Avital MAXX2 User Manual

[

OWNER’S GUIDE

]

[

AUTO SECURITY SYSTEM

]

MODEL

MAXX2

®2002 Directed Electronics

Table of Contents

Consumer Warranty . . . . . . . . . . . . . . 3

What Is Included. . . . . . . . . . . . . . 5

Important Information. . . . . . . . . . 5

Your Warranty. . . . . . . . . . . . . . . 6

Remote Controls . . . . . . . . . . . . . 6

System Maintenance . . . . . . . . . . 7

Remote Control Battery Replacement . 7

System Features . . . . . . . . . . . . . . 8

Stealth Coding Technology . . . . . . 8

Electronic Scan Prevention (ESP) . . 8

Interior Light Illumination . . . . . . 8

Valet Switch. . . . . . . . . . . . . . . . 9

Keyless Entry in Valet Mode. . . . . . 9

Ultrasonic Sensors. . . . . . . . . . . . 9

Instant Remote Control Code Deletion 9

One-Step Remote Control

Code Learning . . . . . . . . . . . . . . 10

Alarm State Memory . . . . . . . . . . 10

Transmitter Functions . . . . . . . . . . 11

Accessory Outputs and

Button Assignments. . . . . . . . . . . 11

System Operation . . . . . . . . . . . . . 12

Active Arming . . . . . . . . . . . . . . 12

Passive Arming . . . . . . . . . . . . . . 12

Disarming the System

(if alarm is not sounding). . . . . . . 12

Disarming the System

(if alarm is sounding) . . . . . . . . . 13

Silent Arm/Disarm. . . . . . . . . . . . 13

Remote Panic . . . . . . . . . . . . . . . 13

Two-Stage Unlock Capability . . . . . 14

Sensor Bypass . . . . . . . . . . . . . . 14

Protected Valet Mode. . . . . . . . . . 15

How to Change Your PIN Code . . . . . 17

Diagnostics . . . . . . . . . . . . . . . . . 19

LED System Status Indicator . . . . . 19

Previous Intrusion Alert . . . . . . . . 19

Specific Zone Intrusion Identification. 19

Automatic Malfunction Override . . . 20

Interpreting Chirps and Flashes . . . 20

User-Programmable Features. . . . . . 21

Passive Arming . . . . . . . . . . . . . . 21

Passive Arming With Door Lock . . . 21

Auto-Rearm and Lock. . . . . . . . . . 22

Ignition-Controlled Door Lock/Unlock. 22

Long-Term Silent Arm/Disarm . . . . 23

Door Ajar Indication . . . . . . . . . . 23

Dual-Sensor Trigger Mode . . . . . . . 23

How to Set the User-Programmable

Features . . . . . . . . . . . . . . . . . . . 24

Programming Table

for System Features . . . . . . . . . . . 26

Programming Table

for Remote Controls. . . . . . . . . . . 27

Security & Convenience Expansions . 28

Glossary of Terms . . . . . . . . . . . . . 29

Quick Reference Guide. . . . . . . . . . 31

Health Check . . . . . . . . . . . . . . . . 33

®2002 Directed Electronics

Consumer Warranty

For a period of five calendar years from the date of purchase of this vehicle security device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, the alarm control unit if proved to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED AND SERVICED BY AN AUTHORISED AVITAL INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS ORIGINALLY INSTALLED. All other system parts are covered under the same warranty agreement for a period of one year. If warranty service is necessary you must have a clear copy of your sales receipt containing all of the information required.

This warranty contains the entire agreement relating to warranty and supersedes all previous and contemporaneous representations or understandings, whether written or oral. IN ANY EVENT, DEI IS NOT LIABLE FOR THE THEFT OF THE VEHICLE AND/OR ITS CONTENTS.

This warranty is void if the product has been damaged by accident, unreasonable use, neglect, improper service or other causes not arising out of defects in materials or construction. This warranty is nontransferable and does not apply to any unit that has been modified or used in a manner contrary to its intended purpose and does not cover batteries. The unit in question must be returned to the manufacturer, postage prepaid. This warranty d

oes not

cover labour costs for the removal, diagnosis, troubleshooting or reinstallation of the unit. For service on an out-of-warranty product a flat rate fee by model is charged. Contact your authorised dealer to obtain the service charge for your unit.

These systems are a deterrent against possible theft. Directed Electronics, Inc. is not offering a guarantee or insuring against the theft of the vehicle or its contents and disclaims any liability for the theft of the vehicle and/or its contents. Directed Electronics does not authorise any person to create for it any other obligation or liability in connection with this security system.

TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLUSION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTED THEREWITH

®2002 Directed Electronics, Inc.

SHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, TOWING, REPAIR, REPLACEMENT, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE. This warranty gives you specific legal rights. Your statutory rights are not affected.

®2002 Directed Electronics, Inc.

What Is Included

■ One Avital Maxx

Control Unit

■ One Valet Switch

■ One Status LED

■ One 4-Button/10-Channel Remote Control

■ One 2-Button/3-Channel Remote Control

■ Two Ultrasonic Sensors

■ One Battery Back-up Siren

■ One Certificate of Installation

■ Two Avital Window Decals

Important Information

Congratulations on your purchase of the Thatcham Evaluated Avital Maxx2vehicle security/convenience system. To fully benefit from the capabilities of your system, we encourage you to read the Owner’s Guide thoroughly. If you have any problems or questions, consult the dealer you purchased the system from. To locate an authorised Avital dealer in your area, call our UK office using the number noted in the back of this guide.

®2002 Directed Electronics, Inc.

It is necessary to retain your proof of purchase, which reflects that

the product was installed by an authorised dealer. For full details

regarding your warranty coverage, please refer to the Consumer

Warranty section of this guide.

