Black & Decker Je65 Instruction Manual [ar]

2 Speed Juice Extractor

First Use Safety Recommendation

Please read through this booklet for safe and efficient use of the appliance. We urge you to read the "Hint's" section and also follow all detailed instructions even if you are familiar with using this appliance.

Keep this guide handy for future reference.

English Page 02 Farsi Page 10 Arabic Page 15

JE65

English

IMPORTANT SAFEGUARDS

While using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury to persons, basic safety precautions should be followed, including the following:

• Read all instructions carefully, even if you are familiar with the appliance.

• To protect against the risk of electric shock, DO NOT IMMERSE the appliance, cord set or plug in water or other liquids.

• To clean, wipe the exterior with a damp cloth.

• Close supervision is necessary when any appliance is used near children. Never leave an appliance unattended when in use.

• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

• Switch off and remove the plug from the power outlet when not in use before assembling or disassembling parts, cleaning or carrying out any maintenance of assembling or disassembling parts, cleaning out any maintenance of the appliance. Never pull the cord while unplugging out from power outlet.

• Do not operate any appliance with a damaged in any manner. Return the complete appliance to your nearest authorized service facility for examination, electrical repair, mechanical repair or adjustments to avoid any hazard.

• The use of attachments or accessories not recommended or sold by this appliance manufacturer may result in fire, electric shock or personal injury.

• Do not let the cord hang over the edge of a table, counter, or touch hot surfaces.

• Avoid touching hot surfaces, use handles and knobs.

• Do not operate or place any part of this appliance on or near any hot surfaces (such as gas or electric burner or in a heated oven).

• Do not abuse the cord. Never carry the appliance by the cord or yank it to disconnect it from the outlet; instead, grasp the plug and pull to disconnect.

• When using an extension cord with your appliance, make sure the extension cord is correctly wired, and rated for its use.

• This product is intended for household use only.

• Do not attempt to repair the appliance yourself; instead, take it to your Black & Decker-owned or Authorized Service Centre for repair.

SAVE THESE INSTRUCTIONS

-2-

English

Parts Identification

1. Motor housing

2. Speed selector

3. Pulp container

4. Juice container

5. Cover

6. Tray

7. Latch - right

8. Latch – left

9. Spout

10. Cord storage

11. Pusher

12. Sieve

13. Sieve housing

14. Sieve adaptor

1312 14

Fig. A

Fig. B

-3-

English

FEATURES

• 450W

• 2 speed operation

• 0.7 litre jug

• Removable pulp container

• Stainless steel sieve

• Removable tray

• Cord storage

Fig A - Before first use:

Before using your Juicer for the first time, make sure it is disconnected from the electrical supply, then remove all packaging from the sieve & pulp container.

To remove the packaging, open the righthand latch (7), then the left-hand latch (8).

Lift the cover (5) & tray (6) from the appliance. Remove the packing from the sieve (12) and

from the pulp container (3). Pull the sieve housing & sieve from the Juicer. All parts must be cleaned as recommended in

the section “How to take care of your Juicer”. The motor housing must only be cleaned with

a damp cloth, and dried thoroughly before use.

Inspect the sieve for signs of damage. Note: Do not use the appliance if the rotating

sieve is damaged.

Fig B - How to assemble your Juice Extractor

Place the sieve housing (13) on the motor housing (1), then place the sieve (12) into the sieve housing, pressing it onto the sieve adaptor (14).

Place the cover (5) on top of the seive housing. Fit the hooks of the latches over the recesses in the cover, then push the righthand latch (7) and the left-hand latch (8) down ensuring they lock in place.

Fit the tray (6) onto the cover (5). This can be fitted as a cover for storage, or inverted to act as a tray where ingredients can be temporarily stored before juicing.

Place a suitable container under the spout (9).

How to use your Juicer

This appliance is designed to extract juice from fruits & vegetables.

Do not use this appliance for any other purpose.

For indoor domestic use only. Prepare material to be processed by washing

thoroughly and peeling as required. Remove all pips and large seeds. Cut large fruits or vegetables into small pieces which will fit the inlet chute.

Smaller items of food can be placed on the tray ready to be directed into the chute with the pusher (11).

Make sure the speed selector (2) is in the ‘’0’’ (OFF) position, then plug the cord-set into a power outlet.

Note: Make sure that the voltage shown on the underside of the motor housing corresponds with the local supply voltage.

Rotate the speed selector to position 1 or 11 as required. Low speed should be used for soft fruits and high speed for harder fruits.

Check the jug and pulp collector are in place, and feed the ingredients into the inlet chute. The pusher (11) can be used to gently guide the ingredients down the inlet slot. Do not overload the machine. Too much pressure may cause material to jam the inlet chute.

This appliance should not be operated continuously for more than 2 minutes at a time. After 2 minutes use, the appliance should be allowed to cool at least one minute before using it again.

If a blockage occurs, NEVER USE FINGERS OR ANY OBJECT OTHER THAN THE PUSHER TO CLEAR THE INLET CHUTE.

If the food cannot be dislodged, turn the speed selector to the “0” position (OFF) and

UNPLUG the POWER CORD FROM OUTLET.

Remove the cover as described in “Before first use” and clear the blockage. Replace the cover, re-connect the Juicer to the electrical supply & resume juicing.

When juicing is completed, the switch should be returned to the off (0) position, and allow the motor to come to a stop. The jug should be left in place until the juice stops flowing from the spout.

UNPLUG POWER CORD FROM THE OUTLET, and disassemble the juice extractor.

Empty the pulp from the collector and clean all parts as soon as possible after you have finished processing.

-4-

English

Emptying the pulp container / strainer

If the pulp container (3) becomes full before all of the ingredients are used, rotate the speed selector (2) to the ‘’0’’ (OFF) position and unplug the Juicer.

Take hold of the pulp container pull it away from the motor housing and discard the pulp. The pulp can be discarded and the strainer returned to its position in the motor housing.

Reconnect the unit to the power supply & recommence juicing.

How to take care of your Juicer

The Juicer must be cleaned thoroughly after each use.

Make sure the appliance is switched ‘OFF’ and unplug the unit from the power supply before cleaning.

NOTE: NEVER IMMERSE the motor housing (1) IN WATER OR ANY OTHER LIQUID.

To clean motor housing, wipe clean with a damp cloth. Allow to dry thoroughly before re-using or storing. The removable parts of the juice extractor assembly should be washed promptly after each use with a mild detergent in warm water. These parts are not dishwasher safe and must be hand washed.

Use a brush to scrub pulp residue from the cutting teeth and strainer holes of the sieve (12).

After washing, rinse and allow all parts to dry thoroughly before re-assembly and storage.

Never use a metal brush to clean the sieve.

Take care when handling the sieve as the blades are sharp.

Warning:

Do not use the appliance if the rotating sieve is damaged.

Protecting the environment

Separate collection. This product must not be disposed of with normal household waste.

Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not dispose it off with other household waste. Make this product available for separate collection.

Separate collection of used products and

packaging allows materials to be recycled and used again. Use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials.

Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or by the retailer when you purchase a new product.

Black & Decker provides a facility for the collection and recycling of Black & Decker products once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual. A list of authorised Black & Decker repair agents and full details of our after-sales service and contact are available on the Internet at: www.2helpU.com

-5-

+ 11 hidden pages