Page 1
®
ENGLISH
Dustbuster
Electrical connection (UK user)
Before using your appliance, ensure the voltage on the charger
corresponds with your mains supply. Never use a light socket!
Do not replace the charger with a 13 amp plug or any other type
of charger. If in doubt, seek advice from your nearest electricity
board or Black & Decker service centre.
Safety points
• The charger is for indoor use only.
• Keep motor draught away from eyes and face during use.
• Keep children and pets at a safe distance away when in use.
• Never use to pick up flammable or combustible liquids.
Product features (Fig. A)
1. On/off slide switch
A
2. Release button
3. Dust bowl
4. Wall mountable charging base
4a. Deluxe base with accessories (if supplied)
5. Charger
Installation instructions (Fig. B)
Fix the charging base vertically to the wall using the
B
screws and plugs supplied, as illustrated,and within reach
of a power socket. Plug in and place the product into
position. The charging base can also be fixed, or simply
placed, in a convenient horizontal position.
Note: Avoid damaging the cable while fixing the holder to
the wall or when removing or replacing the product from
the holder.
Recharging
From new, the rechargeable cells of the product need a minimum
charge time of 16 hours to ensure full power. We suggest you
fully discharge the product when it is used for the first time as this
will help the cells recharge faster. The switch must be in the off
position; the product will not charge if it is in any other
position. Whilst charging, the charger will get warm; this is
perfectly normal and safe, and your product can remain on
charge indefinitely without damage or danger. It is not possible to
“overcharge” the battery cells with the charger provided.
How to use (Figs. C & D)
To start, slide the on/off switch forward (i.e. 0 = off, I = on).
To stop, slide the switch back.
C
2
Page 2
Burst of power
Where applicable, your product has two power settings;
‘I’ for normal power and ‘MAX’ for a burst of additional
power to do tougher jobs, activated by sliding the switch
forward as far as it will go.
Always return the product to its charging base immediately
D
after use so that it will be ready and fully charged for the
next job. The switch must be in the off position; the
product will not charge if it is in any other position. Ensure
that the product is fully engaged on the charging base.
Cleaning the product (Fig. E - H)
Warning! Never use the product without its filter.
Note: The filter bag is re-usable; do not confuse it with a
disposable dust bag and do not throw it away when the
product is emptied. When the filter becomes worn or
damaged, you can obtain a replacement from your local
Black & Decker service centre.
• To clean the filter bag, first remove the dust bowl by
E
pressing the release button and then take out the filter
bag using the plastic grip. Shake or brush any loose
dust off the filter bag. Wash it regularly using warm,
soapy water and ensure it is completely dry before
replacement. The cleaner the filter bag, the better the
product will perform. It is very important that the filter
bag is correctly in position before use.
• To clean the dust bowl, remove the filter bag, empty
F
G
H
the bowl and wash if necessary.
Important! Maximum dust collection will only be obtained
with a clean filter bag and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
Never immerse the product in water. It is only safe to
immerse the detached dust bowl section in water.
A damp cloth and soapy water should be used to clean
the exterior of the motor section. Always ensure the
product is completely dry before re-use or storing.
Economic usage
• Your product is very economical to charge. Whilst it is charging it
uses less than half the amount of electricity used by a light bulb.
• When fully charged, the average effective usage times are
between 8-11 minutes.
• It may take several chargings before these times can
be achieved.
Other information
If the product does not work, check the following:
• The charger was correctly plugged in for recharge.
• The lead is not damaged and is correctly attached to the base.
• The mains power is working.
If all are satisfactory and the product still does not work, refer to
the guarantee or service and repair section of this leaflet.
3
Page 3
Accessories (supplied with HC411/421/431)
Accessories, a crevice tool and upholstery brush, fit the ‘nose’ of
the Dustbuster and may be stored in the base of the product.
These may be purchased from any Black & Decker service centre.
Rechargeable batteries and the environment
Black & Decker cordless products use nickel cadmium
(NiCad) batteries or battery packs which can be charged
many times to give long life and repeatedly full power.
This symbol indicates the NiCad batteries contained
within this unit must be disposed of properly and not
discarded in everyday household waste which may be
Cd
disposed of in an incinerator or landfill site. NiCad
batteries can be harmful to the environment and can
explode when exposed to fire. Do not incinerate.
Therefore, when your product or battery pack needs
replacing, think of the protection of our environment.
Black & Decker recommends the following:
• Discharge batteries completely by running the unit
until the energy is completely discharged and then
remove from the product.
• Take the battery pack to a Black & Decker service
centre, your local dealer or your local recycling
station. If necessary, contact your local council for
disposal information. The collected batteries will be
disposed of properly and/or used for recycling
purposes whilst protecting the environment.
Note: You as a customer are responsible for proper
disposal or recycling of the battery pack.
To remove the battery pack for disposal, prise open the
J
cover on the underneath of the unit using a screwdriver
or similar. Remove the dust bowl and strike the front of
the product firmly on a suitable surface to dislodge the
battery pack. It may take a number of strikes before the
battery pack falls out (be careful where it falls). Once
removed, the battery pack cannot be refitted.
Black & Decker after sales service
All Black & Decker products are scrupulously tested before
leaving the factory. However, in the case of your product being
defective, please take it to your nearest Black & Decker service
centre. All household products, as well as the fittings we
recommend, are guaranteed for 24 months parts and labour.
2 year guarantee
If a Black & Decker product becomes defective due to faulty
materials or workmanship during the guarantee period following
purchase, we guarantee to repair it free of charge, provided that:
• The product has not been misused.
• Repairs have not been attempted by persons other than our
own service staff or the staff or authorised repairers.
• Proof of purchase date is produced.
This guarantee is offered as an extra benefit and is additional to
consumers’ statutory rights.
4
Page 4
United Kingdom Black & Decker Tel: 01753 511234
210 Bath Road, Slough Tlx: 848317 BAND MH
Berkshire SL1 3YD Fax: 01753 551155
NB: These pictures show a loop handle unit, however, some units
have a stick handle.
EC Declaration of Conformity
We declare that units: HC410, HC4105,
HC411, HC420, HC421, HC4305, HC431
conform to 89/392/EEC, 89/336/EEC,
EN55014, EN55104, 73/23/EEC, EN60335
A weighted sound pressure 80dB (A)
A weighted sound power 93dB (A)
Hand/arm weighted vibration <2.5m/s
2
Brian Cooke
Spennymoor, County Durham DL16 6JG, United Kingdom
Director of Engineering
Part no: 796777-20 10/95
5
Loading...