Page 1
1
1
BPWK-88
WINE COOLER
N
GB
U
ser manual
Page 2
Thanks for buying our wine cooler, Hope our advanced product will give your wine a
different joyful taste. Before use, please read and follow all safety rules and operating
instructions.
WARNING
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock, or
injury when using your appliance, follow these
basic precautions:
• Read all instructions before using the Wine cooler.
• DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will “just sit in the garage a few days”.
• Before you throw away your old Wine cooler: Take off the door. Leave the shelves in
place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this
or any other appliance. The fumes can create a fire hazard or explosion.
• The refrigerant of these applances are R600a ,
Flammable and explosive articles should
not be put in or near the cooler, to avoid the fire or explode caused.
-Save these instructions-
To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling shelves out of the rail compartment.
The appliance must be positioned so that the plug is accessible. Release the electric
cord. Move your cooler to its final location. Do not move your Cooler while
loaded with wine. You might distort the body. The wine cellar should be installed in
a suitable place in order to avoid Touching the compressor with the hand.
If the supply cord is damaged, it must be replaced by manufacturer of its Service
agent or a similarly qualified person in order to avoid a hazard.
PLEASE DON’T TRY TO PLUG INTO OR EXTENSION THE CABLE IN ANY
CASE.
2
Page 3
INSTALLATION INSTRUCTIONS
Before Using Your Wine cooler
• Remove the exterior and interior packing.
• Before connecting the Wine cooler to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• When disposing your appliance, please choose an authorized disposal site.
Installation of Your Wine cooler
• Place your Wine cooler on a floor that is strong enough to support it when it is fully loaded.
To level your Wine cooler, adjust the front leveling leg at the bottom of the Wine cooler.
• Locate the Wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Avoid locating the unit in moist areas.
• Plug the Wine cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized Products service center.
Attention
• Store wine in sealed bo t tle s ;
• Do not overload the cooler;
• Do not open the door unless necessary;
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air
circulation;
• Should the Wine cooler be stored without use for long periods it is suggested, after a careful
cleaning, to leave the door ajar to allow air to circulate inside the cooler i n order to avoid
possible formations of condensation, mold or odors.\
OPERATING YOUR WINE COOLER
AND SETTING THE TEMPERATURE CONTROL
Please use the cooler under 5-32 ℃ am bi en t tem p eratu re, i f the am bi en t temperature is higher
than or lower than this temperature, it will cause the temperature fluctuation in the cooler,
3
Page 4
maybe can't reach 5-18 ℃.
Controll System Instruction
This is LCD touch panel.
• “PO
WER”
When the indicator light is on, the prower for machine is on.
• “ ”
To s
hows the temperature of the internal cooler.
•
“ ” Button
The button control upper compartment setting temperature. When you press this button, the
setting temperature will decrease 1 ℃.
• “ ” Button
The button control lower compartment setting temperature. When you press this button, the
setting temperature will decrease 1 ℃.
• “
” Button
To control the inner light turn on/off.
Press this button, the light is on, and the light is not co
ntroled by door. Press this button again,
the light is off, and the light is controled by door.
• “
” Button
To control this appliance turn on/off.
Press this button, the power is on. Press this button with 3 seconds again, the power is off.
• “
”
Al
arm Indicator light
Setting The Temperature Controls
• The temperature setting range as below:
Upper compartment: 5～10ºC
Lower compartment: 10～18ºC
• The acquiescence temperature as below:
Upper compartment: 6 ℃
Lower compartment: 12ºC
• When the system will be entering the set up temperature. Each press once the button,
4
Page 5
the temperature setting of the upper zone will increase 1℃, When the temperature setting reach
the upper limit 10ºC,the temperature will return 5ºC.Each press once the button,the
temperature setting of the lowrer zone will low er 1℃ ,When the temperature setting reach the
upper limit 18ºC, the temperature will return 10ºC.
