Bosch WC140 User Manual
WC140 Integrated Dishwasher
Manual for Installation, Use and Maintenance
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
Important
The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this
product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect
installation or misuse of the appliance.
This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental
capacity, or who lack experience or knowledge about it, unless they have had supervision or instructions on how to use
the appliance by someone who is responsible for their safety.
Under no circumstances should any external covers be removed for servicing or maintenance except by suitably
qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a
fault with your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
This appliance has been designed for domestic use only. Commercial use will invalidate the warranty
CE Declarations of Conformity:
This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directives
89/336/EC, 2006/95/EC, IEC436/DIN44990, EN 50242
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC
DIRECTIVE 2002/96/EC.
At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer
providing appliance recycling services.
Disposing of a household appliance separately avoids possible negative consequences for the environment
Disposing of a household appliance separately avoids possible negative consequences for the environment and health
and health. It also enables the constituent materials to be recovered, saving both energy and resources. As a
deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings
reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out
in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked
with a crossed-out wheeled dustbin.
wheeled dustbin.
.
Important
• Read the instructions prior to installation and use of the appliance.
• Do not lean or climb on the open dishwasher door to prevent damage.
• Close the dishwasher door after use to prevent accidents.
• Use only detergents, salt and rinse aid specifically designed for dishwashers.
• Do not put solvents in the dishwasher detergent compartment to prevent risk of explosion
• Only put dishwasher safe items into the dishwasher. If in doubt, check with the manufacturer of the items.
• Take care when loading the dishwasher to observe the recommendations for best loading practice, and also to ensure
that sharp objects such as knives are placed blade down to prevent accidents.
• Do not open the dishwasher door when a programme is running. If it is necessary to do so, then open it
only slightly to allow the dishwasher to pause the programme and prevent any water spilling out. Remember that the
water in the dishwasher can be very hot when the programme is running.
• When the dishwasher is not in use, we reccomend that you turn off the water supply at the supply tap and disconnect
the main supply.
• If you are leaving the dishwasher for an extended period you should leave the door slightly open to prevent the
formation of unpleasant smells.
Recommendations
Recomendations
• To reduce energy and water consumption, remove all dirt residues from the dishes prior to loading the dishw•
• To reduce energy and water consumption, remove all dirt residues from the dishes prior to loading the dishwasher.
• Only run the dishwasher only when fully loaded.
• Only run the dishwasher when fully loaded.
• Place hollow items (bowls, glasses and pans) face down in the basket.
• Place hollow items (bowls, glasses and pans) face down in the basket.
Before first use
• Set the water softener level as required by the water hardness in the area.
• Add 2kg of salt into the salt compartment and then fill with water to the top of the salt compartment.
• Remove all the packaging materials from the interior of the dishwasher.
• Fill the rinse aid compartment.
• Run a hot programme without any dishes in the dishwasher.
Control Panel
Power Button
To switch the power to the dishwasher on or off, press the power button (1). When you switch on the dishwasher, the end
of programme light will illumnate.
Programme Selection Button
To select a programme, press the programme selection button (2). The dishwasher will store in its memory the last
programme used. To change the programme, press the programme selection button again until the light next to the
required programme is illuminated.
Delay Timer Button and Delay Timer Indicator Lights
The dishwasher is equipped with a variable delay timer of three, six or nine hours’ duration. To set the delay timer, press the
delay timer button (3). This will switch on the delay timer for three hours, and the 3h light will illuminate. To change the
duration, press the delay timer button again until the light next to the required time (6h or 9h) is illuminated.
To cancel the timer, press the delay timer button again until none of the delay timer indicator lights are illuminated.
illuminate.
As the delay timer counts down, the delay timer indicator lights will illuminate in turn, so at six hours’ delay the 6h light will
illuminate, and at three hours’ delay the 3h light will illuminate.
Salt Warning Light
When the dishwasher salt begins to run out, the salt warning light will illuminate to advise that the salt needs refilling.
Rinse Aid Warning Light
When the rinse aid begins to run out, the rinse aid warning light will illuminate to advise that the salt needs refilling.
End of Programme Light
When the programme is complete, the dishwasher will emit five beeps and the end of programme light will illuminate.
Programme selection button
Power button
2
1
Delay timer button
3
Indicator lights
Starting a programme
• PressthePowerbutton.
• Press the Programme Selection button until the required programme light is illuminated.
• If required, press the Delay Timer button.
• Oncethepowerisswitchedon,theendofProgrammeIndicatorlightwillswitchon.
• Onceaprogrammeisselected,theendofProgrammeIndicatorlightwillswitchoff,andtheProgrammeIndicator
light will switch on.
• Whenyouclosethedishwasherdoortheprogrammewillstartautomatically.
Please note: The dishwasher stores the most recently used programme in its memory. To change the
programme, simply press the Programme Selection button .
