Braun 7510 User Manual

7520
7516 7510
+
Syncro
7515 7505
Type 5493 Type 5494
+
-
Internet:
www.braun.com
5-494-460 /00 /II-01 GB/KOR Printed in Germany
Syncro 752 0
1
2
3
4 5
Syncro 7516
ro
ync
S
yncro
S
S
S
y
y
n
n
c
c
ro
ro
No. 7000
7
4
7516
6
7 8
9
10
Syncro 7515
7 8
Syncro 7510
+
7520
7
7510
Syncro 7505
+
7515
7
7505

English

210
+35°C
+15°C
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.
Important
Only use the power supply cord set provided. A damaged cord must be replaced immediately.
Description
1 Foil protection cap 7 Charging light 2 Shaver foil (green) 3 Cutter block 8 Low-charge light 4 Foil release button (red) 7520, 7515 only 5 Long hair trimmer 9 Pilot light 6 Switch 10 Shaver socket
Technical specifications:
Wattage via cord set: 7 W
Power supply via cord set: 100-240 V 2/50 or 60 Hz (automatic adaptation)
Shaver input voltage: 12-24 V
Charging the shaver
7570
First charging: Using the power supply cord set, connect the shaver to the mains with the switch on position «0» and charge it for at least 4 hours (plug might get warm).
Once the shaver is completely charged, shave without the cord until fully discharged. Then recharge to full capacity again (subsequent charges will take about 1 hour).
A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
Best environmental temperature range for charging is 15 °C to 35 °C.
Indicator lights
The pilot light shows that the shaver is connected to the mains.
4
+
21
21
a
u
t
o
m
a
t
i
c
l
o
c
k
2
1
3
The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light flashes or goes off. If later on, the charging light comes on again, this indi­cates that the shaver is being recharged to maintain its full capacity.
• Models 7520 and 7515 only:
The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts to every contour of your face
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the nose)
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard)
Shaving with the cord
If the rechargeable battery is discharged, you may also shave with the shaver connected to the mains via the power supply cord set. (If the shaver does not run immediately, charge it with the switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard growth.
Replace the shaver foil and cutter block every 11/2 years, or when the parts are worn, to ensure optimum shaving performance.
5
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge (only with models 7520, 7516 and 7510) automatically takes care of all cleaning and lubrication needs of your shaver. Please refer to separate use instructions.
Manual cleaning
For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely).
10
for approx. 5-10 seconds so that the shaved stubbles can fall out.
For a thorough cleaning (weekly), remove the shaving foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block
10
oil
with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
Syncro
in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25% better shave.* (Shaver foil and cutter block: part no. 7000)
7000
7000
(* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months.)
Switch on the shaver
Preserving the cell unit
In order to maintain the optimum capacity of the rechargeable battery, the shaver has to be fully dis­charged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity again. This reconditions the rechargeable battery.
Do not expose the shaver to temperatures of more than 50 °C for longer periods of time.
6
Accessories
7XXX
1
2
4
5 6
3
available at your dealer or Braun Service Centres:
Braun Clean&Charge
Shaver foil and cutter block
Wall holder
(part no. 7000)
Environmental notice
This appliance is provided with nickel-hydride recharge­able batteries. To protect the environment, do not dis­pose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations.
Subject to change without notice.
This product conforms to the EMC-Require­ments as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC).
7
Guarantee
Your Braun product comes complete with a 1 year guarantee that commences on the date of purchase. For you to obtain service within the guarantee period you must retain your sales receipt as proof of purchase.
Please ensure you store your sales receipt in a safe place.
Within the guarantee period we will repair, free of charge, any defects in the appliance resulting from faults in materials or workmanship, but may, at our discretion, choose to exchange specific parts or replace the complete appliance.
This guarantee does not cover: damage arising from improper use (kinks in the shaver foil, breakage), normal wear and defects that have a negligible effect on the value or operation of the appliance.
The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used.
The guarantee is valid for 12 months from the original date of purchase as per your sales receipt. The guarantee on any repairs or exchanges made under guarantee expires at the end of this period.
For UK only:
This guarantee in no way affects your rights under statutory law.
8
+35°C
+15°C
210
7570
9
21
21
1
2
3
+
k
c
o
l
c
i
t
a
m
o
t
u
a
10
oil
10
10
7000
7000
Syncro
11
7XXX
1
2
3
5 6
12
4
13
Loading...