Bosch DCN-DIS Quick Reference Card

DCN-DIS Discussion Unit (Dual Delegate)

Channel selector

Volume control

Microphone

button

Microphone

button

Legend

Speaking

Miscellaneous

Listening

Loudspeaker

On:

Microphone active

Last minute

Request-to-speak

First in list

Flashing:

On:

Voice mode

Flashing:

Channel selector

Volume control

On:

Microphone active

Last minute

Request-to-speak

First in list

Flashing:

On:

Voice mode

Flashing:

DCN Next Generation | Quick Reference Card | DCN-DI S Discussion Unit (Dual Delegate)

Bosch Security Systems | 2005-09 | 9922 141 70671 © Bosch Security Systems B.V. | Data subject to change without notice

Microphone

To enable the microphone:

Push your microphone button to enable the microphone of the discussion unit.

• If the red light around your microphone button comes on, you can speak.

• If the green light around your microphone button comes on, your request-to-speak is accepted. You cannot speak until the red light around your microphone button comes on.

To cancel a request-to-speak:

When the green light around your microphone button is on, push your microphone button to cancel your request-to-speak. The operator can disable the possibility to cancel the request-to-speak.

To disable the microphone:

When the red light around your microphone button is on, push your microphone button to disable the microphone. The red light around your microphone button goes off. The operator can disable the possibility to disable the microphone.

VIP mode

When the yellow light around your microphone button comes on, the discussion unit is in the VIP mode. In the VIP mode:

• You can always enable the microphone.

• You cannot make a request-to-speak.

Voice mode

When the discussion unit is in the Voice mode, the microphone is always enabled. Push and hold your microphone button to temporarily disable the microphone. In the Voice mode, you cannot make a request-to-speak.

Channel selector

With your channel selector, you can select the channel that is sent to your headphones. Your channel selector is automatically enabled when you connect your headphones to the discussion unit.

Note

Some types of discussion units do not have a channel selector. With these types of discussion units, you cannot change the audio signal that is sent to your headphones.