Bernafon FU2BTEPP Users Guide

Bernafon Radio Model - Quick Installation Guide

Radio Model Name: Fusion 2 BTE13PP

The Fusion 2 BTE13PP radio model is a low power, short range, inductive radio transceiv er work ing at 3.84 MHz. It can be seen below:

The most important parts of the radio module are a Digital-Signal-Processor (DSP), a radio Front-End (FE), an EEPROM memory, a telecoil and an antenna coil –
all mounted on the same main flex PCB. On the top side besides the radio Front-End, EEPROM and telecoil, also switches for user inter action (e.g. volume
control), two microphones, a programming plug and pads for connecting the battery can be seen. The radio model is intended to be installed in Oticon, Berna fon,
Sonic and affiliated wireless hearing aid devices of the BTE (Behind-The-Ear) PP (Power Plus) or P wearing styles.

Bernafon AG Morgenstrasse 131 Phone: [phone] www.bernafon.com
P.O. Box 550 CH-3018 Bern Fax: [phone] Switzerland

Fusion 2 BTE13PP Radio Model – Top Side

1

Fusion 2 BTE13PP Radio Model – Bottom Side

Bernafon Radio Model - Quick Installation Guide

Radio Model Name: Fusion 2 BTE13PP

The DSP is the main processor controlling the functionality of the amplifier and the FE is a complete radio transceiver, including both transmitter, receiver and
local oscillators. The Fusion 2 BTE13PP radio module also includes all voltage regulators inside the DSP and FE and

(PC_DATA and PC_CLOCK) on board

.

buffered data programming inputs

On the bottom side of the radio model the DSP, the antenna coil and pads for connecting the audio receiver can be seen.

The module only requires a single cell battery and an external audio receiver (speaker) to be attached and plastic s hells holdi ng ever ythi ng to gethe r in order to be
operational.

Bernafon AG Morgenstrasse 131 Phone: [phone] www.bernafon.com
P.O. Box 550 CH-3018 Bern Fax: [phone] Switzerland

2