Bionaire BSF16 User Manual
STAND fan
MODEL BSF16
Read instructions before operating. Retain for future reference.
Instruction Leaflet
INFO-LINE
If after having read this leaflet, you have any questions
or comments on your fan,
call1-800-788-5350 in North America.
☎
FAN SAFETY
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1) Read all instructions before using the appliance.
2) To avoid fire or shock hazard, plug the appliance directly into a 120V
AC electrical outlet.
3) Keep the cord out of heavy traffic areas. DO NOT let the cord hang
over the edge of a table or counter. To avoid fire hazard, NEVER put
the cord under rugs, near heat registers, radiators, stoves, or heaters.
4) To protect against electrical hazards, DO NOT immerse in water or
other liquids. Do not use near water.
5) Close supervision is necessary when any appliance is used by or near
children, or by disabled people.
6) Always unplug the fan before moving it, putting on or taking off parts,
cleaning, or whenever the fan is not is use. Be sure to pull by the
plug and not the cord.
7) Avoid contact with moving parts. DO NOT operate without fan grills
properly in place.
8) DO NOT operate any appliance with a damaged cord or plug, if motor
fan fails to rotate, after the appliance malfunctions, or if it has been
dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair.
9) DO NOT operate in the presence of explosive and/or flammable
fumes.
10) Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by Bionaire®may cause hazards.
11 ) DO NOT use outdoors.
12) Always use on a dry, level surface.
13) Keep unit away from heated surfaces and open flames.
14) WARNING: To reduce the risk of fire or electric shock, DO NOT use
this fan with any solid-state speed control device.
15) DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the
unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current)PLUG (a plug
having one blade wider than the other). This plug will fit into the power outlet only one way.
If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact
qualified personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY.
1
ASSEMBLY INSTRUCTIONS
Tools Required: Phillips Head Screwdriver
BASE/POLE ASSEMBLY
Step 1. Insert the large foot bracket
( U ) into the bottom of the lower pole.
Make sure to align the rectangular plastic tab with groove inside the pole. Slide
the foot up approximately two inches
and then screw the feet into place.
Step 2. Insert the small foot bracket
( X ) into the bottom of the lower pole. Make sure to align the rectangular
plastic tab with groove inside the pole. Slide the foot up until it touches the
bottom of the upper foot bracket. Then screw the small foot bracket into
place.
F
A
B
C
A. Grill Hub
B. Decorative Cap
C. Security Screw
D. Front Grill
E. Fan Blade Cap
F. Washer/Nut
G. Fan Blade
H. Rear Grill Mounting Nut
I. Rear Grill
J. Motor Shaft
K. Motor Housing
L. Speed Control Knob
M. Fan Neck
N. Clasp Screws (2)
O. Extension Pole Clasp
P. Power Cord Clip
Q. Extension Pole
R. Pole Cover, Extension
Pole Bracket
E
D
S. Extension Pole
Bracket/Height
Adjustment Knob
T. Lower Pole
U. Large Foot Bracket
V. Large Foot Extensions
W.Rubber Feet (4)
X. Small Foot Bracket
Y. Small Foot Extensions
H
G
J
O
I
Y
X
K
L
M
N
P
Q
R
S
T
U
V
W
2
Loading...