PR-25 Real Wood Audio Video Cabinet
ASSEMBLY INSTRUCTIONS
Patent Pending
The real hardwoods used in Bell'O furniture are naturally
beautiful. Some differences in wood grain are desirable
and expected. Please use only high quality wood furniture
polish to care for your cabinet.
PARTS LIST
PART DESCRIPTION QUANTITY
A. CABINET TOP 1 PC
B. LEFT SIDE SUPPORT PANEL
C.
RIGHT SIDE SUPPORT PANEL
D. UPPER INTERIOR SHELF
E. MIDDLE INTERIOR SHELF 1 PC
F. BOTTOM SHELF 1 PC
1 PC
1 PC
1 PC
G. TOP DOOR PANEL 1 PC
H. LOWER SHELF DIVIDER 2 PCS
I. UPPER SHELF DIVIDERS 2 PCS
J. CENTER SUPPORT LEG 1 PC
2
PARTS LIST (Continued)
PART DESCRIPTION QUANTITY
K1. UPPER BACK PANEL 1 PC
K2. LOWER BACK PANEL 1 PC
L. LOWER CABINET DOORS 2 PCS
1. CAM LOCK PIN 18 PCS
2. CAM LOCK 18 PCS
3. 30MM DOWEL 32 PCS
4. 03X12MM SCREW 33 PCS
5. 50MM DOWEL 4 PCS
6. LEFT DRAWER HINGE 1 PC
7. UPPER DOOR KNOB 2 PCS
3
PARTS LIST (Continued)
ART DESCRIPTION QUANTITY
P
8. 05/32" x 22MM SCREW 4 PCS
9. RIGHT DRAWER HINGE 1 PCS
10. HINGE PIN 2 PCS
11. 3.5 X 15MM SCREW 16 PCS
12. LOWER DOOR HINGE 4 PCS
13. LOWER CABINET KNOB 2 PCS
14. TOP SHELF SUPPORT ROD 1 PC
FOR YOUR SAFETY, PLEASE FOLLOW THESE PRECAUTIONS:
! ALWAYS REMOVE THE TV AND OTHER EQUIPMENT FROM THE FURNITURE PRIOR TO MOVING THE ASSEMBLED UNIT.
! BE CAREFUL WHEN MOVING THE ASSEMBLED FURNITURE AFTER THE SHELVES AND DOORS HAVE BEEN
INSTALLED, AND/OR WHEN THERE IS EQUIPMENT LOCATED ON OR IN THE FURNITURE AS THIS MAY CAUSE
THE SHELVES AND OTHER ITEMS TO BECOME UNSECURED AND FALL.
! WHEN IN USE, THIS FURNITURE MUST BE PLACED ON A FLAT, SOLID AND LEVEL SURFACE.
! DO NOT LEAN ON THE TV WHEN IT IS ON THE TV STAND.
! DO NOT CLIMB OR STEP ON THE STAND.
THE DOORS.
! DO NOT
! DO NOT PLACE ITEMS ON THE SHELVES WHICH EXCEED THE MAXIMUM WEIGHT LIMITS OF 200 LBS. FOR TOP SHELF
AND 50 LBS. FOR EACH LOWER SHELF
BANG OR PLACE
YOUR OWN WEIGHT
ON
4
ASSEMBLY INSTRUCTIONS
NOTE: 2 PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS FURNITURE. THIS TABLE IS
CONSTRUCTED WITH REAL WOOD VENEER. TO AVOID DAMAGE DURING ASSEMBLY, IT
S
HOULD BE ASSEMBLED ON A SOFT SURFACE.
Fig. 1
F
3
H
1. PLACE the bottom shelf (F) on edge. PLACE four smaller dowels (3) into the holes in the top
side of the bottom shelf as shown in Fig. 1.
the dowels, with the FRONT arrow facing the front of the shelf (the edge without the cut out
slots) as shown.
PLACE the edge of one of the dividers (H) onto
5
Loading...