Page 1
Machine operation
Additional information (including troubleshooting and service) can be found in the individual chapters of the
“Instructions For Use”.
Sort the laundry according to
care symbols:
Do not tumble dry
Suitable for tumble drying -
at low drying temperature
Suitable for tumble drying
Preparing the laundry
Opening the door
Loading the dryer
and closing the door
Switching on the machine
and selecting the programme
Selecting the options
(if available)
Starting the dryer
Programme end -
unloading the dryer
Sort by:
Material thickness:
separate the laundry according to weight (e.g. dry towels and thin underwear
separately).
Type of material:
Degree of drying:
Do not tumble dry
with metallic decorations, bulky items such as sleeping bags, etc.
Check that all fastenings are closed and that pockets are empty. Please ensure that
there are no cigarette lighters in the wash. Turn the laundry inside out.
Pull the door handle. If the child safety lock is activated, please deactivate it
(additional information can be found in the “Door Reversibility/Child Safety Lock”
chapter of the “Instructions For Use”).
Place the laundry loosely in the drum to achieve equal drying throughout. Then
close the door.
Select the drying programme required by turning the programme selector knob.
The
(for information, refer to programme table).
Select the option required by pressing the corresponding button.
The indicator lamp above the relevant button lights up to confirm your selection.
An alarm sounds if an incorrect selection is made (incompatible options).
Press the button again to cancel the option.
The drying programme is started by pressing the
The relevant indicator lamp lights up.
Changing programme selection:
drying, the dryer stops. The
programme, again press the
Interrupting programme:
programme selector knob to “Airing” and press the
at least 5 minutes before opening the door to allow the dryer to cool down.
For your safety the drying cycle stops automatically if you open the door.
To restart, after door opening, close the door and press the
indicator lamp is blinking, indicating that the cycle needs to be started
Start
Whenever there is greater load than the dryer can handle,
Cotton (linen); synthetic textiles (easy care).
Cupboard dry, iron dry etc.
: Woollens, silk, nylon stockings, delicate embroidery, fabrics
button.
Start
If the programme selected is changed during
indicator lamp flashes. To operate the new
Start
button.
Start
To interrupt the dryer during the drying cycle, set the
Start
Take the laundry out of the dryer. The drying process is
End:
complete and the anti-crease phase has been reached (active).
Anti Crease:
cycle, an automatic anti-crease cycle will operate for maximum 60
min. The drum rotates at regular intervals to prevent the laundry
from creasing.
If the laundry is not removed at the end of the drying
button. Wait
Start
button again.
Set the index of the programme selector knob to the top, all lights go off.
Cleaning the lint filter:
machine and open it. Brush the lint using a soft brush or your fingertips. Close the
Switching the dryer off
Please note:
thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer.
Only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover
lint filter and push firmly back into place.
Emptying the water container:
Replace the container when empty by pushing it completely back into place.
If required, activate the child safety lock (additional information can be found in the
“Door Reversibility/Child Safety Lock” chapter of the “Instructions For Use”).
Open the door, pull the lint filter up and out of the
Pull the container out by the handle and empty.
1
Page 2
Programmes / Drying levels
Cotton
Synthetics
Delicate
Overview of programmes Options
Cupboard extra dry
Cupboard dry *
Iron dry *
Cupboard dry *
Iron dry
Delicate
Type of tex tile
Multi-layered, thick laundry such
as: terry towels, dish cloths and
dry towels, bed linen,
underwear, terry towelling bath
robes.
Similar types of laundry which do
not require ironing such as: dry
towels, bed linen, underwear,
baby clothes, T-shirts, cotton
socks.
Laundry which requires ironing
such as: bed and table linen, dry
towels, T-shirts, polo shirts,
work clothes.
Laundry which does not require
ironing such as: shirts, blouses,
T-shirts, sportswear.
Laundry which requires ironing
such as: trousers, dresses, skirts,
shirts, blouses.
Low drying intensity for delicates
and items labelled with , such
as: trousers, dresses, shirts,
blouses.
Fabrics
Cotton or linen hot wash /
coloured laundry
Max. 7 kg
Synthetic, mixed fibre or
cotton easy care (ironing not
required) laundry
Max. 2.5 kg
Laundry made from synthetic
fibres such as polyamide,
nylon, polyacrylic, etc.
Max. 2.5 kg
Vol ume
of load
kg
3.0
7.0
3.0
7.0
3.0
7.0
1.0
2.5
1.0
2.5
2.5
Gentle Dryness
adjustment
Buzzer Anti-
crease
X X X X X
X X X X X
X X X X X
X X X X X
X X X X X
- X X X -
Start
Delay
Approximate
drying times
(in minutes)
Very
Wet
wet
load
load
95’
80’
160’
130’
80’
60’
130’
110’
60’
50’
110’
85’
25’
20’
45’
35’
20’
15’
35’
25’
100’ 85’
Laundry is aired and refreshed for 30
minutes without heating.
AiringTime/cycle
Completes drying or dries single
items (suitable for all fabrics).
* Test programme in accordance with EN 61121.
