Bosch VIP X1600 XF User Manual
VIP X1600 XF
Network Video Server – Base
en Installation and Operating Manual
VIP X1600 XF Table of Contents | en 3
Table of Contents
1Preface 5
1.1 About this Manual 5
1.2 Conventions in this Manual 5
1.3 Intended Use 5
1.4 EU Directives 6
1.5 Rating Plate 6
2 Safety Information 7
2.1 Electric Shock Hazard 7
2.2 Installation and Operation 7
2.3 Maintenance and Repair 7
3 Product Description 9
3.1 Scope of Delivery 9
3.2 System Requirements for Setup 9
3.3 Configuration and Operation 9
3.4 Overview of Functions 10
3.5 Connections and Displays 11
4 Installation 13
4.1 Preparations 13
4.2 Installing Modules 13
4.3 Installing in a Switch Cabinet 14
4.4 Connections 16
4.5 Power On/Power Off 17
5 Maintenance and Upgrades 19
5.1 Testing the Network Connection 19
5.2 Unit Reset 19
5.3 Repairs 19
5.4 Transfer and Disposal 19
6 Appendix 21
6.1 Troubleshooting 21
6.2 LEDs 21
7 Specifications 23
7.1 VIP X1600 XF Base 23
Bosch Security Systems Installation and Operating Manual F.01U.082.088 | V3.5 | 2008.05
4 en | Table of Contents VIP X1600 XF
F.01U.082.088 | V3.5 | 2008.05 Installation and Operating Manual Bosch Security Systems
VIP X1600 XF Preface | en 5
1Preface
1.1 About this Manual
This manual is intended for persons responsible for the installation and operation of the
VIP X1600 XF. International, national and any regional electrical engineering regulations must
be followed at all times. Relevant knowledge of network technology is required. The manual
describes the installation and operation of the VIP X1600 XF base.
1.2 Conventions in this Manual
In this manual, the following symbols and notations are used to draw attention to special
situations:
CAUTION!
This symbol indicates that failure to follow the safety instructions described may endanger
!
i
persons and cause damage to the unit or other equipment.
It is associated with immediate, direct hazards.
NOTICE!
This symbol refers to features and indicates tips and information for easier, more convenient
use of the unit.
1.3 Intended Use
The VIP X1600 XF network video server is intended for use with CCTV systems and serves to
transfer video and control signals via data networks (Ethernet LAN and Internet). The optional
modules for installation determine the range of functions. Encoder modules (senders) and
decoder modules (receivers) are available. The encoder modules each contain RAM memory
for short-term recording of connected cameras. Audio signals can also be transmitted with the
audio versions of the encoder modules. Various functions can be triggered automatically by
incorporating external alarm sensors. Other applications are not permitted.
In the event of questions concerning the use of the unit which are not answered in this
manual, please contact your sales partner or:
Bosch Sicherheitssysteme GmbH
Robert-Koch-Straße 100
85521 Ottobrunn
Germany
www.boschsecurity.com
Bosch Security Systems Installation and Operating Manual F.01U.082.088 | V3.5 | 2008.05
6 en | Preface VIP X1600 XF
1.4 EU Directives
The VIP X1600 XF network video server complies with the requirements of EU Directives 89/
336 (Electromagnetic Compatibility) and 73/23, amended by 93/68 (Low Voltage Directive).
1.5 Rating Plate
For exact identification, the model name and serial number are inscribed on the rating plate
on the bottom of the VIP X1600 XF base and on the rating plates on the circuit boards of the
modules. Please make a note of this information before installation, if necessary, so as to have
it to hand in case of questions or when ordering spare parts.
F.01U.082.088 | V3.5 | 2008.05 Installation and Operating Manual Bosch Security Systems
VIP X1600 XF Safety Information | en 7
2Safety Information
2.1 Electric Shock Hazard
– Never attempt to connect the unit to any power network other than the type for which it
is intended.
– Use only power supply units approved by Bosch Security Systems.
– Never open the housing of the power supply unit.
– Always install a module in the appropriate VIP X1600 XF base housing only.
– If a fault occurs, disconnect the VIP X1600 XF from the power supply and from all other
units.
– Install the power supply and the unit only in a dry, weather-protected location.
– If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
2.2 Installation and Operation
– The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
– Relevant knowledge of network technology is required to install the unit.
– Before installing or operating the VIP X1600 XF, make sure you have read and understood
the documentation for the modules in use and for any other equipment connected to it,
such as cameras or monitors. The documentation contains important safety instructions
and information about permitted uses.
– Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
2.3 Maintenance and Repair
– Never open the housing of a VIP X1600 XF base. The unit does not contain any user-
serviceable parts. Remove only the supplied cover when installing a module.
– Do not change any components in a VIP X1600 XF base or a module. The units do not
contain any user-serviceable parts.
– Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
– Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists).
Bosch Security Systems Installation and Operating Manual F.01U.082.088 | V3.5 | 2008.05
8 en | Safety Information VIP X1600 XF
F.01U.082.088 | V3.5 | 2008.05 Installation and Operating Manual Bosch Security Systems
Loading...