REVERSE CAMERA
BC DH01
Operating and Installation Instructions
Installation Diagram
6M Video wire
1.5M Power wire
Control wire
Ground the wire through the exterior body of the vehicle and keep connection intact.
BC DH01
SPECIFICATION
Power Supply : DC12V±3V
•
Current Consumption : 50mA
•
Resolution : 600 TVL
•
Optical Format : 1/3”
•
Image Sensor : CMOS
•
Eective Pixels : 1080 x 720
•
Lens Angle : 170° (D), 120° (H) , 100° (V)
•
Electronic Shutter : 1/60
•
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages, to property or life, improper storage,
whatsoever arising out of or connected with the use or misuse of our products.
USA & CANADA : Product no intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased as-is.
No warranty, express or implied is provided in the U.S. and Canada.
Control wire
Camera input
Reversing detection
Reversing lights-
Reversing lights+
0.7M Conversion wire
Display Monitor/Car Radio
~ 1/100000 sec
•
White Balance : Auto
•
Humidity : up to 95%
•
Water Proof : Yes
•
Illumination Min. : 0.1 Lux
•
TV System : PAL/NTSC
•
Operation Temperature : -20°C ~ +70°C
•
Storage Temperature : -20°C ~ +70°C
•
DVD
Attention
•
•
•
Camera
Remove protective
film from camera
lens before use.
Take extra
precautions when
setting up the
connection near
petrol tank and wires.
Please connect
Red Wire with
reverse light.
1. Installation Locations
1.1 At tail light (with metal bracket)
1.2 At hatch handle (with metal bracket)
i.
Remove one side
of the reverse light
socket from its
housing then
remove the bulb
from its socket
ii.Connect the reverse
light power cable to
the camera, screwn
the housing & camera
back into position
with a screwdriver
1.3 On the car bumper
i.
Remove the
rotating mount
before installation.
Drill an access
hole for the
camera cables
Pictures are for illustration purpose only, see actual vehicle for accurate installation location.
ii.Mount the camera
onto the acces hole
& secure it in
position with 3M
tape/ screws
TROUBLESHOOTING
Problem
Display monitor / car radio does not show
reverse view when reversing
Display monitor / car radio does not show
reverse view even after correcting the view
setting
Reverse view does not show even after
restarting the display monitor/ car radio
Reverse view does not show even though
power supplies of the reverse light or the
rear car plate light is properly connected
i.
Use a screwdriver
to remove the
original hatch
handle
Solution
Examine if the viewing mode is set to correct
reverse view
Restart the display monitor / car radio
Examine if the power supplies of the reverse
light or the rear car plate light is properly
connected
Examine if the power supply cables of the
reverse light or the rear car plate light is
damaged. Repair/replace if the cables are
damaged
ii.Mount the camera
where the original
hatch handle used
to be
Blaupunkt India Private Limited
47, Atlanta Society, Nariman Point
Mumbai‐ 400 021. Maharashtra. India.
www.blaupunkt.com
Loading...