ULTRA FLANGER UF300
Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA
FLANGER UF300. This high-quality effects pedal delivers two flangers in one—from jetplane thick chorus, vibrato to short delay effects. Thanks to its high-performance features
you can choose between classic and detuned flanger effects with extensive parameter
controls for awesome sound shaping.
Originally, the flanger effect was generated with two tape recorders running
synchronously. The same audio signal was recorded on both machines. If you put a
finger on the left spool of one of the machines, the spool and the playback speed are
slowed down. The generated delay results in phase shifting of the signals.
1. CONTROLS
The MODE switch lets you choose between negative feedback (Mode 1) or positive
feedback (Mode 2) flanger modes. Negative feedback means that the delayed
signal is inverted before it is fed back to the original signal. In positive feedback
mode the delayed signal is not inverted. In this case the effect has a more detuned
character perfect for vibrato effects.
With the MANUAL control you can adjust the flanger delay time. Longer delay times
produce a sharper, more detuned sound, very close to a chorus effect.
Turn up the DEPTH control to achieve a fuller and deeper effect sound.
The RATE control determines the speed of the flanger effect.
The RES(onance) control determines the amount of output signal fed back to the
flanger input to increase the resonance frequency. That way the flanger effect
gets more intensive.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
Top view
ULTRA FLANGER UF300
The UF300 has no on/off switch. As soon as you insert the jack into the IN
connector, the UF300 begins running. When not using the UF300, remove
the jack from the IN connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
For our current warranty terms, please refer to our website at http://www.behringer.com.
3. SPECIFICATIONS
In
Connector 1/4" TS
Impedance 500 kΩ
Out
Connector 1/4" TS
Impedance 1 kΩ
2. WARRANTY
Power supply 9 V , 100 mA regulated
Power connector 2 mm DC jack, negative center
Battery 9 V type 6LR61
Power consumption 30 mA
Dimensions (H x W x D) approx. 54 mm (2 1/8") x 70 mm (2 3/4") x 123 mm (4 4/5")
Weight approx. 0.33 kg (0.73 lbs)
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made
from time to time to existing products without prior notice. Specifications and appearance may therefore differ from those listed or shown.
Do not use near water, or install near heat sources. Use only authorized attachments/accessories. Do not service product yourself.
Contact our qualified servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged.
No utilizar cerca de agua o instalar cerca de fuentes de calor. Utilice sólo accesorios y aditamentos autorizados. No intenté
reparar el producto usted mismo. Contacte a nuestro personal técnico cualificado para servicio y reparaciones, especialmente
cuando la fuente o el cable de alimentación estén dañados.
Не эксплуатируйте прибор вблизи от источников воды и тепла. Применяйте только авторизованные дополнительные
устройства. Никогда не ремонтируйте прибор самостоятельно. Ремонт может производить только квалифицированный
специализированный персонал, особенно при повреждениях сетевого провода или сетевой вилки.
4. SAFETY INSTRUCTIONS
BEHRINGER PSU-SB
USA/Canada 120 V~, 60 Hz
U.K./Australia 240 V~, 50 Hz
China/Korea 220 V~, 50 Hz
Europe 230 V~, 50 Hz
Japan 100 V~, 50 - 60 Hz
Die deutsche Anleitung ist erhältlich @ www.behringer.com
Manuel francophone en téléchargement sur www.behringer.com
Manual en español disponible en www.behringer.com
Manuali italiani disponibili @ www.behringer.com
Русскоязычное руководство @ www.behringer.com
Polska instrukcja dostępna jest pod adresem @ www.behringer.com
Nederlandse handleiding beschikbaar @ www.behringer.com
Suomenkielinen käyttöohje saatavilla osoitteesta www.behringer.com
Svensk manual finns tillgänglig på www.behringer.com
Dansk vejledning findes på @ www.behringer.com
Manual português disponível @ www.behringer.com
Еллзнйкь егчейсЯдйп хрЬсчей дйбиЭуймп уфз дйеэихнуз www.behringer.com
Technical specifications and appearance subject to change without notice. The information contained herein is correct at the time
of printing. The names of companies, institutions or publications pictured or mentioned and their respective logos are registered
trademarks of their respective owners. Their use neither constitutes a claim of the trademarks by BEHRINGER nor affiliation of
the trademark owners with BEHRINGER. BEHRINGER accepts no liability for any loss which may be suffered by any person who
relies either wholly or in part upon any description, photograph or statement contained herein. Colours and specification may vary
slightly from product. Products are sold through our authorised dealers only. Distributors and dealers are not agents of BEHRINGER
and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this
manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and
recording of any kind, for any purpose, without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH.
BEHRINGER® is a registered trademark. ALL RIGHTS RESERVED. © 2006 BEHRINGER Spezielle Studiotechnik GmbH,
Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany. Tel. +49 2154 9206 0,
Fax +49 2154 9206 4903