
Division of The Legacy Companies
MODELS BB914, BB2016, BB1224
BURNISHER
1228 Capitol Dr.
Addison, IL 60101
Phone (630) 532-5021
Fax (630) 532-5020
www.blakesleeinc.com
service@blakesleeinc.com
1149 Bellamy Road North Unit 19
Scarborough, Ontario Canada M1H1H7
Phone (416) 751-2625
Fax (416) 751-8539

In no case can this warranty exceed eighteen (18) months from the date of shipment from our
plant at Addison, Illinois
Tub lining is guaranteed for 3 years from date of installation. Service labor is not included in
this extended warranty.
Your new Blakeslee product has been carefully manufactured and tested.
Occasionally you may experience a problem with your new machine and if it is due to a defective part
or workmanship, we will be more than happy to repair it at no charge to you as stated in our
guarantee.
Like any other piece of equipment that is being heavily used, the machine will require periodic
cleaning and maintenance. This cleaning and maintenance is the owner’s responsibility and is not
covered under out warranty. The compound recirculating tank must be emptied and replenished
every eight hours of use to prevent the waste material from damaging the pump seal. Compound and
water must be in the tank whenever the machine is in operation to lubricate the seal of the pump.
Limited Warranty
Your new Blakeslee burnisher is warranted for one year from date of installation shown
above against defective materials and workmanship. If any defects are found within the
warranty period; parts, and labor involved with their replacement will be covered free of
charge. Service must be performed by a Blakeslee authorized service agency. All labor to
be performed during regular working hours. Overtime premium will be charged to the
customer. All warranty parts are shipped by surface transportation. If other means of
transportation is requested the customer is required to pay the premium. This warranty
does not apply to damages resulting from errors in installation on the part of other
contractors, nor does it apply to machines which have been subject to accident, misuse, or
abuse. It is understood that Blakeslee’s warranty obligation with respect to machines
located outside of the United States or located in the state of Alaska is limited to the
furnishing of replacement parts only. In the state of Hawaii, repair labor is provided free of
charge; travel time and expenses paid by the customer. On the island of Oahu, repair labor,
travel time and expenses are provided free of charge. This is the entire and only warranty
of Blakeslee. We neither assume nor authorize anyone else to assume for us any other
obligation or liability in connection with Blakeslee Machines.

General
Description
Specifications
Unpacking the Unit
Installation
General
Preparing the compound
Operation
Draining and cleaning the Unit
4-1.
4-2.
4-3.
4-4.
4-5.
4-6.
4-7.
4-8.
4-9.
4-10.
4-11.
4-12.
4-13.
Daily
Monthly
Bi-Monthly
Replacing Tub Drain Screen
Media Replacement
Motor Belt Replacement & Adjustment
Converting “V” Belt Drive to “O” Ring Drive
Eccentric Bearing Replacement
Media Tub Replacement
Compound Pump
Drive Motor Rotation
Wiring Diagrams and Schematics
Troubleshooting
9
9
9
9
10
10
10
11
12
13
13
13
14

FIGURE 5-1. MODEL BB914 MAIN ASSEMBLY
FRAME ASSY, w/electric box and casters, epoxy painted
TUB WELDMENT, Complete w/urethane lining and epoxy paint
SPRING, Painted, set of 4
CASTER, w/brake, w/o bracket
CASTER w/brake, w/ bracket
BRACKET, For casters, unpainted
ABS GUARD, Left side switch opening, w/double coated tape and rivets
ABS GUARD, Right side w/tape and rivets
ABS GUARD Front and/or rear, w/o fasteners
FASTNER KIT, Quick disconnect, for front and rear guards, 3 piece Assy.
TOGGLE SWITCH (Older machines)
COMPOUND PUMP 110V 60 CYCLE
COMPOUND PUMP 230V 50/60 CYCLE
HOSE ASSY, Compound supply, ¼”-28 x 1 ½” long
DRAIN HOSE ASSY, Complete with 5/8” hose
FLANGED BEARING ASSY, Painted
ECCENTRIC WEIGHT ASSY, Consists of:
• SCREW, Socket head, ¼”-28 x 1 ½: long
PULLEY, Driven, double groove, serial no. 77-001 and up
PULLEY, Driven, single groove, serial no. 77-000 and below
PULLEY, Drive, double groove, serial no. 77-001 and up
PULLEY, Drive, single groove, serial no. 77-000 and below
BELT, “O”-ring type, serial no. 77-001 and up
BELT, “V” type, serial no. 77-000 and below
MOTOR, ½ hp, 3450 rpm, 110/220 V, 1 phase, 60 cycle
MOTOR, 1/3 hp, 1725 rpm, 110/220 V, 1 phase, 60 cycle
MOTOR, ¾ hp, 3450 rpm, 110/220 V, 1 phase, 60 cycle
CABLE, Electrical w/connectors, motor to switch
CABLE, Electrical, w/connectors power supply
MEDIA RETURN TOP DECK, w/decal and chrome fastener
TUB COVER, Can be used only with media return top deck

