Page 1
Page 2
DESCRIPTION OF CONTROLS ON FRONT CONTROL PANEL
3
1
6
7
2
5
18
9
8
4
19
10
14
15
11
17
12
SPECIFICATION
GENERAL
Supply Voltage DC 12V. Negative Ground
Current Consumption Max.10A
Power Output 4 x 50 W
Number of channels 2 STEREO channels.
Unit Dimensions (L X W X H): 7 X 3.85 X 1.97
13
178 X 98 X 50 (mm)
FM SECTION
16
Frequency range
Effective sensitivity 3uV.
87.5Mhz - 108Mhz (Europe)
87.5 Mhz - 107.9Mhz (U.S.A.)
I.F Frequency 10.7MHz.
Front Control Panel
20
Front Cabinet after removing Front Control Panel
1. RELEASE button
2. SEL & VOL knob
3. POWER & MUTE button
4. LCD
5. SRC button
6. DISP button
7. BND/AP button
8&9. |<< And>>| buttons
10. 1/TOP/>|| button
12. 3/RPT button
13. 4/RDM button
14. 5 DIR- button
15. 6 DIR+ button
16. USB PORT
17. Card slot
18. AUX IN jack
19. IR Remote Sensor
20. RESET button
11. 2/INT button
AM SECTION
Frequency range
522Khz - 1620Khz (Europe)
530khz - 1710Khz (U.S.A.)
Effective sensitivity 40dB.
I.F Frequency 450KHz
Preamp Output 1 V Output
SD or USB PLAYBACK
System MP3 audio system.
Frequency characteristics 20Hz -100Hz dB
10KHz-20KHz dB.
<=5
<=5
Signal to noise (SD & USB) 50dB [1KHz] .
Page 1
Page 6
Page 3
INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
1.- REL BUTTON
To remove the front panel from the main body, press the REL button.
2. - SEL & VOL CO NT RO L BUTTON
A) Press the SEL re peatedly to select VOLUME - BASS - TREBLE - BALANCE - FADER.
B)Press SEL button and hold for more than 2 seconds to turn on EQ OFF(POP/ROCK/
CLAS), then long press SEL button repeatedly to select , LOUD OFF/LOUD ON,
BEEP OFF/ON, AREA(USA/EUR) in radio mode) mode. After selecting the desired
mode, rotate the VOL- or VOL+ button to select one setup item of the desired mode.
To boost up the capability of anti-jamming,
please make sure fix tightly the metal support
strap into the metal joint that connect to the
chassis of the car.
METAL SUPPORT STRAP
DASHBOARD
METAL MOUNTING SLEEVE
To remove the unit out of the metal mounting sleeve,
insert the two supplied KEYS into the left and right side
slots of the chassis at the same time. Then pull the chassis
out of the metal mounting sleeve as shown in the right
illustration.
FIXED FACEPLATE
WIRES CONNECTION
WHITE
RED
ISO SOCKET
RCA OUTPUT
RCA OUTPUT
ANTENNA JACK
CONNECTOR A
1.
2.
3.
4. Memory +12V
5. Auto Antenna Output
6.
7. 12V (To Ignition Key)
8. GROUND
UNIT
CHASSIS
Bend the tabs on the metal mounting
Sleeve against the DASHBOARD with
a screwdriver
FRONT PANEL
PLASTIC TRIM RING
ISO SOCKET SKETCH
CONNECTOR B
1. Rear Right Speaker (+)
2. Rear Right Speaker (-)
3. Front Right Speaker (+)
4. Front Right Speaker (-)
5. Front Left Speaker (+)
6. Front Left Speaker (-)
7. Rear Left Speaker (+)
8. Rear Left Speaker (-)
BEEP ON/BEEP OFF
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
3. -POWER ON/OFF AN D MU TE
Press the POWER to turn on this unit. To turn off the unit, press and hold this button
unit it off. During playing, press this to mute the sound.
4.LCD DISPLAY
5.SRC BUTTON
Press the SRC to select RADIO/CARD(SD card inserted)/USB(flash driver inserted)/
AUX mode.
IN SD, and USB mode, press and hold SRC button to activate TRACK SEARCH
and play the select track automatically.
6. DISP button
In USB/CARD mode, during playback, the ID3 tag information of the current track will
display on the LCD. As long as the current playing music contains relevant ID3 tag
information. Press the DISP to cancel the ID3 function, then the corresponding number
of the current track will display on the LCD.