- - - X X X - -
- X - X X X
2
Page 3
...you want to
correctly care for
and clean your
dryer:
...you want to check
the dryer yourself
first:
(If your machine is not
functioning correctly,
please check the
following points before
phoning for the
customer service – also
refer to relevant chapter
in the instructions for
use)
How to proceed if ...
Clean the filter at the end of
every cycle.
Empty the water container at
the end of each drying cycle.
Clean the heat exchanger at
least every month.
(For further information see
chapter “Heat Exchanger” in
the Instructions for Use).
Drying takes too long / laundry
is not dry enough
The dryer will not operate
(after a power failure, always
press the Start button).
Lint filter or water container
indicator lamp on.
Water droplets underneath
the dryer.
Replacing the drum light bulb
(if supplied).
All programme sequence
indicators blinking.
• Open the door.
• Pull the filter upwards.
• Open the filter.
• Brush lint using a soft brush or your fingertips.
• Close the filter.
• Push the filter back into place.
• Pull the handle to remove the water container.
• Empty the water container.
• Replace the water container when empty by
pushing it
completely
• Remove fibres in and around the water
evacuation hole at least once per month.
• Has the correct drying programme been
selected?
• Was the inserted laundry too wet (washing
machine spin speed less than 1000 rpm)?
• Is the lint filter dirty (filter indicator light on)?
• Is the heat exchanger dirty? (for more
information, refer to the instructions for use)
• Is the room temperature too high?
• Are the END and Anti-crease
indicator lamps lighting up? The drying cycle is
complete and the laundry can be taken out.
• Is the plug properly inserted into the mains
electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
•Has the
• Has the start-delay option been selected?
• Is the lint filter clean?
• Is the water container empty?
• Has the water container been inserted
• Is the heat exchanger clean?
• Has the heat exchanger been inserted
• Has any fluff on the heat exchanger seal been
• Has any fluff on the door seal been wiped
• Has the water container been inserted
• If the inside lamp does not work, the bulb may
•Unplug the dryer.
• Open the door and unscrew the glass cover
• Replace the faulty bulb with a new one and
• Replacement bulb: Philips 15W, 230/240V, E14.
• Service call necessary.
Start
correctly?
correctly?
wiped away?
away?
correctly?
be faulty.
inside the drum.
screw the glass cover back on.
back in place.
button been pressed?
AFTER-SALES SE R V I C E
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off.
Please contact your After-Sales Service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
• The nature of the fault.
• The dryer type and model.
• The service code (the number after the word Service on the adhesive rating
plate) on the right-hand side when the door is open.
3
Page 4
Before using the machine, please also read the “Instructions For Use” carefully!
TRKK 7870
Programme selector knob
Turn the programme selector knob to the desired
programme. The indicator next to the programme
name lights up. The start indicator blinks to show,
that the dryer is in selection mode. After the
button is pressed the start indicator lamp lights up
and the programme starts.
Start button
The drying programme is started by pressing this
button. The indicator lamp flashes during the
selection phase and lights up during drying.
Indicator lamps
Filter
The indicator lamp lights up when the filter and/or
heat exchanger need cleaning.
Clean the filter at the end of every cycle.
Quick Reference Guide
Programme sequence
The programme sequence is indicated by lamps, switching on when
programme step starts and switching off when the programme step is
passed.
Start
Drying Airing
Options
Gentle
Reduces drying intensity (recommended for delicate
items).
Buzzer
Signals/sounds end of drying cycle.
{
End
of
cycle
GB
Anti-
crease
Water container
The indicator lamp lights up when the water
container needs to be emptied. The drying cycle is
automatically interrupted. Empty the container and
press the
programme.
Empty the water container after every drying cycle.
Time remaining display
Depending on the programme selected, once the
drying cycle has been started, a default drying time is
displayed. The time displayed is corrected by a few
minutes depending on the volume, type and
dampness of the laundry.
The drying time specified is a calculated value
which will be updated during the drying
programme.
The flashing lines indicate that the calculation is
running. The remaining time will be updated.
Dryness adjustment
This is an option to adjust the dryness of the laundry
according to your wishes. Select the desired
programme and the option dryness level adjustment
by pressing the button “+” for more dry or the
button “-” for more humid. The selected dryness
will be stored as a pre-setting to the selected drying
programme. Using the drying programme next time
the pre-setting appears. By pressing the dryness
adjustment buttons “+” or “-” the pre-setting can
be changed.
button to restart the drying
Start
Anti-crease
Prevents laundry from creasing up to 12 hours.
Buzzer and Anti-crease cannot be selected
together.
Delayed Start
Delays the start of the drying cycle by 1 to 12 hours.
Each time the button is pressed, the start time is
delayed by 1 hour .
Then press the
selection and to start the dryer .
The delayed start indicator lamp flashes and the
countdown counts down in 1-hour intervals. The
countdown is indicated by the indicator lamp above
the button flashing. During the countdown, the
drum will turn from time to time to re-distribute
the laundry. To cancel or change the previously set
time delay, set the index of the programme selector
knob to the top, or open the door.
button to confirm the final
Start
5019 407 00622
(Subject to technical modifications)
4
Loading...