Blue SA2412DX, SA1312, SA1320, SA2420DX User Manual

Rev. 5/16, Ver. 5

OWNER’S MANUAL

& N

CORNER SAUNAS

Please Do Not Hesitate to

Contact Our Consumer Hotline

800-759-0977

with Any Questions That May

Arise During Assembly or

Use of This Product!

SA1312/SA1320/SA2412DX/SA2420DX

TABLE OF CONTENTS

ASSEMBLY TIPS & WARNINGS

PARTS IDENTIFIER

ASSEMBLY INSTRUCTIONS

OPERATION INSTRUCTIONS

ENJOYING YOUR SAUNA

HEALTH & SAFETY WARNINGS

CLEANING & MAINTANENCE

TROUBLESHOOTING GUIDE

REPLACEMENT PARTS

5-10

14-15

16-23

WARRANTY INFORMATION

If you would like a French version of this manual, please contact

our Customer Service Department at 800-759-0977 or custserv@splashnetxpress.com

Si vous voulez une version française d’un manuel, s'il vous plaît contacter

notre service à la clientèle au 800-759-0977 ou custserv@splashnetxpress.com

The information contained in this manual is subject to change without notice.

ASSEMBLY TIPS & WARNINGS

• Before you begin, read all assembly instructions and safety warnings carefully.

• This sauna requires at least 3 adults to complete assembly.

• Remove all of the contents from boxes and verify that you have all of the parts shown on the Parts

Note: Some parts may be pre-installed or pre-assembled.

may not look exactly like your product.

• Retain this Owner’s Manual for future reference.

ELECTRICAL REQUIREMENTS

• We recommend consulting a licensed electrician and checking local ordinances before installing ANY sauna.

• This sauna requires a 20 amp receptacle and a 20 amp circuit breaker.

may be required to accommodate 20 amp power.

• This sauna requires a dedicated circuit - No other appliances should share the same outlet with the sauna.

CHOOSING A LOCATION

• This sauna should only be placed INDOORS on a dry, level surface.

• There should be a minimum of 5 inches clearance between the sauna and any wall.

• Make sure the main power cord will reach the outlet and remains easy to access.

• The sauna should only be used in a dry location as moisture will damage the wood and electrical

components.

combustible materials.

PARTS IDENTIFIER (NOT TO SCALE)

This manual is used for the assembly of several sauna models; therefore, some images or drawings may not look exactly like your product.

ASSEMBLY INSTRUCTIONS

1. Begin assembly by determining an appropriate location for your sauna – see ASSEMBLY TIPS & WARNINGS for details. Attach the FRONT PANEL to the FLOOR by lining up the FRONT PANEL with the groove in the front of the FLOOR.

2. Attach the LEFT PANEL to the FRONT PANEL by aligning the hooks and sliding the LEFT PANEL down, locking it into place.

3. Attach the RIGHT PANEL to the FRONT PANEL by aligning the hooks and sliding the RIGHT PANEL down, locking it into place.

ASSEMBLY INSTRUCTIONS (CONT.)

4. Attach the LEFT BACK PANEL to the FLOOR. Buckle the LEFT BACK PANEL to the LEFT PANEL.

5. Attach the RIGHT BACK PANEL to the FLOOR. Buckle the RIGHT BACK PANEL to the RIGHT PANEL and to the LEFT BACK PANEL.

6. Attach the FLOOR HEATER to the FLOOR with 1-1/2” SCREWS. Connect the heater plug.

ASSEMBLY INSTRUCTIONS (CONT.)

7. Slide the LONG BENCH HEATER PANEL into place between the LEFT BACK PANEL and RIGHT PANEL. Connect the heater plug. Note: It may be necessary to unbuckle the RIGHT PANEL from

the RIGHT BACK PANEL in order to slide the LONG BENCH HEATER PANEL into place.

8. Slide the SHORT BENCH HEATER PANEL into place between the LONG BENCH HEATER PANEL and LEFT PANEL. Connect the heater plug. Note: Make sure the FLOOR HEATER cable is

placed through the groove in the bottom of the SHORT BENCH HEATER PANEL.

9. Attach LONG BENCH SEAT with 2” SCREWS.

ASSEMBLY INSTRUCTIONS (CONT.)

10. Attach SHORT BENCH SEAT with 2” SCREWS.

11. Lift the ROOF above the sauna, feeding the control panel and heater cables through the corresponding holes. Feed the cables for the AM/FM CD PLAYER through the hole in the bot tom of the ROOF. Secure the ROOF to the sauna with 1-1/8” SCREWS. Connect the control panel and heater plugs.

12. Feed the main power cable through hole in ROOF and plug securely into receptacle on back of POWER SUPPLY box . Secure the ROOF COVER with 3/4” SCREWS.

+ 16 hidden pages