• If
you view actual temperature inside the wine cooler. Please pre ss the or butto n keep 3
seconds,the actual temperature of the upper zone or the lower zone will be display the control
board. After 5 seconds and The temperature will return to display the setting temperature.
• Fl
ashing word= Cooler Temperature
Steady word = Set Temperature
Note
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine cooler will not start.
• When you use the Wine cooler for the first time or restart the Wine cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the Wine cooler is running for a few hours everything will be back to normal.
Function Instruction
• Temperature Recollection Function
In the event of a power interruption, wine cooler can remember the previous temperature settings,
and when the power is recovery,the cooler temperature will go back the same setting
temperature as power off.
• Overtime Open the Door Alarm
When you forget close the door or the door is not closed completely, the buzzer alarm after 5
minutes. Please close the door completely and advoid the cold energy was lost.
Storage diagram
(for 750 ml Bordeaux bottles)
Total: 42 bottles (Max)
F
O
O
c
Shelves
• To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
• For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
5
Page 6
compartment, however this unit was designed with a notch on each sides of the shelf tracks to
prevent bottles from falling.
• W
hen removing any of these shelves out of the rail compartment, To fit or remove the shelf, tilt
the shelf as per the diagram and simply pull out, or push in the shelf until it sits on the support
brackets securely.
C
OUTION
！
Do not store bottles crossways on the interior floor! Otherwise, bottles may fall out when the appli ance
door is opened and this may cause injury or material damage.
How to change the door opening
6
Page 7
This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge
kit comes with the unit (in the box), should you wish to reverse the hinge on your unit.
1. Incline the wine cooler with 45 degrees, take out right lower hinge’s screws with screwdriver
(Fig.1)
2. Le
vel the wine cooler,Hold the door,and take out right upper hinge’s screws with screwdriver,
then take out the door,and rotate door at 180 degree (Fig.2 & Fig.3 & Fig.4)
3. Ta
ke off the decorated nail from left upper side,then fit the door with screws,then fit the
decorated nail to right side of A location. (see Fig.5& Fig.6)
Installation specifications for built-in purposes
7
Page 8
1. After installed wine cellar into cooler, please adjust limited block (a) close to cooler (b)
2.
Please fix the 3 pcs screws through the limited block (a) screw hold into cooler (b), please fi
nd
b
elow picture for reference
a、Limited block b、Cooler c、Screw d、Screwdriver
CARE AND MAINTENANCE
Cleaning Your Wine cooler
8
Page 9
• Turn off the power, unplug the appliance, and remove all items including shelves and rack.
• Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
• Wash the outside cooler with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
Power Failure
• Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened. If the power is going to
be off for a longer period of time, you need to take the proper steps to protect your contents.
Vacation Time
• Short vacations: Leave the Wine cooler operating during vacations of less than three weeks.
• Long vacations: If the appliance will not be used for several months, remove all items and turn
off the appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave
the door open slightly: blocking it open if necessary.
Moving Your Wine cooler
• Remove all items.
• Securely tape down all loose items (shelves) inside your appliance.
• Tu
rn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
Energy Saving Tips
• The Wine cooler should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.
9
Page 10
PROBLEMS WITH YOUR WINE COOLER?
You ca
n solve many common Wine cooler problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUB
LESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Wine cooler does not operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Wine cooler is not cold enough.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off frequently.
The room temperature is hotter than normal.
A large amount of contents has been added to the
Wine cooler.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
The light button is “OFF”.
Vibrations.
Check to assure that the Wine cooler is level.
The Wine cooler seems to make too much noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
Wine cooler.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The Wine cooler is not level.
The door will not close properly.
The Wine cooler is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
10
BORETTI B.V.
De Dollard 17
1454 AT Wate
rgang
T +31(0)20-4363439
F +31(0)20-4361326
S +31(0)20-4363525 (service) E
info@boretti.com
The Netherlands
N
.V. BORETTI S.A.
Rupelweg 16
2850 Boom
T +32(0)3-4508180 F
+32(0)3-4586847 E
info.be@boretti.com Belgium
Loading...