Berkel 3813 Installation Manual

HS and 3000 Series Slicers
Knife Removal Tool Instructions

Before using the knife removal tool, unplug the machine, turn the index knob fully
clockwise to close the gauge plate, remove the product tray, sharpener, top knife cover and
removable ring guard cover.

Removing Knife:

Step One: Point arrow on knife to pin on ring

guard at 1 o’clock position (Figure A).

A

Step Two: Place tool on knife by aligning bottom

pins and notches (Figure B).

B

Step Three: Look between knife and tool to

align pin on tool with hole in knife. Rotate knife if
necessary using hand on back of knife (Figure C).

Knife edge is sharp.

C

Step Four: Push handle in and turn (Figure D).

D

Note: Remember to push the handle fi rmly all the
way into the hub before attempting to turn. You

may experience resistance when turning.

Step Five: Lift tool and knife up and out.

F35225 Rev. A (October 2013)

Replacing Knife:

Step One: Point line on hub to pin on ring guard

at 1 o’clock position (Figure E).

E.

E

Step Two: Place tool on hub by aligning bottom

pins and notches (Figure B).

Note: If the tool does not slide into hub after this
step, nudge slightly to lock into hub (Figure F).

Note: If the tool still does not slide into the hub,

check alignment of the pin on hub with hole in
back of knife (Figure G). Rotate hub if necessary.
Then nudge slightly to lock into the hub (Figure F).

G

F

Step Three: Press handle in and turn (Figure H).

H

Note: Remember to push the handle fi rmly all the
way into the hub before attempting to turn. You

may experience resistance when turning.

Step Four: Lift tool up and out.