Bionaire BPH1009 User Manual

Fig. 1

A. Front Housing
B. Rear Housing
C. Grill

D. Galileo remote
E. Control Panel
F. Foot Base (2

)

F

C

B

A

Control Panel

Galileo remote

D

E

Holmes Products (Europe) Ltd

1 Francis Grove

London SW19 4DT

England

Fax: [phone]

Email: [e-mail]

Website address: www.bionaire.com

UK - Free phone Customer Service Helpline – 0800 052 3615

9100020007404

BPH1009IUK06EM1

INSTRUCTION MANUAL

600W Panel Heater

with Galileo

™

technology

BPH1009

© 2006 JCS/THG, LLC
Bionaire

®

, the Bionaire logo™ and Galileo™ are trademarks of JCS/THG, LLC.

MODEL: BPH1009, BPH1009 (Tx)
220-240V~50Hz 500-600W
OPERATING FREQUENCY: 433.9MHz
VOLTAGE SUPPLY: Tx: DC4.5V

BPH1009IUK06EM1.qxd 8/15/06 3:05 PM Page 1

CONGRATULATIONS!

Your Bionaire®Heater has been designed using
the latest in technology. With normal care and
maintenance, your Bionaire®Heater will provide
years of satisfactory performance.

RETAIN THE FOLLOWING FOR FUTURE
REFERENCE.

IMPORTANT SAFEGUARDS
Mains connection

• Read these instructions carefully, in
conjunction with the illustrations, before using
the heater.

• Before connecting the heater, check that the
voltage indicated on the rating plate
corresponds to the mains voltage in your
home / office.

•Avoid the use of an extension cord because it
may cause the heater to overheat.

• WARNING: Risk of Fire. Discontinue use if
the outlet or plug become hot to the touch.
Overheating may indicate a worn or damaged
outlet. Consult a qualified electrician for outlet
replacement.

Safe positioning

• Only touch the heater with dry hands.

• DO NOT position where it can be touched by
children, especially the very young.

• DO NOT use this heater outdoors.

• This heater is NOT intended for use in
bathrooms, laundry areas and other similar
indoor locations. NEVER locate heater where
it may fall into the bathtub or other water
container.

• Position the heater in such a manner that the
air flow toward the heater and away from it, is
not obstructed.

• Allow a safe area around the heater away
from furniture or other objects; at least 50 cm
from the top and sides and 200 cm at the
front.

• DO NOT use this heater when it is lying on its
side.

• If the heater is tipped over, unplug it and allow
it to cool before standing it back up.

• DO NOT use the heater in rooms with
explosive gas (e.g. petrol) or while using
inflammable glue or solvent (e.g. when gluing
or varnishing parquet floors, PVC etc.)

• The heater cannot be used adjacent to curtain
or combustible material. Curtain or
combustible material may be burned if the
heater was installed incorrectly.

• WARNING: In order to avoid overheating,
DO NOT cover the heater ( ).

• DO NOT position the heater directly under a
power socket.

• When using the heater in portable condition,
do not place in the immediate surroundings of
a bath, shower or swimming pool.

• Heater must be installed at least 0.6m above
the floor or below the ceiling.

Safety in use

• Extra caution is necessary when the heater is
used near children, do not leave heater
unattended.

• DO NOT insert any objects into the heater.

• Keep the mains cord at a safe distance from
the main body of the heater.

• Prevent overheating of the heater by keeping
the air inlet and outlet unblocked. DO NOT
hang anything in front of or above the heater.

• If overheating should occur, the built-in
overheating safety device will switch off the
heater.

• DO NOT use aerosols, inflammable
substances or materials sensitive to heat in
the flow of hot air.

• In the event of a momentary electrical
disturbance , the sample may malfunction and
require user to reset the heater.

• Do not use this heater with programmer, timer,
or any other device that switch the heater on
automatically, since a fire exists if the heater
is covered or positioned incorrectly.

• Your Heater HOUSING is made of a durable
metal construction that will become hot during
operation. Please allow 10 minutes for the
heater to cool before handling. If you must
move your Heater while it is hot, please use
extreme caution. Do not use in the vicinity of
children without supervision.

• When using the Galileo

TM

remote to operate
the heater, please ensure that the function
shown on the GalileoTMcontrol matches the
setting on the control panel. If the settings are
different, push the Mode button until settings
match. See INSTRUCTION MANUAL for
additional information.

Servicing

• Should the heater stop working, first check the
fuse in the plug (UK only) or fuse/circuit
breaker at the distribution board is operating,
before contacting the manufacturer or service
agent.

• If the supply cord or plug is damaged, it must
be replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid hazard.

• The heater contains no user serviceable parts
and should the product suffer damage or
breakdown it must be returned to the
manufacturer or their service agent.

ENGLISH

Fig. 4D Fig. 4E

II

I

Fig. 5

Fig. 2A

Fig. 2B

Fig. 2

2

Fig. 4

Fig. 4A

Fig. 4B

Fig. 4C

I

II

Fig. 3

BPH1009IUK06EM1.qxd 8/15/06 3:05 PM Page 4