Avaya CM160 User Manual

CM160 | Universal Mobile Phone Vent Mount

CM030 Unive rsal PDA/MP3 Cradl e

Package Contents:

(1) CM030 Universal Mobile Phone Cradle (1) CM047-S Vent Mount Assembly

NOTES:

1. This vent mount kit is designed for permanent and semi-permanent use only. This assembly can be di cult to remove from your vent louvres. Be careful if removing the vent assembly.

Installation Instructions

Choose a suitable vent location for

Step 1.

installation. Attach the vent mounting clips to the back of the pedestal with the vent clips correctly positioned with the  at sides facing up.

Gently insert vent pedestal into vent

Step 2.

louvres until the mounting clips are attached to the  n/blade of the vent. Adjust the spacing between the mounting clips if necessary.

Warning: Arkon is not responsible if the vent louvres become damaged as a result of the installation or use of this mount.

Mounting clip

CM047-S Vent Mount Pe destal (fully assembled)

Adjust the support leg vertically until

Step 3.

it rests  rmly along the bottom of the vent or dash surface below the vent. It will need to support the weight of the cradle and device.

Support leg

If necessary, move the support leg to the alternate bracket holes.

If necessary, you can rotate the lateral

Step 4.

head by holding the swivel mechanism and gently pulling and rotating the head to the desired angle .

Warning: Do not attempt to pull out the lateral head to rotate without  rst holding the pedestal for support. Pulling on the head and assembly can damage your louvres.

2. This vent mount kit is not compatible with circular air vents.

While holding the pedestal’s swivel

Step 5.

mechanism, align the T-tab on the pedestal face to the T-slot on the back of the cradle and slide down.

T-sl ot

Removal of Vent Mount Clips

Warning: The vent mount assembly can be di cult to remove from your vent louvres.

Remember to use the utmost care when

Step 1.

trying to remove the vent assembly so as not to damage your vehicle.

Remove the cradle from the vent mount

Step 2.

assembly.

Rotate

Carefully slide the mounting clips inward

Step 3.

as close together as possible to help remove the pedestal from the clips at the center hole.

T-Tab

Cradle back

Safety Precautions

Do not reposition the pedestal while driving. Arkon Resources, Inc. does not promote the adjustment of hand-held devices except when the vehicle is safely parked or stopped.

Arkon is not responsible for any damages caused to your car, your device, or yourself due to the installation or use of the pedestal mount.

Spring-loaded swivel mechanism

Step 4.

Lateral head

Step 5.

Swivel

The Mobile Mounting Specialists™

Consumer Hotline: (USA) (800) 841-0884 (INT’L) (626) 254-9005 Mon-Fri. 9am-5pm, PST

Carefully pinch the clip and angle the clip o of the vent  n/blade.

If are unable to remove the vent mount clips, please call our technical service department at (626) 254-9005.

www.arkon.com

Arcadia, CA 91006 USA

Made in Taiwan