Installer’s Guide
Bose® FreeSpace® Model 32SE
Surface-Mount Environmental Loudspeakers
2
English
Safety Information
Safety reminders
1.1 Read and keep all safety and operating instructions for future
reference.
1.2 For your safety, follow all cautions and warnings in the operating
instructions and on the speakers.
1.3 Follow the instructions in this guide carefully when installing this
product.
1.4 Do not install the loudspeakers near excessive heat sources.
This includes installations near or above radiators, ranges, grills,
fryers, stoves, or other appliances.
1.5 Always route cables so heavy or sharp objects cannot pinch or
cut them.
1.6 Check local codes for use of safety cables. The loudspeaker
has threaded inserts and 1/4-20 screws (1/4-inch diameter with
20 threads per inch, U.S. terminology) are provided for
attaching the safety cables.
1.7 Service by a qualified service person if:
A. The loudspeaker cone is visibly damaged;
B. The loudspeakers do not operate normally even though the
instructions in this guide have been followed;
C. The loudspeakers exhibit a distinct change in performance.
In accordance with EMC Directive 89/336/EEC and Article 10(1)of the Directive,
is in compliance with the following norm(s) or document(s):
Technical regulations: EN50081-1, EN50082-1
Accredited by:
Bose Corporation, The Mountain, Framingham, MA 01701-9168 USA
Bose Products B.V.
Nijverheidstraat 8, 1135 GE Edam
The Netherlands
Nic Merks
Vice President Europe
Manufacturer’s authorized EU representative
15 April 2000
DECLARATION OF CONFORMITY
We, the offerer:
Bose® Corporation, The Mountain, Framingham, MA 01701-9168 USA
acknowledge our sole responsibility, that the product:
Kind of equipment: Loudspeaker
Type designation: Model 32SE loudspeaker
3
English
Installation
1.0 Package contents
2.0 Steps for loudspeaker installation
For 70V and 100V versions of the Model 32SE loudspeakers,
remove the rear cover.
2.1 Changing the tap on 70V and 100V
versions
Both the 70V and 100V versions are set at the factory to the maximum of 32W. For lower output volume, change that setting to 16W,
8W, 4W, 2W or 1W. To do that, remove the spade connector from
the 32W spade and reinsert it into the preferred spade.
8W
1W
2W
4W
16W
32W
Supplied with 70V and 100V
Model 32SE loudspeakers only.
4
English
Installation
2.2 Connecting the wires
This process varies according to the version of loudspeaker you are
using.
2.2.1 To the 4 ohm version
Caution: Install the 4 ohm Model 32SE loudspeaker in compliance
with local building and electrical codes. In the U.S., this version is
designed for installation using Class 2 wiring methods in accordance
with Articles 640 and 725 of NFPA 70, National Electrical Code.
Guidelines for Class 2 wiring methods are usually appropriate for
nonhazardous live circuits and wiring methods in many other countries.
2.2.2 To the 70V or 100V versions
Caution: Install the loudspeakers in compliance with local building
and electrical codes. In the U.S., this version is designed for installation using Class 1, 2, or 3 wiring methods in accordance with
Articles 640 and 725 of NFPA 70, National Electrical Code. Guidelines for Class 2 wiring methods are usually appropriate for nonhazardous live circuits and wiring methods in many other countries. The
guidelines for Class 1 and 3 wiring methods are appropriate for
hazardous live circuits in those same countries.
MODEL 32SE
ENVIRONMENTAL SPEAKER
REFER TO YOUR INSTRUCTION MANUAL FOR PROPER INSTALLATION AND
OPERATING PROCEDURES.
4 OHM PASSIVE POWER RATING: 40W IEC
©2000 BOSE CORPORATION
SUITABLE FOR USE OUTDOORS AND IN WET LOCATIONS
SER. NO. 393560002BP
U.S. PAT. NOS. 4,158,756 4,061,890 RE.31.31,679
BOSE CORPORATION
FRAMINGHAM, MA 01701-9168 U.S.A.
MADE IN IRELAND 254377 REV. 00
Red
(+)
Black
(–)
+
–
5
English
Installation
Optional use of quick-connect terminals on 70V and 100V
versions
Reattach the cover to protect wire termination. Dress the wires
carefully to prevent the cover from pinching them.
