Blomberg KND9920X Operating Instructions Manual
Operating instructions
KND9920X
Refrigerator
EN
1
Please read this manual first!
Dear Customer,
We hope that your product, which has been produced in a 1st-class manufacturing
facility and checked under the most meticulous quality control procedures, will provide
you with years of good service.
For this, we recommend you to carefully read the entire manual of your product before
using it and keep it at hand for future reference.
This manual
• Will help you use your appliance quickly and safely.
• Read the manual before installing and operating your product.
• Follow the instructions, especially those for safety.
• Keep the manual in an easily accessible place as you may need it later.
• Besides, read also the other documents provided with your product.
Please note that this manual may be valid for other models as well.
Symbols and their descriptions
This instruction manual contains the following symbols:
C Important information or useful usage tips.
A Warning against dangerous conditions for life and property.
B Warning against electric voltage.
EN
2
1 Refrigerator 3
2 Warnings 4
Electrical Requirements .....................6
Warning! This Appliance Must Be
Earthed .............................................6
Energy Saving Tips ............................7
Compliance with WEEE Directive and
Disposing of the Waste Product: .......8
Compliance with RoHS Directive: ......8
Package information ..........................8
3 Installation 9
Points to be paid attention to when the
relocation of the refrigerator ...............9
Before you start the refrigerator, .........9
Electrical connection ..........................9
Disposing of the packaging .............10
Disposing of your old refrigerator .....10
Placing and Installation ....................10
Adjusting the legs ............................11
Changing the illumination lamp .......11
4 Preparation 12
5 Using your refrigerator 13
Indicator Panel .................................13
Freezing fresh food ..........................18
Door Open Warning .........................18
Recommendations for preservation of
frozen food ......................................19
Placing the food ..............................19
Water Dispenser ..............................20
Egg holder .......................................22
Blue light .........................................22
Sliding storage container .................22
Deep-freeze information ..................23
Flexi zone Storage Compartment ..23
Telescopic Drawer ..........................24
Description and cleaning of odor
filter: ................................................24
6 Maintenance and
cleaning 25
Protection of plastic surfaces ..........25
7 Troubleshooting 26
8 How To Obtain Service 29
9 Guarantee Details 30
EN
3
1 Refrigerator
1. Egg holder
2. Fridge compartment shelf
3. Sliding and Rotary storage containers
4. Bottle shelf
5. Coolcontrol Compartment's drawer
6. Freezer Compartment's drawer
7. Crisper (Snack Compartment)
8. Bottle holder
C Figures that take place in this instruction manual are schematic and may not correspond
exactly with your product. If the subject parts are not included in the product you have
purchased, then it is valid for other models.
1
2
11
15
14
10
*8
9
7
*3
4
5
6
13
13
12
9. Illumination lens
10. Adjustable glass shelves
11. Fan
12. Ice container
13. Separators
14. Freezer compartment
15. Fridge compartment
*OPTIONAL
EN
4
2 Warnings
• DO NOT connect
your appliance to the
electricity supply until
all packing and transit
protectors have been
removed.
• Leave to stand for at
least 4 hours before
switching on to allow
compressor oil to settle if
transported horizontally.
• If you are discarding an
old refrigerator with a
lock or latch fitted to the
door, disable the lock/
latch, ensure that it is
left in a safe condition to
prevent the entrapment
of young children.
• This appliance must only
be used for its intended
purpose i.e the storing of
edible foodstuff.
• Do not dispose of the
appliance on a fire.
At BLOMBERG, the
care and protection of
our environment is an
ongoing commitment.
This appliance which is
among the latest range
introduced is particularly
environment friendly.
Your appliance contains
non CFC / HFC natural
substances in the cooling
system (Called R600a)
and in the insulation
(Called cyclopentane)
which are potentially
flammable if exposed
to fire. Therefore, take
care not to damage, the
cooling circuit / pipes
of the appliance in
transportation and in use.
In case of damage do
not expose the appliance
to fire or potential ignition
source and immediately
ventilate the room where
the appliance is situated.
• We suggest you contact
your local authority for
disposal information and
facilities available.
• To obtain the best
possible performance
and trouble free
operation from your
appliance it is very
important to carefully
read these instructions.
EN
5
• On delivery, check to
make sure that the
product is not damaged
and that all the parts and
accessories are in perfect
condition.
• Ensure that the
plug remains readily
accessible. Do not use
multiple adapter or
extension cable.
• Failure to observe
these instructions may
invalidate your right to
free service during the
guarantee period.
• Keep ventilation
openings, in the
appliance enclosure or
in the built-in structure,
clear of obstruction.
• Do not use mechanical
devices or other means
to accelerate the
defrosting process,
other than those
recommended by the
manufacturer.
• Do not damage the
refrigerant circuit.
• Do not use electrical
appliances inside
the food storage
compartments of
the appliance, unless
they are of the type
recommended by the
manufacturer.
• We suggest you keep
these instructions in
a safe place for easy
reference.
• This appliance can
be used by children
aged from 8 years and
above and persons
with reduced physical,
sensory or mental
capabilities or lack
of experience and
knowledge if they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and understand
the hazards involved.
