Breville ABN77000085549 User Manual

Wizz Mix Plus
INSTRUCTIONS FOR USE
AND RECIPE BOOK
Breville is a registered trademark of Breville Holdings Pty. Limited
PRINTED ON
RECYCLED PAPER
ABN 77 000 085 549
Breville Customer Service Centre
Australian Customers
Fax (02) 9384 9601
Email Customer Service askus@breville.com.au
New Zealand Customers
Fax 0800 263 001
Email Customer Service askus@breville.com.au
Breville Customer Service Centre Locked Bag 2000 Botany NSW 2019 AUSTRALIA
Customer Service: 1300 139 798
Breville Customer Service Centre Private Bag 94411 Greenmount AUCKLAND, NEW ZEALAND
Customer Service: 0800 288 513
© Copyright. Breville Holdings Pty. Limited 2002
the product you purchase may differ slightly from
the one illustrated in this booklet.
Model EM6
Issue 1/02
Model EM6
CONTENTS
Page
Breville Recommends Safety First 4
Know your Breville Wizz Mix Plus 5
Assembly and Operating Your Breville Wizz Mix Plus 6
Automatic Mixer Bowl Rotation 8
Using your Wizz Mix Plus as a Hand Mixer 8
Care and Cleaning 8
Measuring Up 11
Mixing Guide 12
Recipes
Eggs 13
Batters 15
Pastry 18
Scones 20
Tea cakes 22
Cakes 24
Wizz Mix Plus
Congratulations
on your purchase of your new Breville Wizz MixPlus
2
BREVILLE RECOMMENDS SAFETY FIRST
KNOW YOUR BREVILLE WIZZ MIX PLUS
We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer foremost in mind. In addition, we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:
Turbo button for extra burst of power
5 speed selector switch plus Pulse
Mixer motor body
IMPORTANT SAFEGUARDS
To protect against electric shock do not immerse cord, plug or mixer body in water or any other liquid.
Always use the appliance on a dry, level surface.
Position your mixer away from the edge of the bench top as it may move slightly during use.
Handle you mixer and attachments with care. Never place your fingers inside a mixing bowl or near beaters during use.
Keep hands, hair, clothing, as well as spatulas and other utensils away from moving beaters during operation.
Ensure the motor and beaters have completely stopped before setting the unit down on the benchtop or disassembling.
Do not place hands in the mixing bowl unless the unit is disconnected from the power outlet. Disconnect the mixer from the power outlet before removing beaters.
Use only the beaters supplied with this mixer.
Always remove the beaters from the mixer before cleaning.
Always switch the appliance off and then switch off at the power outlet before unplugging the appliance after use and before attempting to move the appliance, before putting on or taking off parts and before cleaning.
The appliance is not intended for use by young children or infirm persons
4
without supervision.
Do not leave the appliance unattended when in use.
Young children should be supervised to ensure that they do not play with the appliance.
Regularly inspect the supply cord, plug and actual appliance for any damage. If found damaged in any way, immediately cease use of the appliance and return the entire appliance to the nearest authorised Breville service centre for examination, replacement or repair.
The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.
Do not let the cord hang over the edge of a table or counter, touch hot surfaces or become knotted.
Do not place this appliance on or near a hot gas or electric burner, or where it could touch a heated oven.
Always turn off at the power outlet and remove cord before attempting to move the appliance, before putting on or taking off parts or before cleaning.
This appliance is for household use only. Do not use this appliance for anything other than its intended purpose. Do not use outdoors.
Eject button for release of beaters
Mixer release button - press
to release mixer from stand
320 watts of power
Mixing Pivot button
Beater sockets
Gear drive - for automatic
rotation of mixing bowl
Mixing bowl platform
ATTACHMENTS
• 1 x steel beater
• 1 x steel beater with white cog wheel collar
• 1 x steel dough hook
• 1 x steel dough hook with white cog wheel collar
• 1 x glass mixing bowl
5
ASSEMBLY AND OPERATION OF YOUR BREVILLE WIZZ MIX
ASSEMBLY AND OPERATION cont’d
ATTACHING THE BEATERS/ DOUGH HOOKS
1. Place the Wizz Mix Plus stand on a level, dry surface, such as a bench top. Ensure the mixer stand arm is in the horizontal position.
2. Attach the beaters to the mixer before it is placed onto the mixer stand.
3. Insert each beater shaft into the left and right beater sockets underneath the mixer body (see Figure 1). Ensure the beater with the white cog wheel collar is inserted into the socket with the cog wheel pattern. This is important to drive the bowl.
Fig. 1
4. Insert the beaters by pushing the shaft into the socket, turning slightly if required until they lock into place.
ATTACHING MIXER MOTOR TO MIXER STAND
1. To attach the mixer body to the mixer stand, position the mixer motor on the stand so that the back of the mixer aligns with the back of the arm stand.
2. Press the mixer unit down on the stand until the latch clicks into the locking position. (see Figure 2).
Fig. 2
The beater/dough hook with the white cog wheel collar should be in the correct socket so that it aligns with the cog wheel gear on the mixer stand. If not placed correctly, the bowl will not turn.
ENSURE THE MIXER IS SWITCHED OFF AND UNPLUGGED FROM THE POWER OUTLET BEFORE ATTACHING THE BEATERS TO THE MIXER
THE BEATERS/DOUGH HOOKS MUST BE INSERTED INTO THE CORRECT SOCKET, AS THEY ARE NOT INTERCHANGEABLE . IF NOT PLACED
6
CORRECTLY, THE BOWL WILL NOT TURN.
