Bissell Crosswave Cordless 2551 User Manual

QUICK START GUIDE

CROSSWAVE® CORDLESS

2551 SERIES

Quick Start Usage Instructions

31

Small Area Cleaning

For small area cleaning (less than 350 sq ft), fill the
Clean Water Tank with warm tap water to the first water
fill line. Then add formula to the first formula fill line.

RUG BUTTON

click

First, insert the handle
at the top of the body
of the machine until
you hear a “click”.

4

On the back of the machine,
align Clean Water Tank with
the grooves and slide tank into
place until you hear a “click”.

2

4h

Place your CrossWave
Cordless onto the 3-in-1
Docking Station to charge.
For maximum run time,
charge unit for 4 hours
prior to use.

5 6

HARD FLOOR
BUTTON

Turn machine ON by selecting the type of
floor you will be cleaning. For hard floors,
choose the HARD FLOOR button and for area
rugs push the RUG button.

WARNING Refer to the enclosed user guide

for complete instructions and important safety notices.

Large Area Cleaning

For large area cleaning (up to 700 sq ft), fill the Clean
Water Tank with warm tap water to the second water
fill line. Then add formula until you get to the second
formula fill line. Screw the cap back onto the Clean
Water Tank.

Each time you use the product, hold
the solution trigger for 10 seconds
to prime the system with cleaning
solution before you begin cleaning.
When you hold the trigger, LED
lights will illuminate.

When solution is flowing, you will see
bubbles forming at the edges of the
brush roll window.

You are ready to start cleaning with
your BISSELL CrossWave Cordless!

161-6770 10/18 RevB

QUICK START GUIDE

Getting the Best Clean from Your CrossWave® Cordless

For further instructions

reference the User Guide or visit

www.BISSELL.com

For everyday Cleaning:

HARD FLOORS & RUGS

Choose the setting that matches the floor type you
will be cleaning. Prime the system first by holding the
solution spray trigger for 10 seconds. When you’re
ready to clean, hold the trigger on both the forward and
backward pass for great cleaning results.

10 Seconds

HARD FLOOR

RUG

Dirty Machine?

EASY CLEANUP

For the best results, flush the unit by using the 3-in-1 Docking Station and holding down the Clean Out Cycle button
on the carry handle. Then, rinse the Dirty Water Tank, Strainer, Brush Roll, and Brush Chamber. After allowing your
machine and components to dry completely, reassemble everything, making sure the machine’s brush window is
securely in place before using your machine next time.

1

Clean Up

15s

2

Dry

Reassemble

3

Tips & Tricks

» On hard floors, there is no need to

vacuum before using CrossWave®
Cordless. This machine vacuums and
washes at the same time.

» Be sure to charge your machine fully

before using for the first time.

» To dry floors faster, release the

trigger and run the machine over the
floor without dispensing solution.

» When cleaning area rugs, remove

any excessive mud from your area
rug prior to using your CrossWave
Cordless.

» When cleaning excessively dirty

or muddy hard floors, or if the
Brush Roll looks dirty, use the 3-in-1
Docking Station to rinse the Brush
Roll before cleaning your area rugs.

» For overly challenging and stuck-

on messes on hard floors, activate
the RUG mode and hold your
CrossWave® Cordless over the mess.
Using short passes while holding the
trigger allows the multi-surface brush
to go to work.