Bose YZUR, YZUT User Manual
SL2
WIRELESS SURROUND LINK
Owner’s Guide
Guía de usario
Notice d’utilitsation
gçp
SAFETY INFORMATION
Please read this owner’s guide
Please take the time to follow the instructions in this owner’s guide carefully. It will help you set up and operate your
system properly and enjoy its advanced features. Please save this owner’s guide for future reference.
WARNING: To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture.
WARNING: The apparatus shall not be exposed to dripping or splashing, and objects filled with liquids, such as vases,
shall not be placed on the apparatus. As with any electronic product, use care not to spill liquids into any part of the system.
Liquids can cause a failure and/or a fire hazard.
The lightning flash with arrowhead symbol within an equilateral triangle alerts the user to the presence of
uninsulated, dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral triangle alerts the user to the presence of important operating and
maintenance instructions in this owner’s guide.
WARNING: No naked flame sources, such as lighted candles, should be placed on the apparatus.
Note: The product label is located on the bottom of the product.
This product is intended to be used only with the power supply provided.
Note: Where the mains plug is used as the disconnect device, such disconnect device shall remain readily operable.
This product must be used indoors. It is neither designed nor tested for use outdoors, in recreation vehicles, or on
boats.
This product conforms to the EMC Directive 89/336/EEC, to the Low Voltage Directive 73/23/EEC, and to the RTTE
Directive (99/5/EC). The complete Declaration of Conformity can be found at
www.bose.com/static/compliance/index.html.
Important safety instructions
1. Read these instructions – for all components before using this product.
2. Keep these instructions – for future reference.
3. Heed all warnings – on the product and in the owner’s guide.
4. Follow all instructions.
5. Do not use this apparatus near water – Do not use this product near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement, near a swimming pool, or anywhere else that water or moisture are present.
6. Clean only with a dry cloth – and as directed by Bose Corporation. Unplug this product from the wall outlet
before cleaning.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions – To
ensure reliable operation of the product and to protect it from overheating, put the product in a position and
location that will not interfere with its proper ventilation.
8. Do not install near any heat sources, such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Only use attachments/accessories specified by the manufacturer.
10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Unplug this apparatus during lightning storms or when unused for long periods of time – to prevent damage
to this product.
2
SAFETY INFORMATION
gçp
12. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way: such as power supply cord or plug is damaged; liquid has been spilled or objects
have fallen into the apparatus; the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
13. To prevent risk of fire or electric shock, avoid overloading wall outlets, extension cords, or integral
convenience receptacles.
14. Do not let objects or liquids enter the product – as they may touch dangerous voltage points or short-out parts
that could result in a fire or electric shock.
15. See product enclosure for safety related markings.
16. Use proper power sources – Plug the product into a proper power source, as described in the operating
instructions or as marked on the product.
Information about products that generate electrical noise
U.S.A.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any modifications made to this equipment may void the user’s authority to operate this equipment.
Canada
This product complies with the Canadian ICES-003 Class B specification.
Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
RF Guideline:
This device meets the RF Guideline FCC/OET 65 and Canadian Health Code 6 for mobile devices, which assumes installation
provides a distance of at least 20 centimeters (8 inches) from users and others.
This device must not be co-located or operated in conjunction with any other radio transmitter or its antenna.
For your records
The product serial number is located on the bottom of the SL2 transmitter.
Serial number: _________________________________________________________________________________
Dealer name: __________________________________________________________________________________
Dealer phone:________________________________________________ Purchase date:___________________
For future reference, it can be helpful to keep the sales slip and a copy of your product registration card together with
this guide.
3
gçp
YOUR SL2 WIRELESS SURROUND LINK
Getting ready
Thank you for choosing a Bose® SL2 Wireless Surround Link. It provides a simple and
convenient
powered
The SL2 features a small radio frequency transmitter and receiver pair that delivers the left
and right surround audio signals, complete with amplification, to surround speakers in the
rear of your room. Running cable from the front to the back of the room is unnecessary.
Unpacking the carton
Carefully unpack the carton and save all packing materials, which provide the most secure
way to transport the product.
Check to be sure your system includes all of the parts shown (Figure 1). If any part appears
damaged, do not attempt to use it. Notify Bose or your authorized Bose dealer immediately.
For Bose contact information, refer to the address sheet included in the carton.
means to enjoy the surround sound from your LIFESTYLE® system or
Acoustimass® system.
Figure 1
Carton contents
SL2 transmitter
Transmitter cable
6-ft (1.8 m)
Transmitter power pack
120 VAC
(U.S./Canada)
Surround speaker cables
20-ft (6.2 m)
Jewel Cube
speaker adapters
230 VAC power cord
(U.K./Singapore)
®
220 VAC power cord
(Europe)
SL2 receiver
Owner’s
guide
Receiver power pack
120 VAC
(U.S./Canada)
220 VAC power cord
(Europe)
240 VAC power cord
(Australia)
230 VAC power cord
(U.K./Singapore)
A box with dotted lines identifies parts that vary with different
product versions or in different countries.
240 VAC power cord
(Australia)
4
Loading...