4. Ensure that the speed selector switch is set to the 'OFF' (O) position. Also ensure that the mixer is securely attached to the stand before using.
5. Add ingredients to the mixing bowl as per the recipe or your requirements.
6. Position the mixing bowl platform supplied on the mixer stand (See figure 3).
Fig. 3
7. Place the glass mixing bowl on the mixer stand (See figure 4).
Fig. 4
8. Press the Tilt button while holding the
mixer body and lower the mixer assembly so the beaters are inside the mixing bowl.
Make sure the mixer is securely attached to the stand and locked into the horizontal position before using.
AVOID CONTACT WITH BEATERS DURING OPERATION. KEEP HANDS, HAIR, CLOTHING, SPATULAS AND OTHER UTENSILS AWAY FROM THE BEATERS TO PREVENT INJURY OR DAMAGE TO THE WIZZ MIX.
9. Plug the cord into a 230/240v power outlet and turn power 'ON'.
10. Place the beaters into the ingredients inside the mixing bowl. To commence mixing, move the speed selector switch to the right to the required speed. Always begin mixing on a lower speed setting to prevent splattering, increasing to the desired speed for the mixing task. The speed setting can be adjusted during operation by moving the switch from left to right.
Always turn the Wizz Mix off if you need to scrape down the bowl during use. Then continue mixing.
11. When mixing is complete move the speed selector switch back the 'OFF' (O) position. Turn the power off at the power outlet and unplug cord.
12. Press the Mixer Pivot button and raise the mixer unit to the upright position.
13. Remove the mixer from the stand by pressing the Mixer Release button.
14. Remove the beaters/dough hooks by pressing the eject button while grasping the beater shafts. The beater/dough hooks will be released automatically. DO NOT try to pull the beaters/dough hooks out of the sockets. Use a spatula to scrape remaining mixture from the beaters/dough hooks.
7
ASSEMBLY AND OPERATION cont’d
TURBO BOOST FUNCTION
Pressing the Turbo Boost button while mixing provides an extra burst of power, overriding the speed setting being used. Press the Turbo Boost button and hold it down for no more than 30 seconds to avoid overheating. After the Turbo Boost has been used, always turn the mixer off and allow it to cool down for a few minutes before using again.
AUTOMATIC MIXING BOWL ROTATION (GEAR DRIVEN SYSTEM)
The Wizz Mix Plus features a unique gear driven mixing bowl rotation system that automatically rotates the mixing bowl at an even speed during operation for complete hands free operation and an efficient, even mixing action of ingredients.
The speed of the bowl rotation adjusts automatically to the mixing speed selected.
The mixing bowl will not rotate correctly unless the beater/dough hooks are correctly inserted (see 'Attaching the Beater' Page 6).
Only ever use the beaters/dough hooks supplied with this unit.
When using the mixer on the stand, only use the mixing bowl supplied with this unit.
USING YOUR WIZZ MIX PLUS AS A HAND MIXER
The Wizz Mix Plus can be used independently of the mixing stand as a hand­held mixer.
Never force or hold the mixing bowl while it is automatically rotating as this will damage the gear system.
Insert the beaters/dough hooks as per steps 1 to 4 (page 6). Continuously guide the beaters/dough hooks through the mixture for uniform mixing. When mixing is complete slide the speed selector to the 'OFF' position. Turn power off at the power outlet and unplug the cord. Remove the beaters/dough hooks by pressing the eject button while grasping the shafts. The beaters/dough hooks will be released automatically. DO NOT try to pull the beaters/dough hooks out of the sockets. Use a rubber spatula to scrape remaining mixture from the beaters/dough hooks.
CARE AND CLEANING
BEFORE FIRST USE
Before using your Breville Wizz Mix Plus for the first time, wash the beaters in warm soapy water with a soft cloth. Rinse and dry thoroughly. They may be washed in a dishwasher.
When first using your Wizz Mix Plus, you may notice an odour from the motor. This is normal and will dissipate as the motor is run in.
CLEANING AFTER USE
1. Always ensure that the speed selector switch is in the 'OFF' (O) position and that the power is turned off at the power outlet. Then remove the plug from the power outlet.
2. To remove the mixer motor for cleaning press the Mixer Release Button and lift the mixer motor from the support arm.
3. Holding the motor unit, press the eject button and remove the beaters.
4. Use a rubber spatula to scrape remaining mixture from the beaters/dough hooks.
Do not use abrasive scouring pads or cleaners when cleaning the beaters as these may scratch the beater surface. Also ensure
Then wash the bowl, beaters and dough
hooks in warm soapy water with a soft cloth. Rinse and dry thoroughly. They may also be washed in a dishwasher.
5. Do not allow the beaters to soak in water for an extended period of time, as this may lead to the metal finish being damaged.
6. Wipe the mixer body and mixer stand with a damp cloth and dry. Polish with a soft dry cloth.
7. Wipe any excess food particles from the power cord.
that the beaters are not soaked in water for extended periods of time ie. For several hours or overnight, as this may damage the metal finish.
Do not wash or soak the mixer stand in water or any other liquid. Clean with a damp cloth and dry. Do not allow water or any liquid to enter the gear system as damage may result.
AVOID ALLOWING THE BEATERS TO HIT AGAINST THE SIDE OF THE MIXING BOWL WHILE THE MIXER IS OPERATING AS THIS WILL RESULT IN
8
DAMAGE TO THE BEATERS.
NEVER IMMERSE THE MIXER, POWER CORD OR PLUG IN WATER OR ANY OTHER LIQUID.
9
Loading...
+ 9 hidden pages