Alternative wire treatment
• Simple wiring • Daisy chaining
• Sealed rear housing* • Daisy-chaining and sealed rear
housing**
*Use supplied liquid-tight **Dealer must supply additional
fitting fitting. Or, if local codes allow it,
route both wires through one
fitting.
6
English
Installation
2.3 Mounting the bracket
Choose a position and mounting method consistent with local
building codes and regulations. Use two screws per bracket.
• Wall-mount option • Ceiling-mount • Mounting footprint
option
2.4 Attaching and adjusting the speaker
Partially insert the screws into the speaker.
After adjusting the speaker angle, use a wrench to tighten the
mounting screws firmly, securing the bracket.
6.9"
(175.2 mm)
"
"
7
English
Specifications
3.0 Loudspeaker specifications
Frequency Range
90Hz to 16kHz (±3 dB)
Model 32SE Versions
Active Equalization
• 70V (1W, 2W, 4W, 8W, 16W, 32W taps)
• 100V (1W, 2W, 4W, 8W, 16W, 32W taps)
Passive Equalization
• 4Ω, 32W, no transformer
Sensitivity
Active Equalization
86dB-SPL @ 1W, 1m (pink noise)
Passive Equalization
86dB-SPL @ 1W, 1m (pink noise)
Maximum Acoustic Output
101dB-SPL @ 1m (pink noise)
101dB-SPL @ 1m (IEC noise)
Dispersion (-6dB point, average, 1-4kHz)
132o conical
Long-Term Power Handling
32W continuous
Mechanical Specifications
Dimensions: 6"H x 9"W x 5.6"D (15.2 cmH x 22.9 cmW x
14.1 cmD)
Weight: 5 lb (2.3 kg)
Connectors: 70V/100V, screw terminals; 4Ω hex-nut post terminals
Mounting Hardware Included: Quick install U-bracket and hardware
Additional Mounting Points: Two (2) 1/4-20 inserts, 0.7" on bottom
8
English
Warranty
Limited Warranty Bose® Product
What is covered:
All parts defective in material and workmanship.
For how long:
Five years from the purchase date.
What we will do:
We will, at our sole option, repair or replace any defective parts free of charge.
What we will not do:
Pay shipping or transportation charges from you to us.
What you must do:
1. Return product personally with proof of purchase from an authorized Bose
dealer to your authorized Bose dealer, or
2. Return product personally with proof of purchase from an authorized Bose
dealer to the nearest Bose Service Agency, or
3. Return product personally with proof of purchase from an authorized Bose
dealer directly to the Bose organization in your country. If you elect to return
the product directly to a Bose organization,
a) Contact the Bose organization in your country for specific return and
shipping instructions;
b) Properly pack the product in the original carton for shipping. If you
need a new carton, contact the Bose organization in your country for a
new carton available at a nominal charge;
c) Label and ship, freight prepaid, to the address provided by the Bose
organization in your country, and
d) Place any necessary return authorization number prominently on the
outside of the carton. (Cartons not bearing a return authorization
number, where required, will be refused.)
Other conditions:
This warranty is fully transferable provided that the current owner furnishes the
original proof-of-purchase from an authorized Bose dealer. The provisions of this
warranty are in lieu of any other written warranty, whether express or implied, written
or oral, including any warranty of merchantability or fitness for a particular purpose.
Bose’s maximum liability shall not exceed the actual purchase price paid by you for
the product. In no event shall Bose be liable for special, incidental, consequential or
indirect damages. This warranty does not cover a defect that has resulted from
improper or unreasonable use or maintenance, accident, improper packing, or
unauthorized tampering, alteration or modification as determined solely by us. This
warranty is void if the label bearing the serial number has been removed or defaced.
Other law rights:
This warranty gives you specific legal rights, and you may also have other rights
which vary from country to country or state to state. Some places do not allow
limitations on implied warranties or the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to
you.
Please keep this warranty information for your personal records.
Bose Corporation thanks you for your recent Bose product purchase. For your
benefit, we recommend that you record your serial number(s), found on the
product(s), and other purchase information below and keep it with your personal
records along with proof-of-purchase. If necessary, this information will allow us to
9
English
©2000 Bose Corporation
The Mountain
Framingham, MA
01701-9168 USA
English
Loading...