Bazooka EL5A, EL6A, EL8A Instruction

See Model Size

For Length

Figure 9

Figure 10

MOUNTING THE BAZOOKA

Figure 7

Figure 8

3

,,

3

,,

3. Place each mount-

ing base under the
Bazooka so that the
apex at the bottom of
the tube sits inside
the mounting base as
in figure7.

4. Move the bases so

that they are spaced
approximately 3”
from each end of the
enclosure as illustrat­ed in figure 8.

5. Remove the Bazooka

without moving the
mounting bases and set
it aside.

6. Screw each mount-

ing base securely in
place with screws pro­vided as illustrated in
figure 6.

See Model Size

For Length

Figure 9

Figure 10

MOUNTING THE BAZOOKA

Model Length

EL5A 12”
EL6A 17”
EL8A 22”

7. Adjust buckle end of

strap so that it extends
out of the mounting
base (see figure 9) the
proper length for the
model size of Bazooka
you are installing
(Refer to the chart for
proper length)

8. Remove any slack in

the strap by feeding it
out of the mounting
base on the loose end
of the strap opposite
the buckle.

9. Place Bazooka on

the mounting bases
and fasten the buckles
as illustrated in figure

10. The strap should
loop through the buck­le and be tightened
securely by holding the
strap in place with one
hand and pulling the
loose end away from
the buckle, but against
the cabinet.

Technical Note

Due to the jarring and shifting that can occur in a vehicle, the mounting
straps may stretch or loosen. We recommend that you check the straps
regularly to assure that your Bazooka is mounted securely in place.