• Children should be
supervised to ensure that
they do not play with the
appliance.
EN
6
Electrical
Requirements
Before you insert the plug
into the wall socket make
sure that the voltage and
the frequency shown on
the rating plate inside the
appliance corresponds to
your electricity supply.
Rating label is on the left
hand side of inner liner.
We recommend that this
appliance be connected
to the mains supply via a
suitable switched
and fused socket. The
appliance must be
positioned so that the plug
is accessible.
Should the mains lead
of the appliance become
damaged or should it need
replacing at any time,
it must be replaced by a
special purpose made
mains lead which can
only be obtained from a
BLOMBERG Authorised
Service Agent.
Warning! This
Appliance Must Be
Earthed
If the fitted moulded plug
is not suitable for your
socket, then the plug
should be cut off and an
appropriate plug fitted.
Destroy the old plug which
is cut off as a plug with
bared cord could cause
a shock hazard if inserted
into a socket elsewhere in
the house.
The moulded plug on this
appliance incorporates
a 13 A fuse. Should the
fuse need to be replaced
an ASTABEAB approved
BS 1362 fuse of the same
rating must be used. Do
not forget to refit the fuse
cover. In the event of losing
the fuse cover the plug
must not be used until a
replacement fuse cover
has been fitted. Colour
of the replacement fuse
cover must be the same
colour as that visible on
the pin face of the plug.
Fuse covers are available
from any good electrical
store.
EN
7
Important! Fitting A
Different Plug
As the colours of the
wires in the mains lead
of this appliance may
not correspond with
the coloured markings
identifying the terminals
in your plug proceed as
follows: (See diagram).
1. Connect the green-
yellow or green (Earth)
wire to the terminal in the
plug marked ‘E’ or with
the symbol or coloured
green and yellow or
green.
2. Connect the blue
(Neutral) wire to the
terminal in the plug
marked ‘N’ or coloured
black.
3. Connect the brown (Live)
wire to the terminal in
the plug marked ‘L’ or
coloured red.
4. With alternative plugs
a 13 A fuse must be
fitted either in the plug or
adaptor or in the main
fuse box. If in doubt
contact a qualified
electrician.
Energy Saving Tips
1. Ensure your appliance
is installed in a well
ventilated area.
2. Ensure the time between
buying chilled/frozen
food and placing them in
your appliance is kept at
minimum, particularly in
summer. We recommend
you use a cool bag or
a special carrier bag to
carry perishable food.
3. Do not leave the door (s)
of your appliance open
longer than necessary
and ensure they are
closed properly after
each opening.
4. Defrost frozen food in
the fridge, so that frozen
food acts as an ice pack
to assist cooling in fridge.
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP
EN
8
Compliance with
WEEE Directive and
Disposing of the Waste
Product:
This product complies
with EU WEEE
Directive (2012/19/
EU). This product
bears a
c l a s s i f i c a t i o n
symbol for waste
electrical and electronic
equipment (WEEE).This
product has been
manufactured with high
quality parts and materials
which can be reused and
are suitable for recycling.
Do not dispose of the
waste product with normal
domestic and other
wastes at the end of its
service life. Take it to the
collection center for the
recycling of electrical and
electronic equipment.
Please consult your local
authorities to learn about
these collection centers.
Compliance with RoHS
Directive:
The product you have
purchased complies
with EU RoHS Directive
(2011/65/EU). It does
not contain harmful and
prohibited materials
specified in the Directive.
Package information
Packaging materials of the
product are manufactured
from recyclable materials
in accordance with our
National Environment
Regulations. Do not
dispose of the packaging
materials together with the
domestic or other wastes.
Take them to the packaging
material collection points
designated by the local
authorities.
EN
9
3 Installation
B In case the information which are given
in the user manual are not taken into
account, manufacturer will not assume
any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1. Your refrigerator should be
unplugged.Before transportation of your
refrigerator, it should be emptied and
cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with adhesive
tape and secured against impacts.
Package should be bound with a thick
tape or sound ropes and the transportation
rules on the package should be strictly
observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the
refrigerator,
Check the following before you start to
use your refrigerator:
1. Attach 2 plastic wedges as
illustrated below. Plastic wedges are
intended to keep the distance which will
ensure the air circulation between your
refrigerator and the wall. (The picture is
drawn up as a representation and it is not
identical with your product.)
2. Clean the interior of the refrigerator
as recommended in the “Maintenance and
cleaning” section.
3. Connect the plug of the refrigerator
to the wall socket. When the fridge door is
opened, fridge internal lamp will turn on.
4. When the compressor starts to
operate, a sound will be heard. The liquid
and gases sealed within the refrigeration
system may also give rise to noise, even if
the compressor is not running and this is
quite normal.
5. Front edges of the refrigerator
may feel warm. This is normal. These
areas are designed to be warm to avoid
condensation.
Electrical connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily accessible
after installation.
• Electrical safety of your refrigerator shall be
guaranteed only if the earth system in your
house complies with standards.
Loading...