Bauknecht GSI 4875 TW IN, GSI 4875 TW BR Quick Reference Guide

90051 gb.fm5 Page 1 Tuesday, September 25, 2001 5:46 PM

GSF 4872 / GSI 4875

Important:

• If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off ! Refer to the “Troubleshooting guide” in these user instructions to remedy any problems.

• Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.

• Switch off the dishwasher once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted.

Ein/Aus

Vorspülen Reinigen Trocknen Ende

Vorspülen Gläser 40 °C Rapid 50 °C Bio-Spar 50 °C * Bio-Normal 50 °C * 1) Normal 65 °C Intensiv 70°C

ON-OFF button Start button indicator lamp:

Switches “on” when the dishwasher is operating. Flashes when

Switches off at the end of the programme.

Programme progress indicator Pre-rinse Washing Drying Programme end

a fault occurs.

Programme

Crockery to be washed later. - - Lightly soiled glasses and cups. 55 °C Lightly soiled crockery with no dried-on food. 55 °C - + Normally soiled crockery, with dried-on food. 65 °C + + Normally or heavily soiled crockery with dried-on food. 65 °C - + Normally or heavily soiled crockery. 65 °C + + Heavily soiled pans and saucepans. 65 °C + +

Wasser Sprüharm Wasserstop

Klarspüler Salz

Water tap indicator

Turn on the tap.

Spray Arm Block indicator

Release the lower spray arm.

Water stop indicator

“Water stop” device not working. Switch off the dishwasher and shut off the water tap.

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt.

Load

Crockery and cutlery

PROGRAMME CHART

Fault indicator

F1... F9 - Identification of faults for service technician.

Zeitvorwahl

Delay timer

Starts the dishwasher at the set time. The maximum delay that can be programmed is 15 hours. Toward the end of the programme, the display will indicate the time remaining in minutes.

Final rinse

temperature:

Detergent dispenser:

+) with pre-rinse

-) without pre-rinse ** small

compart-

ment

large

compart-

ment

½ Beladung Öko Trocknen

“Half Load” function

Load the upper or

Eco-Dry

Dry cycle without using fans.

lower rack only.

Consumption ***

Normal load Half load

Water (Liter)

Energy

(kWh)

5.0 0.02 9 4.2 0.02 9

12.0 0.82 60 10.0 0.78 59

12.0 0.90 65 10.0 0.78 59

12.0 1.25 73 10.0 1.19 71

16.0 1.30 82 13.5 1.20 80

16.0 1.44 82 13.4 1.37 80

21.0 1.68 93 18.0 1.57 90

Time

(Min.)

Water (Liter)

Energy

(kWh)

Time

(Min.)

Recommended programme for use with

**)

Pre-rinse.

***)

Values for normal conditions. Values may vary in relat ion to us age, e.g .: differe nt loads , water temperatu res, wate r hardne ss and power su pply vo ltage.

Check the programme on the energy data plate.

“new generation”

enzyme-based detergent.

5019 100 90051

90051 gb.fm5 Page 2 Tuesday, September 25, 2001 5:46 PM

Quick reference guide

Daily check list:

1. Turn on the tap.

2. Arrange crockery so that items do not touch each other.

3. Make sure the water jet can reach all loaded items and that the spray arms turn freely.

4. Fill the detergent dispenser and check the salt and rinse aid levels.

5. Close the dishwasher door.

Tips:

Crockery:

• Load crockery upside down on the racks.

Cutlery:

• The cutlery basket can be removed to increase available space.

• Place the cutlery unsorted in the cutlery basket with the handles positioned downwards.

• To avoid the risk of injury on sharp knives and forks, cutlery can also be placed in the basket with the handles positioned upwards.

Cups:

• Load cups at an angle to facilitate water circulation.

Silver cutlery:

• Always hand wash silver cutlery immediately after use. Follow the detergent manufacturer's directions on the detergent pack.

Important:

• Only load the appliance with dishwasher-proof crockery and cooking utensils.

• Certain wooden and aluminium articles may discolour.

• Glued, plastic utensils may be heat sensitive.

• Tin may become dull.

• Decorated crockery (unglazed) may fade.

• Glasses may become dull.

Also refer to the "Dishwasher loading instructions" which contain detailed information and useful tips.

Crockery holder:

• Down: cups and

• Up: plates.

Upper rack

Cutlery holder for long utensils:

•Up: glass holder (gently lift up and release).

•Down: large cutlery (gently lift up)

• Place knives with blades facing downwards.

Cutlery basket:

Upper rack half load.

Half load:

• Upper rack: the cutlery basketsmay

• Remove the cutlery baskets from the

Plate holders:

• The plate holders may be removed to

• To remove, pull the handle up.

• To reposition, simply insert in the

the upper rack only.

be inserted or removed as required.

lower rack.

Lower rack:

increase available space.

required position (normal or crosswise).

Glass holder:

• The glass holder can be moved sideways.

• Down: short glasses.

• Up: long-stemmed glasses.

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

Half load:

• Greater washing power for plates and

• The cutlery baskets may be inserted

Cutlery basket: the cutlery basket may be removed to increase available space

the lower rack only. saucepans. or removed as required.