Boss Audio 630UASB User Manual
2
CONTENTS
Installation & Removal .................................. 3
DIN Mount .................................................... 3
Installing the unit ........................................... 3
Removing the unit ...................................... 4
Wiring Connections ...................................... 5
Operation ..................................................... 6
Location of Keys ............................................. 6
Powering On/Off ............................................ 7
Audio Adjustment .......................................... 7
Time ................................................................ 7
Display............................................................. 7
Aux-In .............................................................. 7
Reset ............................................................... 7
Radio Operation ............................................. 7
Switching to Radio Mode ........................... 7
Selecting AM/FM ....................................... 7
Selecting Station ........................................ 7
Auto Memory Storing & Scanning ............ 7
Reset Stations ............................................. 8
Station Storing ............................................ 8
USB/SD Playback ............................................ 8
Selecting Tracks .......................................... 8
Play/Pause .................................................. 8
Direct Track Access ..................................... 8
BT Playback ..................................................... 9
Remote Control ........................................ ...10
Specifications ................................................ 11
Troubleshooting ............................................ 12
3
Tabs
Screwdriver
Sleeve
Dashboard
30
53mm
182mm
INSTALLATION
Choose the mounting location where the
unit will not interfere with the driver.
Before finally installing the unit, connect
the wiring temporarily and make sure it is
all connected properly and the unit and the
system work properly.
Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
Install the unit where it does not get in the
driver’s way and cannot injure the
passenger if there is an emergency stop.
If installation angel exceeds 30° from
horizontal, the unit might not give its
optimum performance and could
compromise water resistance.
Avoid installing the unit where it would be
subject to high temperature, such as from
direct sunlight, or from hot air, from the
heater, or where it would be subject to
dust, dirt or excessive vibration.
DIN MOUNT
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below:
Installing the unit
1. Make sure the ignition is turned off, and
then disconnect the cable from the vehicle
battery’s negative (-) terminal.
2. Disconnect the wire harness and the
antenna.
3. Mount the sleeve by inserting the sleeve
into the opening of the dashboard and
bend open the tabs located around the
sleeve with a screw driver. Not all tabs
will be able to make contact, so examine
which ones will be most effective.
Bending open the appropriate tabs
behind the dashboard to secure the
sleeve in place.
4. Reconnect the wire harness and the
antenna and be careful not to pinch any
wires or cables.
5. Slide the unit into the sleeve until it locks
into place.
6. Reconnect the cable to the vehicle battery’s
negative (-) terminal. Then replace the
outer trim ring.
4
REMOVING THE UNIT
1. Make sure the ignition is turned off, then
disconnect the cable from the vehicle
battery’s negative (-) terminal.
2. Remove the metal strap attached the back of
the unit (if attached).
3. Lift the top of the outer trim ring then pull it
out to remove it.
4. Insert both of the supplied keys into the slots
at the middle left and right sides of the unit,
then pull the unit out of the dashboard.
Loading...