Operating instructions
ACR 3231
1
2
3
4
10 9
5678
3
Table of Contents
Important information.................. 10
Traffic safety .........................................10
Installation / Hook-up ............................ 10
Radio operation............................ 10
Select the frequency range ................... 10
Station search ....................................... 10
Manual station search........................... 10
Adjusting station search sensitivity ....... 10
Stereo - mono switch ............................ 10
Storing stations ..................................... 11
Storing the strongest stations
automatically ......................................... 11
Recalling stored stations....................... 11
Cassette tape operation .............. 11
Insert cassette tape............................... 11
Remove cassette tape .......................... 11
Fast forward .......................................... 11
Care of your audio equipment............... 12
Appendix....................................... 12
Technical data....................................... 12
8
Legend
1 On/off
Turn knob.
On
Off
Adjust volume:
Turn knob.
2 Cassette tape slot
3
Fast forward
Start/end fast forward: press button
gently.
- Eject cassette tape:
Press button firmly.
4 Display for
frequency range
frequency
memory bank
channel preset
5
Station selection
automatic or manual (“m” in display).
Switch over by pressing lo • m 6
6 lo • m
Io lit up in the display indicates normal
sensitivity for the station search function.
Io not lit up in the display indicates high
sensitivity for the station search function.
m lit up indicates manual station fine
tuning.
Added feature:
Switch over from stereo to mono:
Press lo • m for longer than 2 seconds.
7 M•L
AM and long-wave (LW) switch.
Press this button repeatedly if necessary.
9 FM•T (frequency modulation)
Switch for the FM memory banks I, II,
III and “T” (Travelstore) - for storing and
recalling the six nearest, strongest station signals.
Store “T”:
Press FM•T until the search begins in
the display.
Recall “T”:
Press FM•T until T appears in the display. Then press the station button quickly and repeatedly if necessary.
: TONE
Adjust tone.
more bass
more treble
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLAND
SVENSKA
stereo
manual fine
tuning
sensitivity
(station search)
8 1- 5
For storing and recalling radio stations
ESPAGÑOL
PORTUGUES
9
Important information
Radio operation
Traffic safety
As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you. Should the
traffic situation become particularly demanding, we would advise you not to use the
radio. Please keep in mind that you travel a
distance of 14 m per second at a speed of
only 50 km/h. When adjusting the volume,
make sure that you are still able to hear
sounds coming from outside of the vehicle,
so that you are always able to react to warning signals.
Installation / Hook-up
If you would like to install your new car radio
yourself or add other audio components to
the existing ones, then please read the enclosed instructions on installation and hook-up
carefully.
Do not ground the loudspeaker outputs!
Use only Blaupunkt-certified accessories and
spare parts.
Select the frequency range
You can choose between the frequency ranges:
FM 87.5 – 108 MHz,
AM 531 – 1602 kHz and
LW 153 – 279 kHz.
• Switch on the desired frequency range
by pressing either the button FM•T or
M•L.
Switching between AM and LW:
• Press M•L.
Station search
m should not be lit up in the display. If it is,
switch it off by pressing lo • m
•
If you hold the button pressed, the search
function will forward quickly.
press right or left.
The car radio will automatically tune
into the next station.
Manual station search
m (manual) must be lit up in the display. If it
is not, switch it on by pressing lo • m.
•
press right or left quickly.
The frequency will move up or down in
short intervals.
If you hold the button pressed, then the
frequencies will move up or down more
quickly.
Adjusting station search sensitivity
You can adjust the sensitivity of the automatic station search.
• Press lo • m.
When “Io” is visible in the display, then
only those stations with relatively strong
signals will be picked up (low sensitivity).
When “Io” is not visible in the display,
then stations with weaker signals will
also be picked up (high sensitivity).
Stereo - mono switch
If you would like to switch between stereo
and mono reception:
• Press lo • m for approximately 2 se-
conds.
During stereo reception the stereo sym-
will light up in the display.
bol
Each time the car radio is switched on, the
reception will automatically be set to stereo.