FIGURE 5-2. MODEL BB2016 MAIN ASSEMBLY
FRAME ASSY, w/electric box and casters, epoxy painted
TUB WELDMENT, Complete w/urethane lining and epoxy paint
SPRING, Painted, set of 4
CASTER, w/brake, w/o bracket
CASTER w/brake, w/ bracket
BRACKET, For casters, unpainted
COVER, Left side w/switch opening, included double sided tape and screws
COVER, Right side includes double sided tape and screws
FASTNER KIT, Quick disconnect, for front and rear guards, 3 piece Assy.
TOGGLE SWITCH (Older machines)
COMPOUND PUMP 110V 60 CYCLE
COMPOUND PUMP 230V 50/60 CYCLE
HOSE ASSY, Compound supply, ¼”-28 x 1 ½” long
DRAIN HOSE ASSY, Consists of the following parts
• ADAPTER, Hose connector to aerator
• HOSE CONNECTOR, ½” male
• POLYVINYL TUBING, 5/8” x ½” x 6 ½” long
BELT, “O”-ring type, serial no. 77-001 and up
BELT, “V” type, serial no. 77-000 and below
PULLEY, Driven, double groove, serial no.20S-77-001 and up
PULLEY, Driven, single groove, serial no. 20S-77-000 and below
PULLEY, Drive, double groove, serial no. 20S-77-001 and up
PULLEY, Drive, single groove, serial no. 20S-77-000 and below
MOTOR, 1 hp, 3450 rpm, 110/220 V, 1 phase, 60 cycle
MOTOR, ¾ hp, 1725 rpm, 110/220 V, 1 phase, 60 cycle
CABLE, Electrical w/connectors, motor to switch
CABLE, Electrical, w/connectors power supply
RELAY, Timing, (late production models) 110V 60cycle
RELAY, Timing, (late production models) 220V 50cycle (export only)
SOCKET, Timing, (late production models)
TIE WRAP, Timing, (late production models)
HOSE KIT, Compound tank drain, includes connector and spring clip
ECCENTRIC SHAFT ASSY (See fig. 5-4 for details)

FIGURE 5-5 MODEL BB1224 MAIN ASSEMBLY
TUB WELDMENT, Complete w/urethane lining and epoxy paint
ECCENTRIC SHAFT ASSY (See fig. 5-4 for details)
COMPOUND PUMP 110V 60 CYCLE
COMPOUND PUMP 230V 50/60 CYCLE
HOSE ASSY, Compound supply w/connectors
DRAIN HOSE ASSY, Consists of the following parts
• ADAPTER, Hose connector to aerator
• HOSE CONNECTOR, ½” male
• POLYVINYL TUBING, 5/8” x ½” x 6 ½” long
MOTOR, 1.5 hp, 3450 rpm, 110/220 V, 1 phase, 60 cycle
CABLE, Electrical, w/connectors power supply
TOGGLE SWITCH (Older machines)
BELT, “O”-ring type, serial no. 77-001 and up
PULLEY, Driven, double groove
PULLEY, Drive, double groove
FASTNER KIT, Quick disconnect, for front and rear guards, 3 piece Assy.
SCREW, Rd. hd, s/s, 10-32 x 1-1/2: lg.
SCREW, Cap, hex hd, 5/16-18X1” lg
LOCK WASHER, Split, 5/16”
SCREW, Self tapping washer hd, Rollex, 6/32 x ½” lg.
TUBING, Polyvinyl, 5/8” OD X ½” ID X 30” lg>
NAMEPLATE, Blakeslee (horizontal)
SOCKET, Timing, (late production models)

