Avaya Bogen Universal Bi-Directional User Manual

Universal Bi-Directional Voice Coil Cabinet Speaker

Description

PEC Code: 5330-105 COM Code: 408184026 Model: LUBIDIVCS

Speaker Installation

The Universal Bi-Directional Voice Coil Cabinet Speaker connects to a voice paging system's Voice Coil output. This speaker

can be used as a wall, ceiling, or corridor speaker.

ATTENTION: This speaker is designed to be used in an office environment.

The Universal Cabinet Speaker should be mounted indoors on a flat surface, such as a wall or ceiling. Note: When required, the speaker may also be mounted on a pole by using metal banding tape, or other suitable material, to secure the bracket to the pole.

Use the bracket as a template and mark a screw location in the center of each keyhole slot. Note: Ensure that the mounting position allows for easy wire connection and volume adjustments.

Install screws in the locations marked. Use anchors if necessary to provide a solid mounting (screws and anchors are provided). Leave enough room so the bracket can be slipped over the screw heads.

Attenuator Control

(Volume)

Speaker Wire Connection

Speaker

Mounting

Bracket

Screw

(-)

(+)

(-)

(+)

Maintain proper speaker phasing. Each conductor in the speaker wire must be connected to the same terminal on each speaker, as shown below.When using shielded speaker wire, and wiring from speaker to speaker, wire the shield drains to provide a continuous shield to the next speaker.The shield wire should never be terminated on the speaker.

Note:

Use 22 AWG shielded, twisted pair on all wire runs. Com Code: 401882956. Pec Code: 2734-SPK.

Note: Connections shown are for interconnected speakers. A single speaker does not require outgoing wiring.

Page 1 of 1

Red screw is (+). Silver screw is (-).