Included with your system: one AviGlo 4-button/10-channel

remote and one AviGlo 2-button/3-channel remote. Once exposed

to light, the AviGlo remote control buttons will glow, making them

visible in the dark.

The remote control is a miniature transmitter powered by a small

(+) 3 volt lithium battery. Obstructions, electrical or radio inter-

ference, weather conditions, window tint, or a discharged battery

can reduce range. Your transmitter is the key to your system and

can be used to arm and disarm your alarm, lock and unlock your

doors, open your boot, and control optional accessories such as a

remote engine starter*, window roll-up, and garage door opener.

Your system can accept up to four AviGlo remote controls.

Additional remote controls and remote control batteries can be

purchased from any authorised Avital dealer or by calling the UK

office (freephone number noted in the back of the guide).

* This accessory is not evaluated by Thatcham.

Remote Controls

Your Warranty

®2002 Directed Electronics, Inc.

The Maxx2system requires no maintenance except for remote con-

trol battery replacement when they reach the end of their useful

life. When the battery weakens, operating range will be reduced

and the LED will dim. To replace your remote control battery use

the following procedure.

To replace the battery in your AviGlo remote control, follow the

instructions below.

1. Carefully pry apart the two halves of the remote control with

a small flat-bladed screwdriver. The bottom right-hand corner

of the remote casing has a small indent to allow the screw-

driver access.

2. The lithium battery is the round silver disc, about the size of

a five pence piece. Remove the old battery from the metal

clip. You should note that the (+) side of the battery should

face up and the (-) side should face the circuit board. Slide

the new replacement battery into the metal clip.

3. Re-align the two halves of the enclosure and snap together.

Remote Control Battery Replacement

System Maintenance

®2002 Directed Electronics, Inc.

System Features

Stealth Coding technology offers the most advanced protection

available against code-grabbing devices which thieves may use to

record the digital code transmitted by your remote control. When

you leave the area, thieves can then play back the code to unlock

the doors and de-activate your system. Avital’s remote controls

with Stealth Coding randomly change the code every time you use

them, and your system will not respond if any code is re-transmit-

ted. This technology makes code-grabbing devices useless.

Your system includes Electronic Scan Prevention (ESP), which

blocks electronic scanner codes preventing unauthorised operation

of your system. A thief could use an electronic “scanner” to con-

tinuously scan through thousands of different transmitter codes in

an attempt to find one that will disarm your system. Your Maxx

system uses ESP technology to render this type of attack useless.

When the alarm system is remotely disarmed, the vehicle interior

light(s) will turn on for 30 seconds or until the ignition key is

turned on.

Interior Light Illumination

Electronic Scan Prevention (ESP)

Stealth Coding Technology

®2002 Directed Electronics, Inc.

The Valet switch is a small push-button switch that allows you to

control all of the system’s programmable features and enter your

override PIN code. (See User-Programmable Features section of this

guide.) This switch can only be controlled in conjunction with

your ignition key.

NOTE: Make sure the dealer has shown you where the Valet switch is located. You will need to disarm the system with the Valet switch in the event of a lost or stolen remote control.

While the system is in the Valet mode, you can still use your

remote control to lock and unlock the doors as well as activate any

optional accessories, such as boot release or remote engine starter.

Your Maxx2security system incorporates two Ultrasonic sensors,

which are most commonly mounted at the top of the A-pillars fac-

ing the rear of the vehicle. These sensors detect movement inside

the vehicle by sensing air disturbance. They should trigger the

alarm if a thief gained access to the interior of your vehicle.

In the event of a lost or stolen remote control, all remote controls

can be erased from the systems memory preventing unauthorised

system operation. (See the Programming Table for Remote Controls

section of this guide.)

Instant Remote Control Code Deletion

Ultrasonic Sensors

Keyless Entry in Valet Mode

Valet Switch

®2002 Directed Electronics

Your system allows you to add new remote controls in one step. (See

the Programming Table for Remote Controls section of this guide.)

If your vehicle battery is disconnected and later reconnected, the

system will automatically return to its last state before power was

removed, whether it was armed, disarmed, or in Valet Mode. For

example, if a mechanic were to disconnect the battery while the

alarm was disarmed or in Valet Mode, the alarm will not trigger

when the battery is reconnected. If power is removed and then

restored while the alarm is armed, the systems battery back up

siren will instantly sound and the indicator lights will flash.

Alarm State Memory

One-Step Remote Control Code Learning

®2002 Directed Electronics, Inc.

Transmitter Functions

These outputs allow you to add optional remote-controlled acces-

sories to your system such as a remote engine starter, boot

release, window roll-up, garage door opener, or fuel filler door

release. To activate your optional accessories press the correspon-

ding remote control buttons shown below. You can assign any

remote control function to any button sequence. (See

Programming Table for Remote Controls section of this guide.)

Button/Channel Assignment Feature

Button / Channel 1 Arm/Disarm/Panic/Two Stage Unlock Button / Channel 2 Pulsed Accessory Output (Disarmed Only) Button / Channel 3 * Silent Arm/Disarm Button / Channel 4 * Timer Controlled Output + Buttons / Channel 5* Pulsed/Latched Accessory Output + Buttons / Channel 6 Sensor Bypass + Buttons / Channel 7 * Unassigned** + Buttons / Channel 8 * Unassigned** + Buttons / Channel 9 * Unassigned** + Buttons / Channel 10 * Unassigned**

* Only available with 4-button remote. **Can be assigned to operate any of the first 6 channels on your Maxx

or to control other Avital systems and accessories on other vehicles.

Accessory Outputs and Button Assignments

+ 23 hidden pages