FIGURE 5-5 MODEL BB1224 MAIN ASSEMBLY (Continued)
RELAY, Timing, (late production models) 110V 60cycle
RELAY, Timing, (late production models) 220V 50cycle (export only)
TIE WRAP, Timing, (late production models)
NAPEPLATE, Blakeslee (vertical)

Blakeslee Authorized Parts & service Distributors and Preferred Service Agents are the focal point for service and are responsible for all warranty/repair
work and for maintaining a complete stock of replacement parts.
They have factory-trained servicemen and are kept informed by the factory on the latest servicing procedures.
To receive service and/or parts, call the Blakeslee Distributor nearest you. If you happen to be in an area not covered by a distributor, phone the Blakeslee
Service Department in Chicago at 708-656-0660 for the name and location of one of over 300 strategically-located Blakeslee Authorized Service Agencies,
which is nearest you.
Jones McLeod Appliance Co.
Chandler’s Parts & Service
Acme American Repairs Inc.
Duffys Rest. Equip. Service
Electric Motor Repair CO.
Sauquoit (Utica), NY 13456
5080 Highlands Pkwy S. A150
Authorized Appliance Service
Needham (Boston), MA 02194
Commercial Kitchen Repair
Akron Restaurant Equipment
Acme Pacific Repairs, Inc.
E & G Appliance Service Co.
Commercial Parts & Service
Barker’s Food Machinery Ser.
Midwest Food Equipment Serv.
Eichenauer Food Equipment
Electrical Appliance Repair
Chapman Appliance Service
2857 Louisiana Ave. North
Krueger Electric Service Inc.
Camp Service & Parts Inc.
Kaemmerlen Parts & Service
American Kitchen Mach. Corp.
Burney’s Commercial Service
1833-41 N. Cameron Street
Authorized Factory Service
Commercial Appliance Service
GCS Whaley Foodservice Repairs
3373 Northwest 168th Street

Great West Comm. Kit. Rep.
Buddens Appliance Service
Blanchfield Comm. Kit. Serv.
Electro Ref. Service Ent.
5664 Burleigh Cresc. S.E.
770 Industrial Ave., Unit 13
L.D.I. Technical Services
Commercial Kitchen Equip.
Kitchen Equipment Services
900 Pierre Bertrand, #220
Sure-Fix Food Equip. Serv.
St. Catharines’s ON L2R 3X8
OFS Restaurant Appl. Serv.
Electrical & Refrigeration Serv.
Northcote Sales & Serv. Co.
Medicine Hat Refrigeration
52 Highway 17, P.O. Box 371
Sault Ste. Marie, ON P6A 2R1
Satellite Mechanical Ltd.
Tisdale Plumbing & Heating
Kitchenworks Rest. Equip. Sup
R.R. #5, 823974 Massie Rd.
South Porcupine, ON P0N 1H0
Yukon Appliance Sales & Serv.
Barbers Rest. Eq. & Repairs
Fort St. John, BC V1J 5Z4
R.G. Henderson & Son Ltd.
J.I.K.S. Ind. Kitchen Serv.
27 McCurdy Drive, P.O. Box 83
R.G. Henderson & Son Ltd.
Jemco Food Equip. Service
Action Rest. & Serv. Equip.
Harry Rhyno Refrigeration
Pointe au Pic, QC G5M 1C9
Riviere de Loup, QC G5R 2G8
Triumph Food Equip. Service
Niagara Falls, ON L2E 6S4
7 St. N.E. #322 Puerto Nuevo