The radio will automatically switch to mono
when the reception conditions are poor.
10
Cassette tape operation
Storing stations
For each memory bank (I, II, III, T) you can
store up to five stations using the button 1-5.
• For FM select the memory bank by
pressing FM•T.
You can store 5 stations each for AM and LW
frequencies.
• Select the button 1-5 to store the new
station and press it.
• Press
want to store (automatically or manually).
• Press the button 1-5 and hold it. First
the station will be muted and then become audible again.
The station has been stored in the memory
bank.
The corresponding memory bank and the
button preset will appear in the display.
Note:
If you tune into a station which has already
been stored, then the corresponding button
preset and the memory bank will flash in the
display for approximately 5 seconds.
to tune in the station you
Storing the strongest stations
automatically
(Travelstore)
In your reception area you can automatically
store the five nearest FM stations, sorted
according to their frequencies.
This feature is particularly useful when you
are travelling.
• Press FM•T for at least 2 seconds.
The radio will search for the nearest FM
stations and store them in the memory
bank “T” (Travelstore). When the process has been completed, the first station will be set.
If you wish, you can also store stations in the
Travelstore memory bank manually.
Recalling stored stations
You can recall the stored stations by pressing
the corresponding buttons.
• Select the memory bank.
Press FM•T until I, II, III or T appears in
the display.
• Select the station by pressing the button 1-5, press repeatedly if necessary.
Insert cassette tape
• Switch the car radio on.
• Insert a cassette tape with the empty
reel facing forward and the open side
facing to the left.
Tape playback will begin.
When the tape has run to the end, the car
radio will switch on automatically.
Remove cassette tape
• Press firmly.
The cassette will be ejected.
Fast forward
To begin and end fst forwarding,
• Press
gently.
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLAND
SVENSKA
ESPAGÑOL
11
PORTUGUES
Appendix
Care of your audio equipment
We recommend that you use only C60/C90
cassette tapes in your car radio. Protect your
cassettes from dirt, dust and temperatures
exceeding 50 °C. During cold weather, allow
cold cassettes to warm up somewhat before
playing them in order to avoid uneven tape
transport. Operating problems and sound
distortions may occur after approximately
100 hours of playing time and are caused by
dust particles which adhere to the rubber
roller pad and the tape head. Use a cleaner
cassette to remove normal dirt build-up. If
more dirt than usual has accumulated, use a
cotton bud dipped in rubbing alcohol to clean
these parts. Never use any hard tools.
Technical data
Amplifier:
Output power: 2 x 6.5 W RMS power
according to DIN 45324/
3.1 at 4 Ω
FM:
Sensitivity: 1.3 µV at 26 dB
S/N ratio
Response: 35 - 15 000 Hz (-3 dB)
Cassette:
Response: 40 - 14 000 Hz (-3 dB)
12
Information subject to change!
Illustrationen • Illustrations • Ilustraciones • Illustrazioni • Illustrationer • Afbeeldingen • Ilustraçoes
ILLUSTRATIONEN • ILLUSTRATIONS • ILUSTRACIONES • ILLUSTRAZIONI • ILLUSTRATIONER • AFBEELDINGEN
8 601 310 742
182
53
165
5A
150
58,5
50
5,2-6,3
L
R
L
L
F
R
F
R
L
R
R
R
LR
LF
RF
RR
188
8 908 603 223
Amplifier
)
V
+
)
2
–
1
A
N
(
D
N
O
N
R
I
+
N
T
E
U
I
.
E
W
O
P
+12V
5A
O
N
T
C
R
N
G
I
G
(
A
AC
+12V
+12V
+12V
5A
L
L
F
R
F
R
L
R
R
R
Equalizer
+12V
Fader
+12V
8 601 910 002
Kl. 30
+12V
1
2
V
2
1
2
1
Blaupunkt-Werke GmbH
Bosch Telecom
5/93 MC/VKD-Hi 3 D93 147 018 PM
8
Loading...