service Centre for checking of the ‘Pressure Indicator Button’ once every two years.
Before removing the Water Tank Cap
ensure the Pressure Indicator Button has dropped down and is flush with the top of the cap.
To avoid possible burns from hot steam
and water, never remove the water tank cap or filter holder while there is steam pressure in the water tank. Remove all steam pressure first.
Refer to Page 11 for instructions on how
to release the steam pressure.
TO AVOID POSSIBLE BURNS FROM HOT STEAM AND WATER, NEVER OPEN THE WATER TANK CAP WHILE THERE IS PRESSURE IN THE WATER TANK. REMOVE ALL PRESSURE FIRST.
5
Loading...
+ 11 hidden pages