Benq SW916 surface fit improvement

SW916 surface fit improvement

Correcting Surface Fit

Manually correct geographic distortion by Surface Fit calibration function.

•Using the OSD menu

1. Select Surface Fit in the DISPLAY menu and
press MODE/ENTER.

2. Press ▲/▼ to select Horizontal and press
MODE/ENTER.

3. Press ◄/► to select the direction and press MODE/ENTER.

To adjust left or/and right sides of horizontal surface fit:

4. Press ◄/► to adjust the left or/and right side convex or concave. Default is 0 and
value is -40~0~40.

To adjust the center of the curve:

5. Press ▲/▼ to adjust the center of the curve because the peak of the curve is not
always at the center and it can be adjusted. Default is 0 and value is -40~0~40.

6. Press ▲/▼ to select Ver tica l and press
MODE/ENTER.

1

7. Press ◄/► to select the direction and press MODE/ENTER.

To adjust top or/and bottom sides of vertical surface fit:

8. Press ▲/▼ to adjust the top or/and bottom side convex or concave. Default is 0 and
value is -40~0~40.

To adjust the center of the curve:

9. Press ◄/► to adjust the center of the curve because it is not always at the center
and it can be adjusted. Default is 0 and value is -40~0~40.

•Using the QUICK INSTALL key

1. Press QUICK INSTALL on the remote control.

NETWORK
SETTING

2. Press ▼ to select Surface Fit and press
MODE/ENTER.

3. Follow the steps 2~9 in the above section.

The function is only available for SW916.

2