Your Activator (shaver with Clean&Charge station)
is a system equipped with highly advanced electronic
processors. It ensures unsurpassed closeness and
comfort for you and optimum care for your shaver:
• The system automatically adapts to any voltage
worldwide.
• The system recognizes when cleaning of your shaver is
required, and automatically recognizes which of the
three cleaning programs is appropriate.
• While the shaver is connected to the mains, the system
automatically takes care of charging and discharging in
a way that is optimized for the shaver’s battery capacity
and life span.
• The system takes care of lubrication of the shaver’s
cutting parts.
Warning
Your Activator is provided with a low-voltage adapter.
Therefore you must not exchange or manipulate any
part of it. Otherwise there is risk of electric shock.
In order to avoid any leakage of the cleaning fluid,
place the Clean&Charge station on a flat, stable
surface.
Do not tip, move suddenly or transport the station in
any way if a cleaning cartridge is installed.
Do not place the station in a mirror cabinet, nor store
it over radiators, nor place it on polished or laquered
surfaces. Do not expose to direct sunlight.
The station contains highly flammable liquid. Keep it
away from sources of ignition.
No smoking.
Keep out of reach of children.
24
Do not refill cartridge.
Use only original Braun refill cartridge.
If you wish, you may start shaving right away (if the shaver
is charged, see section «Shaver indicator lights»).
However, we recommend to follow the procedure
described here:
• Using the low-voltage adapter (1), connect the mains
socket of the Clean&Charge station (7) to the mains.
• Press the station lift button (4) to open the housing.
• Hold the cleaning cartridge (8) down on a flat, stable
surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station as far as
it will go.
• Slowly close the housing by pushing it down until it
locks.
eco
norm
al
auto s
intensive
full
cartridge
em
pty
25
Page 26
a
3
2
1
off
cartridge
empty
The display for cleaning fluid (6) will show how much
cleaning fluid is in the cartridge:
a) Cleaning solution sufficiently available
b) Up to 7 cleanings left
c) New cartridge required
empty
c
full
cartridge
full
empty
b
full
cartridge
3
2
1
off
auto select
clean
eco
norm
al
auto select
s
intensive
t
a
r
g
t
n
c
i
l
n
e
a
full
cartridge
em
pty
clean
eco
normal
intensive
a
b
c
d
Make sure the foil protection cap (9) is removed from the
shaver. Insert the shaver head down into the station (the
contacts on the back of the shaver (14) will correspond to
the contacts in the station (3)). If necessary, the system
will now charge the shaver.
Also, the cleaning status will be automatically analyzed
and one of the four diodes of the cleaning program display
(5) will light up:
a) The shaver is clean
b) Eco(nomic), i.e. short cleaning required
c) Normal cleaning required
d) Intensive cleaning required
8590
0
...2
0
4
0
6
0
8
0
1
0
0
clean
eco
lect
e
normal
auto s
intensive
g
n
i
s
n
t
a
a
r
e
l
t
c
full
cartridge
empty
auto select
intensive
clean
eco
normal
If the system has selected one of the three cleaning
programs, it will not start until you push down the «start
cleaning» button (2). This locks the shaver into the station
and starts the cleaning process.
We recommend cleaning after each shave.
While the cleaning is in progress, the respective cleaning
program light will flash. Each cleaning consists of several
cycles (where the cleaning fluid is flushed through the
shaver head) and a heat drying period. The total cleaning
time is 33 to 50 minutes.
Cleaning processes in the Clean&Charge should not
be interrupted. While the shaver is drying, the metal
parts of the shaver may be hot. Also, if the shaver is
taken out prematurely and is not dry, its electronics
could be harmed.
26
clean
eco
normal
auto select
intensive
When the program is finished, the blue «clean» light will
shine. You can release the shaver by pushing the «start
cleaning» button.
Your shaver is now clean, charged and ready for use.
Page 27
Shaving
2
1
2
1
3
2
1
8590
3
2
1
of
f
If the shaver is locked into the Clean&Charge station,
push the «start cleaning» button (2) to release the shaver
and take it out.
Switch positions
off = (switch is locked)
Press and push up the switch to operate the shaver:
1=Shaving with the pivoting head
(the pivoting cutting system automatically adjusts to
every contour of your face).
2= Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose).
3=The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Tips for the perfect shave
We recommend that you shave before washing, as the
skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard
growth.
