Bauknecht GSI 4876 CTW-SW, GSI 4876 CTW-WS Quick Reference Guide

GSI 4876

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Programme progress indicator Pre-rinse /Pre-wash Washing

Drying Programme end

Programme Symbol

and Temperature

Quick Reference GuideGB

Further indications are given in the pages to follow and in the user instructions.

Options

Delayed start button

The wash cycle can be programmed to start after 1-24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time.

Time and failure display

Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme has started. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes.

“F1-F5”, “F7-F9”

” Turn on the water supply tap.

“F6 Half Load button

This function can be used with any programme. The indicator lamp switches on: the wash cycle is activated for the upper or lower rack

Programme selection and

recommended load type

Identification of faults for service technician.

Place the detergent in the:

small large

compartment compartment

only

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Consumption

Normal load / (Half load)

Water

(Litres)

Energy

(kWh)

Time

(Min.)

Pre-wash

Glasses 40° C

Rapid 40° C

Bio-Eco 50° C

Bio-Normal 50° C

Normal 65° C

Intensive 70° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage.

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference prog ramme for energ y label.

3) Programme recommended when using detergents of type A (non enzyme-bas ed detergents).

Crockery to be washed later.

Light soiling, especially glasses and cups.

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery with dried-on food.

Normally or heavily soiled crockery.

Heavily soiled pans and saucepans.

- - 5.0 (4.2) 0.02 (0.02) 9(9)

- X 12.0 (10.0) 0.82 (0.78) 60 (59)

- X 13.0 (13.0) 0.85 (0.75) 30 (30)

- X 12.0 (10.0) 1.25 (1.19) 73 (71)

X X 16.0 (13.5) 1.35 (1.20) 86 (80)

X X 16.0 (13.4) 1.55 (1.37) 86 (80)

X X 21.0 (18.0) 1.68 (1.57) 93 (90)

5019 100 90276

(We reserve the right to make technical modifications)

How to use the dishwasher

1. After loading the dishwasher, close the door properly and open the water supply tap.

2. The dishwasher switches on automatically as soon as the programme selector knob is turned.

programme indicator lamps will switch on.

3. Turn the selector knob to select the desired programme.

indicator lamp lights up.

select options (if supplied).

4. Press the Start button to start the selected programme.

indicator lamp will light up.

the programmed data cannot be altered by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises th e last programme selected. This information remains in the memory even during interruption of the power suppl y.

To change the selected programme, press the Start button for about 5 seconds,

indicator lamp switches off.

Select a new programme using the programme selector knob and press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and

the End indicator lamp (if fitted)

lights up

(for about 30 min.)

One of the

The corresponding

If required,

The Start

Once set,

until the Start

6. Turn the programme selector knob counter clockwise to the initial position to switch off the dishwasher (only after the Start indicator lamp has switched off).

the indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

Upper rack

Half Load:

If the upper rack remove the cutlery basket from the lower rack and place it in the upper one.

is to be loaded,

only

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be chan ged when loaded.

• To lower: pull out the handles and gently lower the rack.

two

side

Upper and lower rack

• To raise: pull up the until the rack clicks into place.

• The rack must be level on both

All

sides.

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

“Vario Organizer” multi-purpose support:

• To be used, for example, for longhandled utensils

with the blade facing downwards),

cups and glasses.

• May be used in three different positions (see also “Dishwasher loading instructions” on Page 4).

1. Upon the left-hand side of the rack.

2. Upside-down, towards the centre of the rack.

3. Upside-down, towards the left side.

Glass holder:

two

(arrange knives

side handles

Lower rack

Half Load:

Loading the lower rack greater washing power, especially for plates and saucepans.

only

gives

Plate holders:

• May be lowered to increase available space (A).

• May be removed to increase available space (B). To remove: pull the handle up.

Cutlery basket:

The cutlery basket can be removed to increase (C) available space.

Please read the user instructions carefully.

+ 2 hidden pages