Banner DX81P6 User Manual

1

2

3

4

5

SureCross DX81P6 FlexPower Supply

0 131628 5

Module

Datasheet

• Wireless solution for powering a FlexPower Node and sensor device

• Unique power management system to run the FlexPower Node and a device
through switched power outputs for up to 5 years, depending upon the power
requirements of the device

• Six 3.6 V dc lithium “D” cell batteries

• IP67 sealed enclosure

FlexPower systems allow for a true wireless solution as the Node can be powered by
battery power (3.6 to 5.5 V dc). Battery life is application specific. Contact Banner
Engineering’s application engineers for a battery life calculation for your specific
application.

For additional information, updated documentation, and accessories, refer to Banner
Engineering's website, www.bannerengineering.com/surecross.

Model

DX81P6 3.6 V dc battery Six 3.6 V Lithium "D" Cells 5-pin Euro pigtail QD

Power Batteries Cable

Specifications

Estimated Battery Life

114,000 mA·hours

Housing

Polycarbonate housing and rotary dial cover; polyester
labels; EDPM rubber cover gasket; nitrile rubber, non­sulphur cured button covers
Weight: 0.98 kg (2.15 lbs)
Mounting: 1/4-inch or M7 (SS M7 hardware included)
Max. Tightening Torque: 0.56 N·m (5 lbf·in)

Wiring Access

One 1/2-inch NPT with 5-pin Euro-style 150 mm
pigtail QD

Operating the devices at the maximum operating conditions
for extended periods can shorten the life of the device.

Environmental Rating

IEC IP67; NEMA 6; (See UL section below for any
applicable UL specifications)

Operating Conditions

Operating Temperature: −40 to 85 °C
Operating Humidity: 95% max. relative (non­condensing)
Radiated Immunity: 10 V/m, 80-2700 MHz
(EN61000-6-2)

Shock and Vibration

IEC 68-2-6 and IEC 68-2-7
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz

5-pin Euro-Style Female Wiring for DX81

Use the battery supply module to power FlexPower® devices only.

5-pin Euro-Style Female Connector

1

Do not apply more than 5.5 V dc to the gray wire.

P/N 131628 Rev. D 2 January 2014

Pin Wire Color Description DX80...C Terminals

3 Blue dc common (GND) V­5 Gray

1

3.6 V dc B+

195.9

[7.71’’]

148.1

[5.83’’]

87.6

[3.45’’]

55.9

[2.20’’]

138.2

[5.44’’]

20.1

[0.79’’]

SureCross DX81P6 FlexPower Supply Module

DX81P6 Dimensions

Warnings

Violating Warnings. The manufacturer does not take responsibility for the violation of any warning listed in this

document. Make no modifications to this product; any modifications to this product not expressly approved by Banner
Engineering could void the user’s authority to operate the product. All specifications published in this document are
subject to change; Banner reserves the right to modify product specifications or update documentation at any time. For
the most recent version of any documentation, refer to: www.bannerengineering.com. © 2006-2013 Banner Engineering
Corp. All rights reserved.

Banner Engineering Corp Limited Warranty

Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following
the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture
which, at the time it is returned to the factory, is found to have been defective during the warranty period. This warranty
does not cover damage or liability for misuse, abuse, or the improper application or installation of the Banner product.

THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR
IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE), AND WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR
TRADE USAGE.

This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO
EVENT SHALL BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR
ANY EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR
SPECIAL DAMAGES RESULTING FROM ANY PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE
PRODUCT, WHETHER ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY,
NEGLIGENCE, OR OTHERWISE.

Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any
obligations or liabilities relating to any product previously manufactured by Banner Engineering Corp.

www.bannerengineering.com - tel: [phone]