Leporello, 85x205 mm, 10 pages, 2/2c = black + PMS541u
cruZer
Z20
1
2
2
3
1
4
6
90°
5
7
90°
a
b
c
d
2
34567
English
Our products are designed to meet the highest standards of
quality, functionality and design. We hope you entirely enjoy
your new Braun shaver.
Please read the use instruction carefully and thoroughly
before using the appliance.
Warning
Your shaver is provided with a special cord set with an
integrated Safety Extra Low Voltage power supply. Do not
exchange or manipulate any part of it. Otherwise there is risk
of electric shock.
This appliance is not intended for use by children or persons
with reduced physical, sensory or mental capabilities,
unless they are given supervision by a person responsible
for their safety. In general, we recommend that you keep the
appliance out of reach of children. Children should be
supervised to ensure that they do not play with the
appliance.
Oil bottle
Keep out of reach of children. Do not swallow. Dispose of
properly when empty.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Long hair trimmer
5 Charging light
6 On/off switch
7 Special cord set
Charging
The best environmental temperature for charging is between
15 °C and 35 °C.
Using the special cord set, connect the shaver to an
•
electrical outlet with the motor switched off.
When charging for the fi rst time or when the appliance is
•
not used for a few months, leave the appliance to charge
continuously for 4 hours.
The charging light (5) shows that the appliance is being
•
charged. When the battery is fully charged, the charging
light turns off. Intermittent blinking after a while indicates
that the battery maintains its full capacity. This can also
happen short term when charging after the battery was
completely discharged.
A full charge provides 30 minutes of cordless shaving
•
time depending on your beard growth.
Once the shaver is completely charged, discharge the
•
shaver through normal use. Then recharge to full capacity. Subsequent charges will take about 1 hour.
Maximum battery capacity will only be reached after
•
several charging/discharging cycles.
If the rechargeable batteries are discharged, you may
•
also shave by connecting the shaver to an electrical
outlet via the special cord set.
8
Shaving
Remove the foil protection cap (1). Activate the on/off switch
(6). The fl oating foil frame automatically adapts to your skin
surface for a close, smooth shave.
For pre-shaving after a few days of not having shaved, use
the long hair trimmer (4) to pre-cut long hairs. For a close,
smooth shave, fi nish with the foil.
Trimming
Push out the long hair trimmer (4). It allows controlled
trimming of moustache and sideburns. It evenly cuts and
trims larger areas: Ideal for shaping sideburns, moustaches and partial short beards.
Frequent use of the long hair trimmer may reduce the battery
capacity.
Tips for the perfect shave
For best results, Braun recommends you follow 3 simple
steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your
skin.
3. Stretch your skin and shave against the direction of
your beard growth.
Cleaning
This appliance is suitable for cleaning under an open
water tap.
Warning: Detach the hand-held part from the power
supply before cleaning it in water.
Regular cleaning ensures better shaving performance.
Rinsing the shaving head after each shave under running
water is an easy and fast way to keep it clean:
Switch the shaver on (cordless) and rinse the shaving
•
head under hot running water (b). A natural based soap
may also be used provided it contains no particles or
abrasive substances. Rinse off all foam and let the
shaver run for a few more seconds.
Next, switch off the shaver, remove the shaver foil and
•
the cutter block. Then leave the disassembled shaving
parts to dry.
If you regularly clean the shaver under water, then once
•
a week apply a drop of light machine oil onto the long
hair trimmer and shaver foil.
Alternatively, you may clean the shaver using the brush
provided (c):
Switch off the shaver. Remove the shaver foil.
•
Using the brush, clean the cutter block and the inner
•
area of the shaver head. However, do not clean the
shaver foil with the brush as this may damage the foil.
9
Keeping your shaver in top shape
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
(Shaver foil and cutter block: 20S)
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by
shaving) every 6 months approximately. Then recharge the
shaver to full capacity. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.
Environmental notice
This product contains rechargeable batteries.
In the interest of protecting the environment, please
do not dispose of the product in the household waste
at the end of its useful life. Disposal can take place at a
Braun Service Centre or at appropriate collection points
provided in your country.
Subject to change without notice.
Electric specifi cations see printing on the special cord set.
99562745/III-10
China/GB
10
Loading...