FUSE 10 A
7. - BND/AP BUTTON
A)Press the BND/AP button to select radio band as follow:FM1 -> FM2 -> FM3 -> A M1
-> AM 2. Press and hold the BND/AP button to activate the auto storage function. The
unit scans and preset the stations with strongest signal.(18stations in FM or 12
stations in AM )
8&9. -TUNE, SEEK, TRACK, SKIP UP/DOWN BUTTONS
A) Radio mode
Press the>>I or I<< to perform manual seek tuning. Press and hold the >>I or I<< to
perform auto tuning. The unit will tune to the station with strong signal.
B) SD, and USB mode
Press the >>I or I<< to play the next or previous track.
Page 5
Page 2
Page 4
10-15. - PRESET STATI ON S ME MO RY AND >II, INT, RPT, RDM BUTTONS
A)Radio mode
Press the 1-6 buttons to select the preset stations. Press and hold the 1-6 buttons to
store the station that currently listening.
B) SD, and USB mode
Press the >II to pause or resume playing. Press the INT to play the first 10 seconds of
the tracks. Press again to off this function and the current track will keep playing.
Press the RPT once to repeat plays the current track. Press the RPT twice to repeat
plays the current folder. Press the RPT thrice to repeat plays all tracks.
Press the RDM to turn random play on or off. Press the 5/6 to play the next or previous
folder.
16. - USB PORT
When USB storage device is connected, the unit is automatically sw it ch ed t o US B mo de .
17. - SD CARD SLOT
When SD card is inserted, the unit is automatically switched to SD mode.
(Note: if both USB storage device and SD card inserted, the system will switch to
the mode of USB.)
18. - AUX I NP UT J AC K (3.5MM STE REO JA CK)
Press the SRC to select auxiliary input playing mode when connecting with external
audio device.
19.- IR Remote Sensor
20.- RESET BUTTON
The unit must be reset under the following conditions:
A) Prior to using this unit for the first time after installation.
B) If the unit fails to operate properly, press the RESET with a pen t ip o r ot he r po in te d
instrument.
OPERATION OF REMOTE CONTROL
5
12
1. Powe r On/Off
2. Mute B utton
3. Loudness Button
This fu nctio n enhan ces t he bass s ound effec t
given t he low vo lume le vel . Press t he LOUD t o
turn on/off the loudness function.
4. SEL/ MENU Bu tto n
5&6. VO L UP/ DOW N Butto n
7. MO/S T But ton
Press the MO/ST to select stereo or mono sound
mode under FM radio reception.
8. A.P Button
Press the A.P button to preview the current preset
stati ons.( 18s ta tio ns in FM ) Pr ess and hold the A.P
butto n to acti vate th e aut o stora ge func tion. The un it
scans and preset the stations with strongest signal. (18stations in FM )
9. Band B utton
10. Mod e Butto n
11. Tune/Seek Up And Track Skip Up/FF Button
12. Tune/Seek Down And Track Skip Down/REW Button
13. SCA N BUTTON
Press the SCN button to scan the radio frequency. If a valid s ignal h as dete cte d, the cu rrent frequency will be
hold an d blink ing for 5 s econds, then press SCN again to stop scan and remain the current frequency; other
wise, the radio will go on to scan the other radio frequency 5 sec ond s later.
14. DSP butt on
In USB/CARD mode, during playback, the ID3 tag information of the current track will
display on the LCD. As long as the current playing music contains relevant ID3 tag
infor matio n. Pres s the D SP to c ancel t he ID3 fu nctio n, th en the corresponding number
of the current track will display on the LCD.
17
20
1
2
MUTE
SELECT
8
14
DSP
A.P.
ST
-
9
10
16
19
MODE
TOP/
1
RDM
4
BAND
INT
2
5
LOC
RPT
3
6
LOUD
SCN
4
11
6
7
15
3
13
18
21
Page 3
15. LOC /DX But ton
Local seeking tuning lets you tune in only those radio station with sufficiently strong signals for good receptions.
Press LOC to select the local (LO) or distance (DX) mode on radio recep tion. ( Not e: t his f uncti on only w ork s on
FM rece ption )
16. Track TOP/>||/Radio Preset 1
17. Track INT/Radio Preset 2
18. Track RPT/Radio Preset 3
19. Track RDM/Radio Preset 4
20. Rad io Pres et 5 and US B/C ARD DIR -
21. Rad io Pres et 6 and USB/CARD DIR+
Page 4
Loading...