Black Box RMK19WX User Manual

DECEMBER 1999

RMK19WX

You can use this Rackmount Kit to mount Unit A or Unit B of a ServSwitch TM Wizard Multimedia KVM Extender

(our product code ACU1600A) in 1 U of vertical space in a 19" rack. Each of these Kits consists of a front­paneled rack sHelf and a pair of countersunk screws. To use this Kit to mount an Extender Unit, take these steps,
referring to Figure 1 on the other side of this page:

1. Place the Extender Unit on the Kit shelf so that the RJ-45 jack and auxiliary LEDs on its side are facing
forward and are aligned with the cutouts in the shelf's front panel. In this position, the two screwholes on

the bottom of the Unit should be lined up with the matching holes on the bottom of the shelf.

2. Screw the two screws included with the Kit through the holes in the shelf, into the bottom of the Unit.

3. Once you've attached the Unit to the shelf, match the holes at the ends of the shelf's front panel to an

appropriate set of matching holes on your equipment rack. Screw the Unit assembly to the rack using your
own screws, bolts, cage nuts, etc. (not included).

Figure 1. Rackrnounting an Extender Unit (Uni1: A shown).

@Copyright 1999. Black Box Corporation. All rights reserved.

CUSTOMER

SUPPORT

INFORMATION

RI AC:K BOX and the . lolro are registered trademarks. and SeivSwioch and SeivSwitch Wizard are trademarks, of Black Box Corporation.

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax [phone]
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com . E-mail: [e-mail]