Power button
Programme Selection button
Delay Timer button
End of Programme
Indicator light
At the end of a programme
Ifpossible,donotopenthedishwasherdooroncetheprogrammehasstarted.
Attheendoftheprogramme,thedishwasherwillbeepvetimes,andtheendofProgrammeIndicatorlightwillswitchon.
Changing a programme
It is possible to change the programme if necessary once the programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the Programme Selection button until the required Programme Indicator light is illuminated.
• Then close the door. The dishwasher will begin the new programme from the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel the programme once the programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold the Programme Selection button for approximately three seconds, until the end of Programme Indicator
light flashes and the Programme Indicator light switches off.
• Then close the door. The dishwasher will drain for approximately thirty seconds. Once this is complete, the
dishwasher will beep five times and the end of Programme Indicator light will switch on.
Switching the dishwasher off
• Once the dishwasher beeps five times, and the end of Programme Indicator light switches on, the dishwasher can be
switched off by pressing the Power button.
• Then turn off the water tap and remove the plug from the power socket.
Please note: The dishwasher will automatically continue on the programme it has started if the door is
opened or in the event of a power cut.
Detergent
fig 1
fig 2
fig 1
To fill the detergent compartment
1. Push the latch to open the compartment.
2. Add the required amount of detergent. The main detergent compartment
(b in figure 1) has lines to allow for specific amounts of detergent.
These are marked at either 15 cm
the dishes are.
Ifyourdishesareinneedofanintensivewash,thenadd5cm
detergent into the prewash section of the compartment (a in figure 1).
3. Then close the detergent compartment lid until the latch locks.
Please note: You should only use detergents designed specifically for
use in dishwashers.
Ifusingdishwashertablets,alwaysusethedetergentcompartment,donotput
them in the main body of the dishwasher or in the cutlery basket. The solubility
of dishwasher tablets can vary depending on the temperature and duration of
the programme. As a result, it is recommended that powder detergents should
be used in the shorter programmes to allow better performance.
3
or 25 cm3, depending on how dirty
3
of
fig. 1
CDA recommends the use of separate detergent, rinse aid and dishwasher salt
rather than combination tablets as separates achieve better wash performance.
Ifyoudousecombinationdetergents,addsaltandrinseaidtothedishwasher
and then adjust the water hardness setting and rinse aid setting to the
minimum.Whenyouthenuseseparatedetergentsagain,youshouldllthe
salt and rinse aid compartments, adjust the water hardness setting to the
maximum and run an empty wash, then adjust the water hardness setting and
the rinse aid setting to the appropriate level.
Salt
To ensure the best efficiency, the dishwasher needs soft water. Hard water
means that lime residues remain on the dishes and the interior of the
dishwasher, affecting performance. The softener system is designed to
remove the ions that make the water hard to provide the best quality wash
performance. This is achieved by using dishwasher salt.
To add dishwasher salt, follow the steps below:
1. Remove the lower dishwasher basket and then unscrew the salt
compartment cap, as shown in figure 2.
2. Fill the compartment with dishwasher salt (do not use table salt), carefully
to prevent unnecessary spillage. Before first use, you should fill the
compartment with 2kg of dishwasher salt and then fill up the salt
compartment with water (up to the brim of the compartment) as shown
in figure 3.
3. Replace the cap and the lower basket.
Whenthesaltwarninglightonthecontrolpanelilluminates,youshould
refill the salt compartment with salt only – do not add water to the salt
compartment after the first use.
You should run a programme immediately after adding dishwasher
salt, to prevent any damage to the dishwasher systems.
fig. 2
fig. 3
Softener adjustment
ENGLISH
Open the
testing
strip.
Run
water
through
your tap
for 1
min.
Keep the
testing
strip in
water for 1
sec.
Shake the
testing strip
after taking it
out of water.
Wait for
1 min.
Make your machine’s water hardness
setting according to the result
obtained through the testing strip.
The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher
is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the
system is correctly set. To find out the water hardness level of your water supply you can use the test strip supplied or
alternatively contact your local water board.
No Lime
Very low lime content
Low lime content
Medium lime content
Lime content
High Lime content
1. Open the testing strip.
2. Run water through the tap for one minute.
3. Hold the testing strip in water for one second.
4. Shake the testing strip after taking it out of the water
5. Wait for one minute
6. Check the number of marks on the strip to see the level of water hardness.
If the hardness of the water you use is above 63dE or if you are using well water; you are recommended to use filter and
If the hardness of the water you use is above 60 dE or if you are using well water; you are recommended to use lter and
water refinement devices.
water refinement devices.
Please note: The level of water hardness is preset to level 3.
1. Press and hold down the programme selection button
2. Press the power button to switch on the dishwasher
3. Keep the programme selection button pressed until the five programme indicator lights and the end of programme
indicator light flash.
4. To adjust the level, press the programme selection button until the required level is selected. The programme lights
will illuminate as in the table of water hardness settings.
5. To store the selected water hardness level, press the power button.
Loading...