Binatone DT820N Quick Installation Manual

Quick Installation Guide

DT820N

Wired ADSL2+ Router

1. Connecting the router

Before installing the device, please make sure your
broadband service provided by your ISP is available. If there
is any problem, please contact your ISP. You need to connect

the device to the phone jack, the power outlet, and your
computer or network. Before cable connection, cut off the
power supply and keep your hands dry.

a. Connect the ADSL LINE.

Method one: Plug one end of the twisted-pair ADSL
cable into the LINE port on the rear panel of DT820N,
and insert the other end into the wall socket.

Method two ： You can use a separate splitter.
External splitter can divide the data and voice, and
then you can access the Internet and make calls at
the same time. The external splitter has three ports:

• LINE: Connect to the wall jack

• PHONE: Connect to the phone sets

• MODEM: Connect to the ADSL LINE port of

DT820N
Plug one end of the twisted-pair ADSL cable into the

LINE port on the rear panel of DT820N. Connect

1

the other end to the MODEM port of the external

splitter.

b. Connect the Ethernet cable. Attach one end of a

c. Attach the power adapter. Connect the power adapter

d. Turn on the DT820N and power on the computers and

network cable to your computer’s Ethernet port or a
regular hub/switch port, and the other end to the LAN
port on the DT820N.

to the POWER connector on the rear of the device
and plug in the adapter to a wall outlet or power
extension.

LAN devices.

Figure 1

2