Beko WMY7046LB2DV7220X User Manual

0 (0)
Beko WMY7046LB2DV7220X User Manual

Dryer

DV 7220 X

User manual

2960310534_KM/280814.1900

Read this manual prior to initial operation of the product!

Dear Customer,

We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results.

We advise you to read through this manual carefully before using your product and keep it for future reference.

This User Manual will

Help you use your machine in a fast and safe way.

Read the User Manual before installing and starting your product.

In particular, follow the instructions related to safety.

Keep this User Manual within easy reach for future reference.

Please read all additional documents supplied with your product. Remember that this User Manual is also applicable for several other models.

Explanation of symbols

Throughout this User Manual the following symbols are used:

A Important safety information. Warning for hazardous situations with regard to life and property.

B Caution; Warning for supply voltage.

Caution; Warning for fire hazard.

Caution; Warning for hot surfaces.

Read the instructions.

C Useful information. Important information or useful hints about usage.

This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance

also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment.

2960310534_EN/070912.1445

1Important safety information

This section includes safety information that will help protection from risks of personal injuries or materialistic damages. Failure to follow these instructions shall cause any warranty and reliability commitment to become void.

General safety

Never place the machine on a carpetcovered floor, otherwise, lack of airflow beneath the machine may cause electrical parts to overheat. This will cause problems with your machine.

If the power cable or mains plug is damaged, you must call qualified electrician for repair.

The product should not be plugged in during installation, maintenance and repair works. Such works should always be made by the technical service. Manufacturer shall not be held responsible for damages arising from processes carried out by any unauthorised persons.

Connect the product to a grounded outlet protected by a fuse of suitable capacity as stated in the technical specifications table.

Operate your product at temperatures between +5°C and +35°C.

Do not use electrical devices in the product.

Do not connect the air exit of the product to the chimney holes which are used for the exhaust fumes of the devices operating with gas or other types of fuel.

You must provide enough ventilation in order to prevent gases exiting from devices operating with other types of fuels including the naked flame from accumulating in the room due to the back fire effect.

Always clean the lint filter before or after each loading.

Never operate your dryer without the lint filter installed.

Do not allow fibre, dust and dirt accumulation around the exhaust exit and at adjacent areas.

Power cable plug must be within easy reach after installation.

Do not use extension cords, multi-plugs or adaptors to connect the dryer to power supply in order to decrease the risk of electric shock.

Do not make any changes on the plug supplied with the product. If it is not compatible with the socket, have a qualified electrician change the socket with a suitable one.

Items cleaned or washed with gasoil/ fuel oil, dry-laundry solvents and other combustible or explosive materials as

well as the items that are contaminated or spotted with such materials should not be dried in the product since they emit flammable or explosive vapor.

Do not dry items cleaned with industrial chemicals in the dryer.

Do not dry unwashed items in the dryer.

Items soiled with cooking oils, acetone, alcohol, fuel oil, kerosene, stain remover, turpentine, paraffin and paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer.

Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer.

Do not use fabric softeners and anti-static products unless they are recommended by the manufacturers of the fabric softener or the product.

Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.

If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated by hair care products be placed in a tumble dryer they should

first be washed in hot water with extra detergent - this will reduce, but not eliminate, the hazard.

This product must be grounded. Grounding installation decreases the risk of electric shock by opening a path with low resistance for the electricity flow in case of a malfunction or failure. Power cable of this product is equipped with a conductor and a grounding plug that allows for grounding the product. This plug must be installed appropriately and inserted into a socket which is grounded in accordance with the local laws and regulations.

Do not install the product behind a door with a lock, sliding door or a door that has a hinge against the hinge of the dryer.

Do not install or leave this product in places where it will be exposed to outdoor conditions.

Do not tamper with the controls.

Do not perform any repair or part replacing procedures on the product even if you

3 EN

know or have the ability to perform unless it is clearly suggested in the operating instructions or the published service manual.

Inside and exhaust duct of the product must be cleaned by the qualified service personnel periodically.

Wrong connection of grounding conductor of the product can cause electric shock. If you have any suspect about the grounding connection, have it checked by a qualified electrician, service representative or service personnel.

Do not reach into the machine when the drum is spinning.

Unplug the machine when it is not in use.

Never wash down the appliance with water! There is the risk of electric shock! Always disconnect by unplugging from the mains before cleaning.

Never touch the plug with wet hands. Never unplug by pulling on the cable, always pull out by grabbing the plug only. Do not operate the machine if the power cable or plug is damaged!

Never attempt to repair the machine yourself, otherwise, you will be putting your life and others’ lives in danger.

