Behringer D0400 User Manual

DIGITAL DELAY DD400

43521

8

7

6

Thank you for showing your confi dence in us by choosing the BEHRINGER DIGITAL DELAY
DD400. This ultimate effects pedal is designed to deliver 24-bit high-resolution stereo delay
sounds comparable to state-of-the-art studio processors. Thanks to its parameter controls and
built-intap tempo feature, you’ll have plenty of cool sounds at your disposal to handle every
situation.

The delay effect creates a delay of the input signal with various repetitions. Different tempo
settings allow interesting delay effects.

1. CONTROLS

Top view

The LEVEL control adjusts the output level.{1}
The FEEDBACK (Feedback) control adjusts the amount of signal repetitions.{2}
The TIME (Delay Time) control adjusts the exact delay time.Depending on the MODE {3}

control position you can adjust it around 200 ms, 500 ms or 1300 ms. The delay time
describes how fast the signal repetitions will follow after the original signal.

With the MODE control you can chose between three different delay time ranges {4}
around 200 ms, 500 ms or 1300 ms with either mono (M) or stereo (S) delay. The exact
delay time can be adjusted by the TIME control. In position HOLD the signal will be
repeated constantly.

The ON/BATT LED illuminates when the effect is activated. It also serves as a battery {5}
level indicator.

Use the footswitch to activate/deactivate the effect. The built-in tap tempo feature is {6}
also accessed through this switch.

Hold the footswitch down for at least one second and release to enter tap mode. The •
LED will blink in rhythm with the current tempo.

Tap the footswitch to the desired tempo. The pedal will measure the time between •
the last two taps and automatically employ this as the delay time. The LED will now
fl ash in rhythm with the new tempo.

After a few seconds, the unit will automatically exit tap mode and the footswitch can •
be used to activate/deactivate the effect again.

Turning the Time knob will override the tapped tempo and the delay will be deter-•
mined by the settings of the Mode and Time knobs.

Use this ¼" TS IN connector to plug in the instrument cable.{7}
The two ¼" TS connectors OUT A and OUT B send the signal to your amp. Use both {8}

connectors if you want to achieve full stereo delay effect. For mono use just plug in
OUT A.

Use the DC IN connection at the front of the unit to plug in a 9 V power supply
(not included).

DIGITAL DELAY DD400

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace
the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be careful not to
scratch the unit.



The DD400 has no on/off switch. As soon as you insert the jack into the in connector,
the DD400 begins running. When not using the DD400, remove the jack from the in
connector. This extends the life of the battery.

The SERIAL NUMBER is located at the bottom.

2. WARRANTY

For our current warranty terms, please refer to our website at http://www.behringer.com.

In

Connector ¼" TS
Impedance 500 kΩ

Out A

Connector ¼" TS
Impedance 1 kΩ

Out B

Connector ¼" TS
Impedance 1 kΩ
Power supply 9 V
Behringer PSU-SB
U.S./Canada 120 V~, 60 Hz
China/Korea 220 V~, 50 Hz
U.K./Australia 240 V~, 50 Hz
Europe 230 V~, 50 Hz
Japan 100 V~, 50 - 60 Hz
Power connector 2 mm DC jack, negative center
Battery 9 V type 6LR61
Power consumption 90 mA
Dimensions (H x W x D) approx. 54 mm (2 ⅛") x 70 mm (2 ¾") x 123 mm (4
Weight approx. 0.33 kg (0.73 lbs)

BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifi cations may be made from time to
time to existing products without prior notice. Specifi cations and appearance may therefore differ from those listed or shown.

Do not use near water, or install near heat sources. Use only authorized attachments/accessories. Do not service product yourself. Contact our
qualifi ed servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged.

No utilizar cerca de agua o instalar cerca de fuentes de calor. Utilice sólo accesorios y aditamentos autorizados. No intenté reparar el producto
usted mismo. Contacte a nuestro personal técnico cualifi cado para servicio y reparaciones, especialmente cuando la fuente o el cable de

alimentación estén dañados.

Не эксплуатируйте прибор вблизи от источников воды и тепла. Применяйте только авторизованные дополнительные устройства. Никогда
не ремонтируйте прибор самостоятельно. Ремонт может производить только квалифицированный специализированный персонал,

особенно при повреждениях сетевого провода или сетевой вилки.

3. SPECIFICATIONS

, 100 mA, regulated

4. SAFETY INSTRUCTIONS

4

/5")

Die deutsche Anleitung ist erhältlich @ www.behringer.com
Manuel francophone en téléchargement sur www.behringer.com
Manual en español disponible en www.behringer.com
Manuali italiani disponibili @ www.behringer.com

Русскоязычное руководство @ www.behringer.com

Polska instrukcja dostępna jest pod adresem @ www.behringer.com
Nederlandse handleiding beschikbaar @ www.behringer.com
Suomenkielinen käyttöohje saatavilla osoitteesta www.behringer.com
Svensk manual fi nns tillgänglig på www.behringer.com
Dansk vejledning fi ndes på @ www.behringer.com
Manual português disponível @ www.behringer.com

Еллзнйкь егчейсЯдйп хрЬсчей дйбиЭуймп уфз дйеэихнуз www.behringer.com

Technical specifi cations and appearance are subject to change without notice. The information contained herein is correct at the time of printing.
All trademarks (except BEHRINGER, the BEHRINGER logo and JUST LISTEN) mentioned belong to their respective owners, and such use
neither constitutes a claim of the trademarks by BEHRINGER nor affi liation of the trademark owners with BEHRINGER. BEHRINGER accepts
no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement
contained herein. Colors and specifi cations may vary slightly from product. Our products are sold through authorized dealers only. Distributors
and dealers are not agents of BEHRINGER and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or
representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including
photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH. ALL
RIGHTS RESERVED. © 2008 BEHRINGER International GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich, Germany. Tel. +49 2154
9206 0, Fax [phone]