Bionaire BLP3340 User Manual

1 YEAR LIMITED WARRANTY

Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada)

Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of one year from

the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair
or replace this product or any component of the product found to be defective during the warranty period.
Replacement will be made with a new or remanufactured product or component. If the product is no longer available,

replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT

attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable.

Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service
centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and
conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly,
repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not

cover: Acts of God, such as fire, flood, hurricanes and tornadoes.

What are the limits on JCS’s Liability?

JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or

statutory warranty or condition.

Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for

a particular purpose is limited in duration to the duration of the above warranty.

JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.

JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use
the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of
contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.

Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages
or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.

How to Obtain Warranty Service

In the U.S.A.

If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-253-2764 and a convenient service center address will be provided to you.

In Canada
If you have any question regarding this warranty or would like to obtain warranty service, please call

1-800-253-2764 and a convenient service center address will be provided to you.

WARRANTY INFORMATIONWARRANTY INFORMATION

In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business Jarden Consumer Solutions located in
Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have

any other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE
DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.

© 2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved.
Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.

pure indoor living

LOW PROFILE

HEATER

MODEL: BLP3340

Instruction Leaflet

Read instructions before operating. Retain for future reference.

PLEASE READ AND SAVE THESE

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT INSTRUCTIONS: When using electrical

appliances, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and injury
to persons, including the following:

1. Read all instructions before using this heater.

2. This heater is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0.9 m) from the
front of the heater and keep them away from the sides
and rear.

3. Extreme caution is necessary when any heater is used

by or near children or invalids and whenever the heater
is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or plug
or after the heater malfunctions, has been dropped or
damaged in any manner. Discard heater, or return to

authorized service facility for examination and/or

repair.

6. Do not use outdoors.

7. This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never locate
heater where it may fall into a bathtub or other water
container.

8. Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away
from traffic area and where it will not be tripped over.

9. To disconnect heater, turn controls to off, then remove
plug from outlet.

10. Do not insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.

DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS

SAFETY FEATURE IN ANY WAY.

11. To prevent a possible fire, do not block air intakes or

exhaust in any manner. Do not use on soft surfaces,

like a bed, where openings may become blocked.

12. A heater has hot and arcing or sparking parts inside. Do
not use it in areas where gasoline, paint, or flammable
liquids are used or stored.

13. Use this heater only as described in this manual. Any

other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.

14. Always plug heaters directly into a wall outlet/

receptacle. Never use with an extension cord or

relocatable power tap (outlet/power strip).

15. When unplugging, be sure to pull by the plug and not
the cord.

16. If the heater will not operate, see specific instructions
on Auto Safety Shut-off.

17. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.

18. Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if plug or
outlet is hot to touch.

19. The heater must not be located immediately below a
socket-outlet. Do not use this heater in the immediate
surroundings of a bath, a shower or a swimming pool.

PLEASE READ AND SAVE

THESE IMPORTANT

SAFETY INSTRUCTIONS

Printed In China SPR-060111-495 P.N. 148576

OPERATING - INSTRUCTIONS CLEANING AND MAINTENANCE

ECO-SMART™ TECHNOLOGY

ECO-SMART™ is a technology that allows this portable heater
to heat an area more efficiently through a continuous cycling
of wattages. Although no physical change is noticeable, when
the heater runs in ECO-SMART™ mode it consumes less energy
over a long period of time. To activate the Eco-Smart™ cycle
depress the Eco-Smart™ button. The Eco-Smart™ cycle can be
deactivated by depressing the Eco-Smart™ button. Once
deactivated, the heater will run continuously at 1500 watts.

PRE-OPERATING INSTRUCTIONS

1. Make sure the heater is OFF before plugging the heater
into the outlet.

2. Place the heater on a firm, level surface.

3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 Amps.

4. Make sure unit and plug is free of moisture and debris
before plugging into an electrical outlet.

CONTROL PANEL DETAILS (Figure 1)

Control Panel:

1. Press the On/Off button to turn unit on.

2. Select temperature by pressing the Temperature button
until the desired temperature is chosen.

3. Set the Timer for the duration in which you would like the
heater to run before turning off automatically.

4. Then choose whether or not you would like to use the Eco­Smart™ Technology by pressing the Eco-Smart™ button.

ON/OFF

TEMPERATURE

Figure 1

TIMER

(NOT A BUTTON)

ECO-SMART™

SENSOR

FCC STATEMENT

Potential for Radio/Television interference

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.

This product has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC rules.

These limits are designed to provide reasonable protection
against harmful interference in a residential installation. The
product generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the
interference will not occur in a particular installation. If the
product does cause harmful interference to radio or television
reception, which can be determined by turning the product on
or off, the user is encouraged to try to correct the interference
by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the product and the

receiver.

• Connect the product into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

• Changes or modifications not expressly approved by the

party responsible for compliance could void the user’s
authority to operate the equipment.

Questions? Comments? Call 1-800-253-2764 in North America.

CLEANING/MAINTENANCE

Always unplug the heater before cleaning and allow the
heater to cool down.

1. Clean the unit with a soft cloth moistened with a mild
soap solution.

2. NEVER use abrasive or flammable solvents to clean the

unit.

3. After cleaning, be sure to completely dry the unit with a
cloth or towel.

4. Store heater in a cool, dry location.

5. It is recommended that you store the unit in its original
carton.

TIP: Over time, dust may accumulate on the front grills.

This can be removed by wiping the unit with a damp
cloth.

TROUBLESHOOTING

If your heater fails to operate:

• UNPLUG THE UNIT and make sure the heater is placed

in an upright position (see Tip Over Shut-Off section).

• Make sure the electrical outlet or circuit breaker is

working.

• Check for obstructions. If you find an obstruction turn

the heater OFF, and unplug the unit. Carefully remove
the obstruction and follow the reset instructions.

• The temperature may be set too low. Adjust the

thermostat until the heater restarts.

Please DO NOT attempt to open or repair the heater.

If you have any questions regarding your product or
would like to learn more about other Bionaire®
products, please contact our Consumer Service
Department at 1-800-253-2764 or visit our website at
www.bionaire.com.

AUTO SAFETY SHUT-OFF WITH INSTANT
TIP OVER PROTECTION

This heater is equipped with a patented, technologically­advanced safety system that requires the user to reset the
heater if there is a potential overheat situation. When a
potential overheat temperature is reached, the system will
automatically shut the heater off. It can only resume
operation when the user resets the unit. For specific reset
instructions please refer to the unit.

To Reset the Heater:

1. Unplug the heater and allow 30 minutes for the heater

to cool down.

2. After 30 minutes plug the heater in and operate
normally.

3. If the heater does not work normally, repeat steps 1
and 2 again.

Tip Over Shut-Off:

When the unit is accidentally knocked over, it will instantly
shut off. The unit may also shut off if it is moved or
bumped. To reset, simply place the heater in an upright
position and it will operate normally.

NOTE: If unit does not turn on when placed in the upright
position, press the mode button once and heater will resume
operation.