For malfunctions that cannot be solved by following the information given in the safety instructions:

Turn off the machine, disconnect the power cord and contact an Beko Service.

Do not stop the dryer before the drying cycle comes to an end unless you

will remove all laundry from the dryer immediately in order to lay them and dissipate the heat.

Remove the door of the drying compartment before decommissioning or disposing of the product.

The final step of the drying cycle (cooldown cycle) occurs without applying heat to ensure that the items are left at a temperature that will not damage them.

Fabric softeners or similar products should be used as specified by the fabric softener instructions.

Underwear that contains metal reinforcements should not be placed in a dryer. Damage to the dryer can result if metal reinforcements come loose during drying.

Check all garments for forgotten lighters, coins, metal pieces, needles, etc. before loading.

Remove all objects from pockets such as lighters and matches.

At times when your dryer is not in use or after the laundry is taken out following the completion of drying process, turn off by

using the On/Off button. In cases when the On/Off button is on (while the dryer is energized), keep the door of the dryer closed.

Intended use

This product has been designed for domestic use. It should not be used for other purposes.

Use the product only for drying laundry that are marked accordingly.

Dry only those articles in your product that are stated in this manual.

This product is not intended to be used by persons with physical, sensory or mental disorders or unlearned or inexperienced people (including children) unless they

are attended by a person who will be responsible for their safety or who will instruct them accordingly for use of the product.

Children’s safety

Electrical appliances are dangerous for the children. Keep children away from the machine when it is operating. Do not let them tamper with the machine.

Packaging materials are dangerous to children. Keep the packaging materials out of reach of children or dispose them by classifying according to waste directives.

Do not allow children sit/climb on or enter in the product.

Children should be supervised to ensure that they do not play with the product.

Close the loading door when you leave the area where the product is located.

4 EN

Install the product in an environment which has no risk of freezing and is in a stable and level position.
Operate your product in a well ventilated, dust-free environment.
Do not block the air ducts in front of and under the product with materials such as long pile rugs and wooden planks.
Do not place your product on a long pile rug or on similar surfaces.
Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product.
Once the product is installed, it should stay at the same place where its connections have been made. When installing the product, make sure that the rear wall of it does not touch anywhere (tap, socket, etc.) and also pay attention to install the product at a place where it will stay permanently.

2 Installation

It is the customers responsibility to arrange a suitably qualified installer to correctly install this

product.

CPreparation of location and electrical installation for the product is under customer’s responsibility.

BInstallation and electrical connections must be carried out by a qualified personnel.

APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products will cause risks for your safety.

Appropriate installation location

BDo not place the product on top of the power cable.

Keep at least 1.5 cm distance to walls of other furniture.

Under counter installation

A special part (Part no: 295 970 0100) replacing the top trim must be provided and installed by the suitably qualified installer in order to use the machine under a counter or in a cupboard. It should never be operated without the top trim.

Leave at least 3 cm of space between the side and rear walls of the product and the walls of the counter/cupboard when

installing your product under a counter or in a cupboard.

Mounting over a washing machine

A fitting device should be used between the two machines when installing above a washing machine. The bracket (Part no. 296 280 0100 white/296 280 0200 grey) must be installed by the Authorised Service Agent.

Place the product on a firm floor. If it will be

placed on top of a washing machine, the approximate weight of both machines may reach 180 kg when they are full. Therefore, the floor must be capable of carrying the load on it!

Ventilation hose and connection (for products equipped with an outlet vent)

Ventilation hose allows exhaust air from inside the machine

Vented dryer has 1 air outlet.

Stainless sheet metal or aluminum pipes can be used instead of a hose. The pipe diameter should be minimum 10 cm.

Maximum hose and pipe lengths are given in the table below.

 

Hose

Pipe

 

 

 

Maximum length

4 m

5 m

1 elbow 45°

-1.0 m

-0.3 m

1 elbow 90°

-1.8 m

-0.6 m

1 elbow 90° short

 

-2.7 m

1 wall passage

-2.0 m

-2.0 m

CEach elbow and other passages should be subtracted from the maximum length stated above.

To connect a ventilation hose;

1. Connect the air outlet hose to the hose spacer piece by turning it counterclockwise.

2. Make the hose passages as shown below.

CExhaust of humid air from the dryer into the room is inconvenient. It may damage the walls and furniture in the room.

CThe ventilation hose can be routed outdoors via a window or it can be connected to the air outlet in the bathroom.

CAir outlet hose must be routed directly to the outdoors. There must be a limited number of elbows as not to hinder ventilation.

CTo prevent water accumulation in the hose, make sure that it is not folded on the floor.

5 EN

Loading...
+ 11 hidden pages