BAUKNECHT TK Plus 7B DI User Manual

1
CONTENTS
QUICK REFERENCE GUIDE
PROGRAMME CHART
PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING
INSTRUCTIONS FOR USE
PLEASE READ INSTRUCTIONS
FOR USE BOOKLET!
BOOKLET
BEFORE USING THE DRYER PRECAUTIONS AND GENERAL
RECOMMENDATIONS ELECTRICAL CONNECTION DESCRIPTION OF THE DRYER REMINDER - MAINTENANCE AND CLEANING CLEANING THE LINT FILTER CLEANING THE HEAT EXCHANGER DRAINAGE SYSTEM DOOR REVERSIBILITY TROUBLESHOOTING GUIDE/
AFTER-SALES SERVICE
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
3
5 7 8 8 8 9 10 11
12
2
BEFORE USING THE DRYER
This dryer is exclusively designed to dry machine
dryable laundry in quantities which are usual for private households. Observe the instructions given in these Instructions For
Use and the Programme Chart before using the dryer. Keep the Instructions For Use and the Programme
Chart handy for reference. If you pass on the dryer to others, make sure that the Instructions For Use and the Programme Chart go with it. The manufacturer declines all liability for damage to
property or injury to persons or animals due to non­compliance with the directions given in these Instructions For Use.
1. Removing the packaging and inspection
After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use it. Contact the After-Sales Service or your local retailer. If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few hours before operating. Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales Service technicians.
2. Electrical Connections
Electrical connections must be carried out by a
qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. Electrical connections must comply with local
Electricity Board regulations. Data regarding voltage, power consumption and the
required fuse protection is shown on the rating plate mounted at the rear of the dryer. The dryer must be earthed as prescribed by law.
Before carrying out any maintenance on the dryer
disconnect it from the mains supply. Mains cable replacement must only be carried out by
the After-Sales Service. After installation, access to the mains plug or to an all-
pole disconnection switch must be ensured at all times. Light bulb replacement must only be carried out by
the After-Sales Service.
3. Installation
Do not install your dryer where it may be exposed to
extreme conditions, such as: poor ventilation, temperature below 5°C or above 35°C. The appliance must not be installed behind a lockable
door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer, in such a way as to prevent the tumble dryer door from being fully opened.
Small indoor located storage rooms, bathrooms, toilets, shower rooms and enclosed areas without ventilation are not suitable locations for installation of the dryer. If it must be installed in such a location, adequate ventilation must be ensured (open doors, ventilation grid or slot larger than 500 cm²). Before running the first cycle, ensure that the water container is fully pushed inside and that the heat exchanger is correctly positioned.
Before running the first cycle, ensure that all of the drainage system hoses are connected (as shown in the picture below).
If possible use a hose to drain the water directly into the domestic plumbing system. This will avoid having to empty the water container at the end of each drying cycle, since the condensation water can be directly drained away. Also see section entitled “Drainage System”. Take care not to install the dryer on a deep-pile carpet. Take care not to trap the mains cable between the dryer and the wall. When installing the dryer make sure that the four feet are stable and resting on the floor, adjusting them as required, and check that the machine is perfectly level using a spirit level. If, due to lack of space, the dryer must be installed directly next to a gas or coal stove, a heat insulating plate (85 x 57cm) must be installed in between and the side of the plate facing the stove must be covered with aluminium foil.
3
The dryer is not designed for built-in installation.
The dryer can be installed under a worktop,
provided that adequate ventilation of the dryer is assured. Install a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop under which the dryer is installed.
4. Assembly of distance holders
To ensure that the appliance is positioned at a correct distance from the wall at the rear side and to allow sufficient ventilation, distance holders must be mounted on the rear side of the dryer before starting the first drying cycle.
Remove the two distance holders from the packaging.
A.
The distance holders must be inserted on the rear
B.
side of the dryer in the protective cover.
Secure both distance holders by turning them in a
D.
clockwise direction as far as the stop position.
D
5. User and child protection
Children must not be allowed to play with the dryer.
Ensure that children and small animals cannot get into
the drum. Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
B
Insert the distance holders in the holes provided on
C.
both sides.
C
Stacking kit
Depending on the
model, your dryer can be stacked on top of your front loading washing machine. For further information please contact the After-Sales Service.
4
Loading...
+ 9 hidden pages