BRAUN 7505 User Manual [ru]

7526

7505

Syncro

–

Type 5493 Type 5494

7526

English 4

Français 12

Español 20

Thank you for purchasing a Braun product. We hope you are completely satisfied with your new Braun shaver. If you have any questions, please call: US residents 1-800-BRAUN-11

1-800-272-8611

Canadian residents (905) 712-5400

Merci d’avoir fait l’achat d’un produit Braun. Nous espérons que vous serez pleinement satisfait de votre nouveau rasoir Braun. Si vous avez des questions, veuillez appeler Braun Canada : (905) 712-5400

Gracias por haber comprado un producto Braun. Esperamos que Ud. completamente satisfecha con su nueva afeitadora Braun. Si Ud. tiene alguna duda, por favor llame al: Cd. de México 387-1941 Interior del país 01(800) 508-5800

Internet

www.Braun.com

5-493-451/01/III-00 USA / CDN / Mex. Printed in Germany Imprimé en Allemagne Impreso en Alemania

The world’s # 1 selling foil shavers

Le rasoir à grille le plus vendu au monde

Fabricante mundial # 1 en la venta de rasuradoras de lámina

Syncro 7526

Syncro

Syncro 7505

No. 7000

7505

7 8

–

752

English

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:

Read all instructions before using this appliance.

DANGER

To reduce the risk of electric shock:

1. Do not reach for an appliance that has fallen into water. Unplug immediately.

2. Do not use while bathing or in a shower.

3. Do not place, store or charge the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.

4. Except when charging, always unplug this appliance from the electrical outlet immediately after using.

5. Unplug this appliance before cleaning.

FOR HOUSEHOLD USE SAVE THESE INSTRUCTIONS

WARNING

To reduce the risk of burns, fire, electric shock, or injury to persons:

1. Close supervision is necessary when this appliance is used by, on, or near children.

2. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.

3. The shaver should never be exposed to temperatures of less than 32 ºF / 0 ºC and more than 105 ºF/+40ºC for longer than a few hours. Keep the shaver and cord dry at all times. Do not handle with wet hands. Do not store in a damp environment. To avoid damage do not wind the cord around the appliance. It is important to check the cord for damage periodically particularly at each end where the cord enters the plug.

4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.

5. Keep the cord away from heated surfaces.

6. Never drop or insert any object into any opening.

7. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.

8. Do not use this appliance with a damaged or broken foil, as serious facial injuries may occur.

9. Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to «off», then remove plug from outlet.

210

+35°C

+15°C

Your Braun Syncro (7526 only) is supplied with a Braun Clean&Charge (please see separate use instructions).

Important

Only use the power supply cord set provided. A damaged cord must be replaced immediately.

Description

1 Foil protection cap 7 Charging light 2 Shaver foil (green) 3 Cutter block 8 Low-charge light 4 Foil release button (red) 7526 only 5 Long hair trimmer 9 Pilot light 6 Switch 10 Shaver socket

Technical specifications:

•

Wattage via cord set: 7 W

•

Power supply via cord set: 100-240 V 2/50 or 60 Hz (automatic adaptation)

•

Shaver input voltage: 12-24 V

Charging the shaver

•

7570

First charging: Using the power supply cord set, plug the shaver into an electrical outlet with the switch on position «0» and charge it for at least 4 hours (plug might get warm).

•

Once the shaver is completely charged, shave without the cord until fully discharged. Then recharge to full capacity again (subsequent charges will take about 1 hour).

•

A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.

•

Best environmental temperature range for charging is 60°F to 95°F / 15°C to 35°C.

Indicator lights

•

The pilot light shows that the shaver is plugged into the outlet properly.

•

The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light flashes or goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity.

• Model 7526 only:

The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.

Shaving

Switch positions

0 = Off (switch is locked)

Press and push up the switch to operate the shaver:

1 = Shaving with the pivoting head

The pivoting cutting system automatically adjusts to every contour of your face

2 = Shaving with the pivoting head locked at an angle

(to permit shaving in difficult areas, e.g. under the nose)

3 = The long hair trimmer is activated

(for trimming sideburns, moustache and beard)

Shaving with the cord

If the rechargeable battery is discharged, you may also shave with the shaver plugged into the outlet via the power supply cord set. (If the shaver does not run immediately, charge it with the switch on position «0» for approx. 1 minute.)

Tips for the perfect shave

•

It can take 14-21 days for your beard to adjust to the new shaving system.

•

We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.

•

Hold the shaver at right angles (90°) to the skin.

•

Stretch your skin and shave against the direction of beard growth.

•

Replace the shaver foil and cutter block every 11/2 years, or when the parts are worn, to ensure optimum shaving performance.

Keeping your shaver in top shape

Automated cleaning

The Braun Clean&Charge (only with model 7526) automatically takes care of all cleaning and lubrication needs of your shaver. Please refer to separate use instructions.

Manual cleaning

For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely).

for approx. 5-10 seconds so that the shaved stubbles can fall out.

For a thorough cleaning (weekly), remove the shaving foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block

oil

with Braun cleaning agents. If your skin is very dry and you notice a reduced operation

time of the shaver, apply a drop of light machine oil onto the shaver foil.

Do not rinse the shaver in or under water.

Replacing the shaving parts

The shaver foil and cutter block are precision parts that,

Syncro

in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25% better shave.* (Shaver foil and cutter block: part no. 7000)

7000

(* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months.)

Switch on the shaver

Preserving the cell unit

•

In order to maintain the optimum capacity of the cell unit, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity again. This reconditions the cell unit.

•

Do not expose the shaver to temperatures of more than 122 °F / 50°C for longer periods of time.

+ 18 hidden pages