Blaupunkt Q3000 Installation Manual
Q3000 Smart Home Alarm
Kit Content and Installation Guide
Table of Contents
1. Introduction __________________________________________________________ 1
2. Installation ___________________________________________________________ 4
3. Troubleshooting & Factory Reset ________________________________________ 7
4. Specifications ________________________________________________________ 9
Information and illustrations are subject to change within this document. Blaupunkt
reserves the right to alter the specification and product design at anytime without
notice.
1
1. Introduction
This document includes information to help you install and maintain your Q3000 alarm
system and its accessory devices. For information about registration and system operation
using Blaupunkt Home Connect cloud server. Please refer to “Blaupunkt Home Connection
User Manual” which you can download from server home page
https://eu.bphomeconnect.com/
Kit Contents
Control Panel
The Control Panel is the hub of your alarm system. It must be powered on and connected to
internet at all times. When an alarm signal is transmitted from accessory devices, the Control
Panel will activate its built-in buzzer to raise alarm and report the event to the server, which in turn
sends notification to user via email or smartphone push notification.
The Control Panel is puposedly designed to resemble the appearnce of a speaker and blend in
your home environment.
Status LED (Green / Red): Green ON – Disarm Mode
Green Flash – Learning Mode
Red ON – Away Arm Mode
Red Flash – Home Arm Mode
Off – Walk Test Mode
Status LED (Amber / Red): Amber ON – System has fault
Amber Flash – AC failure
Red Flash – System alarming
Red ON – Alarm Memory
Off – Normal
Network LED (Amber ): Amber ON – Network Error
Off – Normal
Learn/Rest Button: Used for learning new device or resetting panel to default.
Battery Switch: Slide to ON to activate and charge built-in battery.
DC Jack: Connect the DC9V 1A adaptor supplied in the package to power up Control Panel
Ethernet Port: Connect to your router
Mode
LED
Status
LED
Network
LED
Learn/Reset
Button
Battery
Switch
DC Jack
Ethernet
Port
Loading...