Binatone DT860W Quick Installation Manual

Quick Installation Guide

DT860W

150M Wireless N ADSL2+ Router

7109504820

1

1. Connecting the Router

Before installing the device, please make sure your broadband service
provided by your ISP is available. If there is any problem, please contact
your ISP. You need to connect the device to the phone jack, the power outlet,
and your computer or network. Before cable connection, cut off the power
supply and keep your hands dry.

1) Connect the ADSL LINE.

2) Your splitter divides the data and voice, and then you can access the
Internet and make calls at the same time. The external splitter has three
ports:

•

LINE: Connect to the wall jack

•

PHONE: Connect to the phone sets

•

MODEM: Connect to the ADSL LINE port of DT860W.

Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on
the rear panel of DT860W. Connect the other end to the MODEM port of
the external splitter.

3) Connect the Ethernet cable. Attach one end of a network cable to your
computer’s Ethernet port or a regular hub/switch port, and the other end
to the LAN port on the DT860W.

4) Attach the power adapter. Connect the power adapter to the POWER
connector on the rear of the device and plug in the adapter to a wall
outlet or power extension.

5) Turn on the DT860W and power on the computers and LAN devices.