Important, Keep for
Future Reference
Assembly
Instructions
The Ultimate High Performance Double Jogging Stroller
Q-Series Single
assembly instructions Q- 2004 8/13/04 5:12 PM Page 1
2 1
• Important, keep this booklet for future reference.
• Accessories which are not approved by the manufacturer or distributor
should not be used.
• Warning: Prevent serious injury to your child by always using the
safety harness.
• Warning: Any load attached to the handle affects the stability of the stroller.
• Warning: It may be dangerous to leave child unattended.
• Always use your wrist strap – these strollers can really roll, and the
wrist strap gives you control if you should slip or fall down.
• The passenger should remain seated (no standing in the stroller).
• Watch out for cars – never assume that a driver can see you and your child
• Never use Roller Blades while using a Baby Jogger Stroller
• Intended for passengers up to five years of age weighing no more
than 75 pounds.
• This Jogger seats one passenger.
• Warning: Recommended weight for seat pocket is 2 pounds and basket
is 10 pounds. Excessive weight may cause a hazardous unstable
condition to exist.
• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer
For the sake of your precious cargo, please read
these warnings before using your Baby Jogger.
The Q-Series strollers are completely
assembled with the exception on putting
on the wheels... simply pull up on the
handle until you hear a click... attach
the wheels (shown on page 6) and
you’re ready to roll!
With the simple lift of a strap,
Baby Jogger’s new Q-Series strollers fold in
half, which makes transporting them easier
than ever before. Combine that technology
with our reputation for quality and durability
and you have the world’s best lineup of high
performance strollers.
Frame
Baby Jogger Introduces The
World’s Easiest Folding System!
Simple
Lift & Fold
assembly instructions Q- 2004 8/13/04 5:12 PM Page 2
2 3
1. Unsnap seat from frame.
2. Release the two bottom velcro straps.
3. Remove Quick-fold strap from folding
latch by unscrewing triangle shaped
fastener.
4. Unthread folding strap through seat
Seat
Footplate
• Insert the footplate tab into the footplate holder slot and snap down onto Jogger frame.
• Using a phillips head screwdriver, attach footplate to Jogger frame.
You will need to rest the Jogger Handle on the floor in order to get to the
bottom of the footplate.
Seat removal:
1 2
3
4
assembly instructions Q- 2004 8/13/04 5:12 PM Page 2
4 5
• Unsnap rear basket straps from
frame and remove basket.
• Undo basket’s front Velcro strap.
Basket
• Basket removal requires releasing the bottom section of seat as shown on previous page to
reveal velcro strap.
1. Remove canopy by releasing upper velcro straps and unsnapping from Jogger frame.
2. Using a phillips head screwdriver, unscrew brackets from Jogger frame to remove canopy.
Canopy
Canopy removal:Basket removal:
assembly instructions Q- 2004 8/13/04 5:12 PM Page 4
6 7
• To install, gently slide the
wheel’s rear axle into the hole in
the axle end until you hear it
click into place.
• To remove, simply push in
the spring lock while pulling
out the wheel.
Rear Wheels
1. To install front wheel, lay
stroller back so handle is
resting on floor. Open the
caliper by flipping the
caliper lever toward the
rear wheels while pinching
calipers together..
2. Insert the front wheel into
the fork tips by aligning
the axle flats with the fork
tip flats.
3. Tighten by turning the
wheel lever and holding
the opposite side.
Close the wheel lever
making sure that it is
facing toward the back of
the stroller.
4. Close caliper by flipping
the caliper lever toward
the fork tips.
Front Wheel
Caliper
Lever
assembly instructions Q- 2004 8/13/04 5:12 PM Page 6
8 9
Warning: Avoid serious injury from falling or sliding out.
Always use seat belt!
Adjusting safety harness:
• Loosen the shoulder straps from their plastic guides.
• Slide the end of each strap through pair of seat loops closest to your child’s shoulder.
Safety Harness
• Slide the end of the shoulder strap back into plastic guide.
Please note: If you feel the straps are too tight, you may adjust their length by sliding the
plastic guides toward the top of the seat.
• Lock both sides of the strap mechanism into the center buckle. To adjust the center strap,
move its plastic guide up or down.
assembly instructions Q- 2004 8/13/04 5:12 PM Page 8
10 11
Adjusting the Brake
• If you don’t have good braking action, simply
squeeze the brake handle five or six times. If the
problem persists, loosen the brake’s cylinder ring
to adjust the small ring, and then move the small
ring away from the handle to tighten the cable.
(Please do not over tighten!) To lock the rings,
tighten the cylinder ring against the handle while
holding the small ring in place.
Hand Brake with Parking Button
• To use the parking button feature, simply squeeze the brake handle and push the park brake button.
Rear Wheel Parking Brakes
• Simply push brake pedal down to engage
brake and lift up to release.
Brakes
Brake
Pedal
Small
Ring
Cylinder
Ring
• Simply adjust seat straps to
desired degree of recline.
• Pull on strap when you
want to return the seat to
its upright position.
Reclining Seat
assembly instructions Q- 2004 8/13/04 5:12 PM Page 10
12 13
Washing
• You can machine wash your stroller’s seat in cold water with a mild detergent.
To minimize shrinkage, simply reattach the seat to the frame to dry.
(Please do not put the seat in the dryer!)
• You may clean the stroller frame using a soft, dry cloth, and an occasional spray of
household wax will maintain its healthy glow.
Wheel Care
• Moisture – especially from the beach – can rust the wheel bearing case.
Spraying regularly with a silicone lubricant will keep your wheels looking healthy.
• Also, if you jog massive amounts of miles, your stroller will benefit from a yearly visit to the
bike shop for wheel alignment. Refer to the number on the tire wall for the optimum
pressure for your tires.
Storing
• Sunshine can fade seat fabric and dry out tires, so storing your
stroller indoors will prolong its good looks. However, if you do
store it outside, using a tarp will protect against weather wear.
Stroller Care
Steering
• Steering your stroller is simple: it’s balanced to
turn with just a light touch on the handlebar.
For tighter turns, push down on the handlebar and
raise the front wheel to steer.
Wrist Strap
• Make sure wrist strap is around your wrist whenever
your baby is in the stroller. The Baby Jogger is lightweight
and ready to roll – with or without you – and the wrist strap
helps you gain control over your stroller.
In the Dark
• Since we are concerned about the safety of you and your
baby, we recommend that you not use your stroller at
night. However, if you choose to, please attach
reflective strips to the wheel spokes and the seat.
Bicycle lights can also be mounted on the handlebar.
In Motion
assembly instructions Q- 2004 8/13/04 5:12 PM Page 12
We wish you many happy journeys with your new
Baby Jogger! Your stroller is a great product, and
we are proud to manufacture it. If you have any
questions or comments, please give us a call at.
BJC Q/S 08.10.04
1.800.241.1848
Baby Jogger is a Division of Dynamic Brands
2042 Westmoreland Street • Richmond, VA 23230
T: 800.241.1848 • F: 804.515.1092
www.babyjogger.com
Thank You!
assembly instructions Q- 2004 8/13/04 5:12 PM Page 14
Loading...