BrassCraft BC260 User Manual

Cable Drum Machine

Operation

Manual

BC260 SERIES

Cleans 1 1/4" to 3" lines up to 50'

Used For: Sink, Shower & Floor Drains

42FM

" WARNING - Read All Instructions, When Using Electric Tools,

Basic Safety Precautions Should Always Be Followed To Reduce The Risk

Of Fire, Electric Shock And Personal Injury. Save These Instructions."

651-950200

GENERAL
SAFETY

Important

Replacement parts:

When servicing, use only
identical
replacement parts.
Polarized plugs:
To reduce risk of electric
shock, this equipment
has a polarized plug
(one blade is wider than
the other). This plug will
fit in a polarized outlet
one way. If the plug
does not fit fully in the
outlet, reverse the plug.
If it still does not fit,
contact a qualified
electrician to install the
proper outlet.
Do not change the plug
in any way.

WORK AREA

• Keep your work area clean and well lit. Cluttered benches and dark
areas invite accidents.

• Do not operate power tools in explosive atmospheres, such as in
the presence of flammable liquids, gases, or dust. Power tools create

sparks which may ignite the dust or fumes.

• Keep bystanders, children, and visitors away while operating a
power tool. Distractions can cause you to lose control.

ELECTRIC SAFETY

• Grounded tools must be plugged into an outlet properly installed and
grounded in accordance with all codes and ordinances. Never remove
the grounding prong or modify the plug in any way. Do not use any
adapter plugs. Check with a qualified electrician if you are in doubt as
to whether the outlet is properly grounded. If the tools should
electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user.

• Double Insulated tools are equipped with a polarized plug (one blade is
wider than the other.) This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install a polarized
outlet. Do not change the plug in any way. Double Insulation
eliminates the need for a three wire grounded power cord and
grounded power supply system. (Applicable only to Class II tools.)

• Avoid body contact with grounded surfaces such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock
if your body is grounded.

• Don’t expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock.

• Do not abuse the cord. Never use the cord to carry the tools or pull

the plug from an outlet. Keep cord away from heat, oil, sharp edges

or moving parts. Replace damaged cords immediately. Damaged
cords increase the risk of electric shock.

• When operating a power tool outside, use an outdoor extension cord
marked “W-A” or “W.” These cords are rated for outdoor use and
reduce the risk of electric shock.

PERSONAL SAFETY

• Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use tool while tired or under the
influence of drugs, alcohol, or medication. A moment of inattention
while operating power tools may result in serious personal injury.

• Dress properly. Do not wear loose clothing or jewelry. Contain long hair.
Keep your hair, clothing, and gloves away from moving parts. Loose
clothes, jewelry, or long hair can be caught in moving parts.

• Avoid accidental starting. Be sure switch is off before plugging in.
Carrying tools with your finger on the switch or plugging in tools that
have the switch on invites accidents.

• Remove adjusting keys or wrenches before turning the tool on. A
wrench or a key that is left attached to a rotating part of the tool may
result in personal injury.