Page 1
GSI 6320
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme selector knob
On / Off button
GB
Start button
Switches “on” when the dishwasher
is operating. Flashes when a fault
occurs. Switches off at the end of
the programme.
Programme chart
Programmes Loading instructions A B Litres kWh Minutes
Rapid 30 min 40°C
Standard
Intensive 70°C
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@email.whirlpool.com”.
1)
Lightly soiled crockery, with no
dried-on food.
Normally soiled crockery. X X 19.0 1.24 133
50°C
Heavily soiled crockery, especially
pots and pans.
3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Detergent
X - 16.0 0.70 30
X X 20.0 1.90 125
(We reserve the right to make technical modifications)
2)
Consumption
5019 496 90272
3)
Page 2
How to use the appliance
C
BA
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Press the ON/ OFF button.
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.
A:
B:
Select additional
options
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
Only after the START button has switched off: Press the
OFF
ON /
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
button. All the indicator lamps switch off.
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
Page 3
Dishwasher loading instructions and racks provided
Upper rack:
Multi-purpose supp ort (A)
Depending on the posi tion, f or
long-handles utensil s, c ups a nd
glasses. May be used in three
different positions.
Crockery holders (B):
Depending on the position,
for example plates, cups and
long-stemmed glasses.
Revolving glass support (C)
Depending on the position, for
example small or longstemmed glasses.
1)
Half Load:
Load the upper rack
Place the cutlery basket (D) in
the upper rack.
only
.
Rack height adjustment
(also when loaded):
•
Lower adjustment:
out the
rack handles
two
outwards (E) and lower the
rack.
•
Upper adjustment:
handles (E) upwards until
two
the rack clicks into place
(Factory setting).
The rack must be level on
both sides.
pull
pull the
depending on the model
:
2)
:
Lower rack:
Depending on the model with
fixed or tilting plate holders (F).
Half Load:
Load the lower rack
Greater washing power,
particularly for plates and
saucepans.
only
.
Cutlery basket (G) or (H):
Some models are provided
with a grid (I) that can be
fitted onto the cutlery basket
to keep items separated.
Cutlery basket (D) for
appliances with half load only.
Sharp knives and forks that
might cause injur y m ust be
placed in the cutlery basket with
the handles positioned upw ards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in
a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed),
silver cutlery.
Spare parts which are sold separately:
1)
Multi-purpose support (A) - N. AMH 369.
2)
Revolving glass support (C) - N. WGH 1000.
BK/III/GB
Page 4
What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the
problem (* see also the corresponding chapter in the user instructions).
Problem Cause Remedy
The appliance is not
working
If crockery is not
perfectly dry
If crockery is not
perfectly clean
Sandy or grainy
residues
Colour of plastic
parts faded
• No water supply. • Open the tap.
• The appliance does not load
sufficient water.
• There is a power failure. • Insert the plug into the mains socket.
• Starting the selected programme. • The programme can be set to “0” to start.
• Insufficient rinse aid. • Increase dosage *.
• Residual water in cavities. • Load crockery at an angle.
• The water jet does not reach the
crockery.
• Insufficient detergent. • Follow recommended detergent do sa ge.
• Unsuitable programme. • Select a more intense wash cycle.
• Spray arms blocked. • The spray arms must be able to turn freely.
• Spray arm nozzles clogged. • Remove any impurities obstructing the water
• Incorrect detergent/detergent
too old.
• Clogged filters. • Check filters regularly/if necessary clean *.
• Filters incorrectly assembled. • Insert the filter correctly *.
• Tomato/carrot juice... • Depending on the material, if necessary use a
• Clean the water supply tap filter.
Ensure there are no kinks in the water hose.
• Press the Start button.
• Close the door.
• Check the domestic circuit fuse.
• Arrange crockery so that items do not touch
each other. Load crockery upside down.
flow *.
• Use a good quality detergent.
detergent with a greater whitening power.
Deposits on crockery
•removable • Streaks on the crockery/glasses. • Increase the rinse aid dosage *.
• Streaks on glasses. • Reduce the rinse aid dosage *.
• Layer of salt on crockery/glasses. • Close the salt container lid properly*.
• not removabl e • Insufficient water softening,
Opaque glasses/
glasses not sparkling
Rust on cutlery
Identifying
calcium deposits.
• Cannot be washed in the
dishwasher.
• Not made of stainless steel. • Use suitable cutlery.
• The START indicator lamp flashes. • Ensure that the filter assembly is not clogged
appliance faults
• Indicator F... (if provided). • Call the After-Sales Service.
If after carrying out the above checks the malfunction persists or appears again, turn the appliance off
and turn off the water supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
• The nature of the fault.
• The appliance type and model.
• The service code (the number indicated on the adhesive rating
plate) inside the door on the right-hand side.
• Change water hardness setting, if necessary
add salt *.
• Use suitable glasses.
and if necessary clean it *.
Start the programme again. Press the START
button for about 2 seconds, until the START
indicator lamp switches off. Select a new
programme and press the Start button again.
Loading...