To maintain 100% shaving performance, replace your foil
and cutter block every 18 months or when worn.
Shaving with the cord
If the shaver is completely discharged and you do not
have the time to recharge in the Clean&Charge station,
you may also shave with the shaver connected to the
mains via the low-voltage adapter.
After shaving
Automatic cleaning
After each shave, return the shaver to the Clean&Charge
station and proceed as described above in the section
«Before shaving». All charging and cleaning needs are
then taken care of. With daily use, a cleaning cartridge
should be sufficient for about 30 cleaning cycles.
The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approximately 8 weeks.
8
5
9
0
0
...
2
0
4
0
6
0
8
0
1
0
0
an
cle
o
ec
lect
l
a
rm
o
n
to se
au
e
iv
ns
inte
g
n
i
s
n
t
a
a
r
e
l
t
c
full
cartridge
pty
em
27
Page 28
2
1
off
1
off
new
0
a
old
0...20 40 60
8590
Quick cleaning
Press the foil release buttons (12) to lift the shaver foil
(do not remove the foil completely). Switch on the shaver
for approx. 5–10 seconds so that the shaved stubbles can
fall out.
Thorough manual cleaning
Manual cleaning is recommended only when the
Clean&Charge station is not available, e.g. when travelling. Never use water to clean the shaver.
Remove the shaver foil and tap it out on a flat surface.
Using the brush, clean the cutter block and the inner area
of the pivoting head. If you do not use the Clean&Charge
station for a longer period of time, you should apply a drop
of light machine oil onto the shaver foil.
Replacing the cartridge
After having pressed the lift button (4) to open the
housing, wait for a few seconds before removing the used
cartridge.
Before discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning
solution.
Cleaning the housing
Clean the housing of shaver and station from time to time
with a damp cloth, especially inside the opening of the
station where the shaver rests.
The shaver indicator lights
Pilot light (18): the shaver is connected to the mains.
The red low-charge light (17) flashes when the battery
capacity has dropped below 20%, provided the shaver is
switched on. The remaining capacity will then be sufficient
for 2 to 3 shaves.
28
0...20 40 6
8590
empty ch
8585
Page 29
Model 8590:
empty charge
charging lights (16) will light up (20% per light), provided
the shaver is connected to the mains or switched on.
Model 8585/8581: The green single charging light (16)
shows that the shaver is being charged. When fully charged, the charging light flashes or goes off. If later on, the
charging light comes on again, this indicates that the
shaver is being recharged to maintain its full capacity.
When the shaver is fully charged, all five
Charging information
A full charge will give up to 50 minutes of cordless shaving
time, depending on your beard growth.
Best environmental temperature range for charging is
15 °C to 35 °C.
For battery maintenance, the system will automatically
initiate full discharging and then recharging of the batteries. This will take place every six months at the most,
and only if necessary.
Accessories
Available at your dealer or Braun Service Centres:
•
Shaver foil and cutter block
To maintain 100% shaving performance, replace your
foil and cutterblock every 18 months or when worn.
Change both parts at the same time for a closer shave
with less skin irritation.
•
Cleaning cartridge Clean&Charge
No. 8000
CCR
0...20 40 60 80 100
8590
1
2
Environmental notice
This appliance is provided with nickel-hydride rechargeable batteries. To protect the environment, do not dispose
of the appliance in the household waste at the end of
its useful life. Open the housing as shown, remove and
dispose of the batteries at your retail store or at appropriate collection sites according to national or local
regulations.
The cartridge can be disposed with regular garbage.
3
56
4
29
Page 30
Subject to change without notice.
This product conforms to the EMC-Directive 89/336/EEC and
to the Low Voltage Regulation 73/23 EEC.
Electric specifications see printing on the housing.
Guarantee
We grant 1 year guarantee on the product commencing
on the date of purchase. Within the guarantee period we
will eliminate, free of charge, any defects in the appliance
resulting from faults in materials or workmanship, either
by repairing or replacing the complete appliance as we
may choose.
This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor.
This guarantee does not cover: damage due to improper
use, normal wear or use as well as defects that have a
negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts
are not used.
To obtain service within the guarantee period, hand in or
send the complete appliance with your sales receipt to an
authorised Braun Customer Service Centre.
30
Page 31
31
Page 32
5-644-457/02/XII-03
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.